Crestron TSR-302-BTP Manual

Crestron Ikke kategoriseret TSR-302-BTP

Læs gratis den danske manual til Crestron TSR-302-BTP (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Crestron TSR-302-BTP, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

DO GUIDE

DO Check the Box

QTY PRODUCT PART NUM.

1 TSR-302-BTP Battery Pack for TSR-302 2039523

3. Lift the old TSR-302-BTP out of the battery compartment, as shown in the following

photograph.

DO Install the New Battery

After completing the removal of the old TSR-302-BTP from the touch screen remote, perform

the following procedure to install the TSR302-BTP in a TSR-302:

1. Place the TSR-302-BTP in the battery compartment, oriented as in the previous

photograph.

2. Reattach the battery compartment cover by pressing down lightly on the locking tab while

sliding the cover into place.

DO Charge the Battery

Install the TSR-302-BTP in the TSR-302 touch screen remote and mount it in an ac-powered

TSR-302-DS Table Dock.

TSR-302-BTP

Battery Pack for TSR-302

DO Remove the Battery

To remove the existing TSR-302-BTP from a TSR-302, perform the following procedure:

1. Remove the battery compartment cover on the rear of the TSR-302 by using two thumbs

and gently pressing in the direction of the arrow shown in the following photograph.

2. Place the touch screen remote on a clean, soft surface, with the screen side down.

DO GUIDE

DOC. 7664A (2040915) 08.14

Specications subject to change without notice.

DO Store the Battery

The TSR-302-BTP can be stored in a temperate, dry place (removed from the touch screen

remote and table dock) for up to six months without signicant irreversible degradation of its

performance. The self-discharge rate is a function of temperature and internal resistance.

High-temperature storage reduces charge retention. Best results occur when the TSR-302-BTP

is stored at a temperature of 32° to 95°F (0° to 35°C).

NOTE: The TSR-302-BTP should be 30% to 50% charged when put into storage.

DO Dispose of the Battery

NOTE: The TSR-302-BTP contains a lithium polymer battery. When the unit can no longer

retain a charge, it must be recycled or disposed of properly. Follow local ordinances and

regulations for disposal.

The battery must be recycled. Deliver the battery to an appropriate recycling

facility.

DO Learn More

www.crestron.com

Crestron Electronics 15 Volvo Drive, Rockleigh, NJ 07647

888.CRESTRON | www.crestron.com

As of the date of manufacture, the TSR-302-BTP has been tested and found to comply with specications

for CE marking.

The specic patents that cover Crestron products are listed at patents.crestron.com. Product warranty can be found at www.crestron.com/warranty.

Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other trademarks, registered trademarks,

and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names