Alecto DVM-275 Manual
Læs nedenfor 📖 manual på dansk for Alecto DVM-275 (3 sider) i kategorien Babyalarm. Denne guide var nyttig for 23 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/3
INSTALLATION
Power supply:
The baby unit (camera) is powered by the
included 5V power adaptor with the straight
(micro USB) plug.
Make sure that the baby can’t touch the wire of the baby unit
or the adaptor cord. Place the
baby unit at least 1-1.5 meters
away from the baby and bundle
excess cable lengths using tape or
this purpose.
The parent unit (monitor) is powered by the
permanently installed and non-exchangeable
battery. This battery is recharged by connect-
ing the supplied 5V power adaptor with the
perpendicular (micro USB) plug to the rear of
the parent unit.
Insert the power adaptors into a 230V wall outlet.
Only use the supplied power adaptors with the
The specications of both adaptors are identical. That’s
why it won’t cause any problems when accidentally
interchanging the adaptors.
SCREEN SYMBOLS
Signal strength:
strong reception
good reception
average reception
poor reception
no reception
Sound:
sound is enabled
Attention, this doesn’t indicate the set volume
X sound is disabled (volume set to 0)
Attention, when disabling the sound while the VOX
function is active (for this, see ‘menu operated
functions’), the speaker symbol will keep indicating that
the sound is enabled
Lullabies
Feeding timer:
in the lower right corner of the screen
Temperature alert:
the temperature alert is enabled
Temperature:
(‘22’ is an example)
Indicates the temperature in the room where the baby unit
is situated; take into account a possible tolerance of ± 1.5
degrees
23:07:25 (‘23:07:25’ is an example)
The time is displayed in the upper right corner of the screen.
Battery:
battery full
alert tones will sound for approximately 20 to 30 minutes.
Zoom function:
USE
BABY UNIT:
Switching on/o:
button at the front of the baby unit to
switch on the baby unit. The indicator directly underneath the
button again to
power adaptor.
then completely to the right and then fully down and up. Final-
The arrow buttons on the parent unit allow you to aim the
camera at the desired spot.
Automatic night vision:
dark and will switch of again when it becomes light.
The LEDs can illuminate objects up to a distance of
approximately 3-5 meters.
When it’s dark, that is when the night vision LEDs are
switched on, the images on the parent unit will be
displayed in black and white.
Attention: infra-red light cannot be perceived by the
human eye; that means you cannot tell whether the
infra-red LEDs are switched on with the naked eye.
PARENT UNIT:
Switching on/o:
Press and hold button for 3 seconds to switch the parent
Volume:
volume.
X symbol appears when the
sound is disabled.
Sound indicators:
whether the baby is crying. In this way you can also monitor
baby monitor is located a bit further away in the room.
To talk back:
Press the button to talk back to your baby. Keep the button
depressed for as long as you’re speaking and release the
button to listen.
While using the talk-back function, the icon appears
in the screen.
Display o (parent sleep mode):
If the display brightness of the parent unit on your bedside
by pressing the button. The sound remains enabled.
See the section ‘VOX’ to automatically switch o the
screen + sound when the baby is sleeping and to
switch them on again as soon as the baby starts crying
Pan/tilt:
Press and hold the or button to aim the camera to
The sound is disabled while orienting the camera of the
baby unit.
ZOOM: (enlarging)
button again to restore the normal view.
screen when this function is enabled.
MENU OPERATED FUNCTIONS
button.
Use the navigation button or to select the desired
option. Press the button to open the selected option.OK
Lullabies:
or to select the
‘Lullabies’ option and press the buttonOK
or button to select the desired lullaby or
OK
button
3. Press 2x the button to leave the menu and to return to
the normal screen or wait for 10 seconds until this happens
automatically
Playback of the lullabies is stopped automatically after
approximately 20 minutes. You may also open the
menu and select STOP to stop playing the songs earlier.
At the bottom of the menu you also have the option to
adjust the playback volume of the lullabies at the baby
unit.
Keep in mind that the sound of the lullaby is returned to
the parent unit via the microphone of the baby unit. In
this case, you may want to set the sound of the parent unit to
level 0 (= sound o).
As soon as and for as long the lullabies are being
played, the symbol appears at the top in the display.
View:
you may use this menu to select which view must be dis-
played in the screen.
or to select the
‘View’ option and press the buttonOK
or button to select which camera you’d like to
5 seconds one after the other and press the buttonOK
Attention: The unit does NOT automatically switch to a
camera where sounds are being detected.
Temperature:
This menu allows you to input a minimum and maximum value
or to select the
‘Temperature’ option and press the buttonOK
• ‘Low Temperature’ for the minimum temperature
•
set these options with the or button
•
•
• ‘OFF’ to disable the temperature alert
•
press the button to select this settingOK
3. Press 2x the button to leave the menu and to return to
the normal screen or wait for 10 seconds until this happens
automatically.
DVM-275
USER’S MANUAL
INTRODUCTION
•
•
have the baby monitor switch on.
•
foil from the parent and baby unit.
About this user’s manual:
always adhere to the instructions described in this
documentation.
This symbol is followed by a user’s tip.
this user’s manual.
DECLARATION OF CONFORMITY
Press and hold for 3 seconds to switch the parent unit on
again to switch the display back on.
press and repeatedly to increase or decrease the
volume
press and hold to move the camera up or down (tilt
function)
press and repeatedly to select the desired setting
press and hold to move the camera left or right (pan
function)
press and repeatedly to select the desired setting
BABY UNIT:
register the baby unit on the
parent unit. See the related
instructions further on in this
manual.
Parent unit table stand:
the stand at the rear of the device.
Baby unit wall mount:
” tripod nail
bracket to place the baby unit in a higher position or to mount
FUNCTION OVERVIEW
PARENT UNIT:
step.
press again to restore the normal view.
selected setting.
12 5
3
109
8
OK
OK
Produkt Specifikationer
| Mærke: | Alecto |
| Kategori: | Babyalarm |
| Model: | DVM-275 |
| Vekselstrømsindgangsspænding: | 110-240 V |
| Vekselstrømsindgangsfrekvens: | 50-60 Hz |
| Produktfarve: | Hvid |
| Skærmtype: | LCD |
| Pakkevægt: | 690 g |
| Skærm diagonal: | 5 " |
| Skærmopløsning: | 480 x 272 pixel |
| Berøringsskærm: | Ingen |
| Husmateriale: | Plast |
| Strømkilde type: | AC, Battery |
| AC-adapter inkluderet: | Ja |
| Maksimal indendørs rækkevidde: | 50 m |
| Maksimal udendørsinterval: | 300 m |
| Modtager bredde: | 163 mm |
| Modtager dybde: | 15 mm |
| Modtager højde: | 95 mm |
| Nattilstand: | Ja |
| Maks. rækkevidde: | - m |
| Temperaturføler: | Ja |
| Transmitter bredde: | 75 mm |
| Transmitter dybde: | 75 mm |
| Transmitter højde: | 130 mm |
| Sender: | Ja |
| Modtager: | Ja |
Har du brug for hjælp?
Hvis du har brug for hjælp til Alecto DVM-275 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Babyalarm Alecto Manualer
5 November 2024
5 November 2024
2 Oktober 2024
7 September 2024
14 August 2024
12 August 2024
11 August 2024
10 August 2024
8 August 2024
7 August 2024
Babyalarm Manualer
- Babyalarm SilverCrest
- Babyalarm Amplicomms
- Babyalarm Denver
- Babyalarm Sencor
- Babyalarm Beurer
- Babyalarm Philips
- Babyalarm Concept
- Babyalarm Medisana
- Babyalarm Gigaset
- Babyalarm Emos
- Babyalarm Technaxx
- Babyalarm Grundig
- Babyalarm D-Link
- Babyalarm Motorola
- Babyalarm Kodak
- Babyalarm Tefal
- Babyalarm Hama
- Babyalarm Hyundai
- Babyalarm Belkin
- Babyalarm TriStar
- Babyalarm TRENDnet
- Babyalarm Sanitas
- Babyalarm Fysic
- Babyalarm Topcom
- Babyalarm Uniden
- Babyalarm Medion
- Babyalarm EZVIZ
- Babyalarm König
- Babyalarm Ariete
- Babyalarm Elro
- Babyalarm Geemarc
- Babyalarm Babymoov
- Babyalarm Beaba
- Babyalarm Withings
- Babyalarm Terraillon
- Babyalarm Angelcare
- Babyalarm Fisher-Price
- Babyalarm Graco
- Babyalarm Neonate
- Babyalarm PADWICO
- Babyalarm Vtech
- Babyalarm Chicco
- Babyalarm Lindam
- Babyalarm Reer
- Babyalarm Alcatel
- Babyalarm Tommee Tippee
- Babyalarm Jane
- Babyalarm Olympia
- Babyalarm Ansmann
- Babyalarm HQ
- Babyalarm Niceboy
- Babyalarm Marmitek
- Babyalarm Basetech
- Babyalarm Tesla
- Babyalarm Foscam
- Babyalarm Lorex
- Babyalarm Cobra
- Babyalarm Xblitz
- Babyalarm Joblotron
- Babyalarm Binatone
- Babyalarm Eufy
- Babyalarm Overmax
- Babyalarm Albrecht
- Babyalarm Nova
- Babyalarm Trebs
- Babyalarm Bébétel
- Babyalarm Manhattan
- Babyalarm Switel
- Babyalarm Brondi
- Babyalarm GoClever
- Babyalarm Lupilu
- Babyalarm Duux
- Babyalarm Audioline
- Babyalarm BT
- Babyalarm CAPiDi
- Babyalarm Tigex
- Babyalarm Lionelo
- Babyalarm Pabobo
- Babyalarm Oricom
- Babyalarm Oregon Scientific
- Babyalarm SereneLife
- Babyalarm Stabo
- Babyalarm Duronic
- Babyalarm TrueLife
- Babyalarm Kogan
- Babyalarm Cresta
- Babyalarm Chipolino
- Babyalarm Summer
- Babyalarm BabyOno
- Babyalarm Safety 1st
- Babyalarm Esscom
- Babyalarm Luvion
- Babyalarm Hartig And Helling
- Babyalarm NUK
- Babyalarm Tomy
- Babyalarm Babysense
- Babyalarm Jablotron
- Babyalarm Modern-Electronics
- Babyalarm Hartig Helling
- Babyalarm Levana
- Babyalarm Summer Infant
- Babyalarm IBaby
- Babyalarm Fischer Price
- Babyalarm Mobi
- Babyalarm MicroTalk
- Babyalarm Oretti
- Babyalarm Neno
- Babyalarm LeamsiQ
- Babyalarm Philips-Avent
- Babyalarm Heimvision
- Babyalarm BabySafe
- Babyalarm Chillax Baby
- Babyalarm Hubble Connected
- Babyalarm Peekyboo
Nyeste Babyalarm Manualer
16 November 2024
12 November 2024
11 November 2024
31 Oktober 2024
30 Oktober 2024
30 Oktober 2024
28 Oktober 2024
28 Oktober 2024
22 Oktober 2024
20 Oktober 2024