Allen & Heath Sigma Manual


Læs nedenfor 📖 manual på dansk for Allen & Heath Sigma (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 24 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
SIGMA OPERATING SYSTEM HIGHLIGHTS
24 bus outputs.
Assignment to buses from inputs and from monitors.
8 auxiliary mixes for cue and echo (in-line M470 systems) 6 on
M410/20/30 systems.
Two stereo cue outputs with talkback for performer's foldback.
Stereo monitor/remix main output.
Mono sum of stereo output.
Four variable equaliser sections plus high pass filter provided on
inputs and monitors.
Low residual noise preamps, equalisers, line and mix amplifiers.
Low distortion design at all points in the system.
PFL facility on all inputs, groups and monitors. Interrupts LS and
meter only.
AFL facility on all inputs, groups and monitors derived post-pan-
pot. Interrupts LS and meter only.
SOLO MUTE facility on all inputs and monitors. Auto shut-off of all
sources not selected SOLO.
SOLO MUTE has two sub systems — input and monitor. Both can
be enabled and inhibited independently.
AUTO MUTE facility on all inputs and monitors, sequence and
synchronise audio mutes to MIDI.
Three fader options, retrofit capable. 100mm low cost or VCA
grouping or fader automation.
Capacity for 56 modules, potentially 112 inputs to the mix.
2 mainframe lengths 36 and 48 module capacity total.
Complementary module expander frames and patchbay/
producer's desk frames.
High standard of appearance when installed, cabling concealed
within the frame.
Electronic balanced circuits on all main inputs and outputs
including microphones, line and tape inputs, group outputs, main
outputs, etc.
Attention to details of audio performance at all stages. The
electronic signal path is of the high input impedance, low output
impedance type. Coupling capacitor isolate all input connections
and outputs from DC offsets. All switches pot and faders are
capacitor coupled to prevent clocks and noise.
Amplifier bandwidths are tailored to accept the maximum
bandwidth possible while rejecting extreme LF (sub 5Hz) and HF
(over 60KHz) signals. While the external operating level is + 4dBv
(1.23v RMS) the internal level is reduced to 0dBv. This yields 22dB
internal headroom 0VU sine wave input or output and maximum
output level.
The electronically balanced outputs are actively driven by
separate amplifiers for each phase (pin 2 hot) and feedback design
removes drive to either phase if grounded. At the same time the
other phase output amplitude is doubled.
Electronic balanced inputs are differential type on line inputs and
symmetrical long tail pair design on microphone input having
excellent CMRR. The preamps are designed so that the headroom
at the critical input stage is also 22dB. Low noise preamp design
achieves noise performance at line inputs superior to the output
noise of signal sources including dBx tape and 16 bit linear digital
playback.
The use of summing amplifiers for every output, main, or sub
system, ensures consistent performance with any module loading
format. Low noise amplifiers keep noise floors negligible. The
same high quality standards apply to all outputs. All inputs and
outputs except group insertion points are phase coherent.


Produkt Specifikationer

Mærke: Allen & Heath
Kategori: Ikke kategoriseret
Model: Sigma

Har du brug for hjælp?

Hvis du har brug for hjælp til Allen & Heath Sigma stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Allen & Heath Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Elektron

Elektron Overbridge Manual

26 November 2024
Elektron

Elektron Sidstation Manual

26 November 2024
SoundTube

SoundTube IPD-RS82-EZ Manual

26 November 2024
Kramer

Kramer 4x1VB Manual

26 November 2024
Kramer

Kramer RC-63A Manual

26 November 2024
SoundTube

SoundTube IPD-HP82-EZ Manual

26 November 2024
Kramer

Kramer RK-KVM-1U-PP3 Manual

26 November 2024
Gioteck

Gioteck VX-2 (PS3) Manual

26 November 2024