US Blaster USB 7329 Manual

US Blaster DJ fest musik USB 7329

Læs nedenfor 📖 manual på dansk for US Blaster USB 7329 (23 sider) i kategorien DJ fest musik. Denne guide var nyttig for 3 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/23

DESCRIPTION OF THE FUNCTIONS

Top View:

1. L.C.D.

These liquid crystal displays (L.C.D.) indicate the track numbers, time (minutes, seconds, frames), pitch range, and relative playback information.

2. Seamless Loop

There is A, B/LOOP/ EXIT, RELOOP buttons.

i. . A BUTTON---“start point” (A point. Also, Cue 1 could be A point) After setting up the A point, the green Led light up

ii. . B / LOOP EXIT BUTTON: ---“ End point”(B point). Press the B /LOOP button to set up the B point and start the loop playback automatically. Loop

lights on the display and the 3 LEDs flash. Press this button again to exit the LOOP playback.

iii. . Return to the loop playback by pressing the RELOOP while in performance.

iv. . Change “ START POINT” and” END POINT” by pressing the A& B/ LOOP EXIT button again

v. The interval between A and B point must be more than 20 frames; otherwise, the B point will be canceled, then LOOP function disappears and LOOP fades

on the display

3. Instant Reverse

i. When Instant Reverse mode ON, the Brake sound cause by motor reverse will not be heard.

Under this mode, If the track reverses back from 00:50, and switch back to forward play as 00:45. The track will start to play from 00:55

Please note that there is a 10 seconds buffer for this mode, which means the track can reverse 10 seconds backwards from the point you selected.

ii. Hold the Instant Reverse button for 3 seconds and the LED flashing.

Under this mode, the track starts reverse and forward play instantly from the switch point

If the track reverses back from 00:50, and switch back to forward play as 00:45. The track will start to play from 00:45