Celly PC2WIRELESSEARP Manual

Celly Hovedtelefon PC2WIRELESSEARP

Læs nedenfor 📖 manual på dansk for Celly PC2WIRELESSEARP (23 sider) i kategorien Hovedtelefon. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/23
Please read this manual and
pay attention to the safety
warnings before using the
product.
Keep the manual to have the possibility
to consult it at a later time, or in case of
passing the product to a third party.
Esprinet S.p.A. can not in any way be
held responsible for injury or damage
caused to people or things resulting from
improper use of the product.
Safety rules
Avoid listening at volumes that are too
loud, especially for prolonged periods
while using the product.
If you use the product at an excessive
volume, it could permanently damage
your hearing. Listen at a moderate
volume.
Audio alerts, warnings, and environmental
noises may sound different when using
the product.
Be aware of how these signals differ in
terms of sound so that you can recognize
the signals in corresponding situations.
Do not use the product while driving a
motor vehicle, cycling, using machines,
or in other situations where noise
awareness in your surroundings could
affect you or others. At the same time,
also observe the laws and regulations of
the country in which you use the product.
To avoid malfunction or damage to the
product, avoid accidental falls, do not
crush, puncture or exert a high level of
pressure on the product.
Keep the product away from moisture,
water or other liquids.
Do not store or expose the product to any
heat source, direct sunlight, radiators,
stoves or other heat sources such as
your car dashboard in the summer.
Do not attempt to modify, repair or
disassemble the product.
Do not use the damaged product.
Never use aggressive detergents, alcohol
or other chemical solutions for cleaning
as
they could damage the housing or even
impair the functionality of the product.
Do not immerse the product in water or
other liquids.
There are no serviceable parts inside the
product. Never open and take it apart.
Keep the product out of the reach of
children. Never allow children or people
with disabilities to use electrical products
unsupervised. Make sure that children do
not play with the plastic wrap, they could
swallow it and choke.
Make sure that children do not remove
small parts from the product and play
with them.
Reload
When using for the first time, charge
the battery to maximum capacity. To
recharge, plug the charging cable into
the product's charging port. A red light
positioned outside the charging box will
begin to flash, indicating the progressive
charging of the product. When all the
lights stop flashing, the charging will be
completed.
Please, remove the sticker form both
the eraphones before the use.
Pairing
The earphones, once extracted from
the case, will turn on automatically
and a light on each earphone will start
to flash red and blue. The earphones
must be connected to the device within
5 minutes, otherwise they will go into
power saving mode. To activate the
pairing mode again, simply place the
earphones in the charging case, close it
and wait a few seconds before reopening
it, following the above procedure again.
Now activate the wireless function on the
device, search for PULSESOUND, select
it once identified and connect it. You will
hear the "CONNECTED" sound when
pairing is completed. If prompted for a
pass word, enter "0000".
Automatic reconnection
Once the headset and device are paired,
they will automatically reconnect when
the wireless feature of your device is on
and within range.
MONO / STEREO operation
Only one headset can be used for
music playback or for making calls. This
   
earphones. To use this function, remove
only one earphone from the charging box.
If you want to switch to stereo mode, you
can also remove the second earphone
at any time. Conversely, if you want to
switch to mono mode, put a headset in
the charging box at any time
Multifunction buttons Automatic shutdown
1. If connected to a device, after
disconnecting the connection, the
headset will automatically turn off after
5 minutes.
2. If you don't connect the device when
the blue and red light flashes, the
headset will automatically shut down in
5 minutes.
Pairing between left and right
earphones
If the connection between the left
and right earphones is lost, put both
earphones back inside the charging
box, close it and wait a few seconds
before reopening it. The earphones will
automatically re-connect to each other.
If the process just described does not
work, disconnect the earphones from
your device, wait a few minutes, then
reconnect them (the earphones must
be placed inside the charging box). For
both procedures, it is necessary that
the earphones inside the charging box
are charging, so make sure that the
charging box has a sufficient charge level
to ensure the charging of the earphones.
Maintenance
1. Do not use abrasive solvents to clean
the product;
2. Do not attack the product with any
kind of sharp object as it may scratch or
damage the product;
3. Keep the product away from high
temperatures, dust and humidity.
Specifications
Wireless version: 5,3
Box charging time: 1.5 hours
Rated power: 3mW
Max power: 5mW
Earphones battery type: Li-polymer
Battery 3,7V/25mAh (0.0925Wh)
Box battery type: Li-polymer Battery
3,7V/200mAh (0.75Wh)

Speaker frequency response:
20Hz~20KHz
Maximum radiated power: < 20mW
Frequency range: 2,4GHz-2,4836 GHz
Wireless range: 10 meters




Single earphone weight: 3.4g
Charging box weight: 32.5g
User information for proper
disposal (Directive 2013/56 / EU)
The crossed-out bin symbol shown
on the equipment or on its packaging
indicates that the product at the end of its
useful life, including the non-removable
battery, must be collected separately
from other waste to allow for proper
treatment and recycling. The safe use of
this product is guaranteed in compliance
with the following instructions, therefore
it is necessary to keep them and follow
them scrupulously throughout the life
of the product. The product does not
require technical maintenance, NEVER
DISASSEMBLE IT. The battery inside is
integrated and not replaceable. Do not
attempt to remove the built-in Lithium Ion
/ Polymer battery yourself as it may cause
overheating, fire and injury. The battery
should only be removed by independent
qualified professionals who are able
to remove it safely and disposed of in
accordance with applicable laws. The
user must, therefore, give the equipment
at the end of its life free of charge to
the appropriate municipal centers for
the separate collection of electrical
and electronic waste, or return it to the
retailer, on a one-by-one basis, or free
of charge for appliances with smaller
external dimensions. to 25 cm. Adequate
separate collection for the subsequent
sending of the decommissioned
equipment for recycling, treatment and
environmentally compatible disposal
helps to avoid possible negative effects
on the environment and health and
favors the reuse and / or recycling of the
materials of which it is composed the
equipment. Illegal disposal of equipment,
batteries and accumulators by the user
involves the application of the penalties
provided for by the current legislation.
This product complies with
  
EU. The product carries the CE
mark and complies with safety standards
established by the European Union.
Esprinet SpA declares that the product
complies with Directive 2014/53/EU.
The full text of the EU declaration
of conformity is available at the
following Internet address: https://
xchange .esp rinet. com/co mp/celly/
PC2WIRELESSEARP.pdf
Celly® is a trademark owned by
Esprinet S.p.A.
All brands are registered trademarks of
their respective owners.
Esprinet S.p.A., via Energy


Made in China.
www.celly.com
for info and contacts, write to:
contact@esprinet.com
Instruction manual
HEADSET WIRELESS
Model: PC2WIRELESSARP

EN
 
Play/pause Single click Single click
Reply/end calls Double click Double click
Refuse calls Long press Long press
Previous track Double click //
Next track // Double click
Volume - Long press //
Volume + // Long press
Voice assistant Triple click Triple click

Produkt Specifikationer

Mærke: Celly
Kategori: Hovedtelefon
Model: PC2WIRELESSEARP

Har du brug for hjælp?

Hvis du har brug for hjælp til Celly PC2WIRELESSEARP stil et spørgsmål nedenfor, og andre brugere vil svare dig


Hovedtelefon Celly Manualer

Celly

Celly PC2WIRELESSEARP Manual

20 November 2024
Celly

Celly PC2J35MMEARPIN Manual

19 November 2024
Celly

Celly KHWHEADPHONE Manual

26 Juli 2024
Celly

Celly KHWEARPHONE Manual

26 Juli 2024
Celly

Celly Mini1 Manual

26 Juli 2024
Celly

Celly UP300 Manual

26 Juli 2024
Celly

Celly BHSNAILBK Manual

25 Juli 2024

Hovedtelefon Manualer

Nyeste Hovedtelefon Manualer

Miiego

Miiego MOOVE 55 SILENCE Manual

19 December 2024
Miiego

Miiego MiiBUDS AIR Manual

18 December 2024
Miiego

Miiego MiiRHYTHM II Manual

18 December 2024
Miiego

Miiego MOOVE45i PRO Manual

18 December 2024
Miiego

Miiego MiiBUDS PLAY II Manual

18 December 2024
Westone

Westone Pro X 30 Manual

16 December 2024
JLab

JLab Studio Pro ANC Manual

16 December 2024
Violectric

Violectric DHA V590² Pro Manual

14 December 2024
Violectric

Violectric DHA V590² Manual

14 December 2024
Edifier

Edifier TWS X3 Manual

10 December 2024