Amtrol Extrol SX-90V Manual

Amtrol Kedler & kedler Extrol SX-90V

Læs nedenfor 📖 manual på dansk for Amtrol Extrol SX-90V (2 sider) i kategorien Kedler & kedler. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

USE ONLY IN RESIDENTIAL CLOSED

HYDRONIC SYSTEMS. Do not install on domestic

water systems, or in open heating systems. Corrosion and tank failure

may result. Use a Therm-X-Trol® or Therm-X-Span® for domestic water

systems. Use a Radiant EXTROL

® for radiant heating systems where air

elimination equipment or barrier tubing is not used.

READ CAREFULLY THE PRODUCT

INSTALLATION, OPERATING AND

MAINTENANCE MANUAL. FAILURE TO FOLLOW THE

INSTRUCTIONS AND WARNINGS IN THE MANUAL MAY RESULT IN

SERIOUS OR FATAL INJURY AND/OR PROPERTY DAMAGE, AND

WILL VOID THE PRODUCT WARRANTY. THIS PRODUCT MUST BE

INSTALLED BY A LICENSED PROFESSIONAL. FOLLOW ALL

APPLICABLE LOCAL AND STATE CODES AND REGULATIONS, IN

THE ABSENCE OF SUCH CODES, FOLLOW THE CURRENT

EDITIONS OF THE NATIONAL PLUMBING CODE AND NATIONAL

ELECTRIC CODE, AS APPLICABLE.

This Product, like most Products under pressure,

may over time corrode, weaken and burst or

explode, causing serious or fatal injury, leaking or flooding and/or

property damage. To minimize risk, a licensed professional must install

and periodically inspect and service the Product. A drip pan connected to

an adequate drain must be installed if leaking or flooding could cause

property damage. Do not locate in an area where leaking could cause

property damage to the area adjacent to the appliance or to lower floors

of the structure.

RUPTURE OR EXPLOSION HAZARD. Do not

expose product to freezing temperatures or

temperatures in excess of 240°F. Do not adjust the pre-charge or

re-charge this Product except during installation or regular inspection.

Replace the Product and do not adjust the pre-charge if corroded,

damaged or with diminished integrity. Adjustments to pre-charge must

be done at ambient temperature only. Failure to properly size the Product

or follow these instructions may result in excessive strain on the system

and may lead to Product failure, serious or fatal personal injury, leakage,

and/or property damage.

A relief valve must be installed to prevent pressure

in excess of local code requirement or maximum

working pressure designated in the Product Manual, whichever is less.

At least once every 3 years or if discharge is present, a licensed

professional should inspect the pressure relief valve and replace if

corrosion is evident or the valve does not function. FAILURE TO

INSPECT THIS VALVE AS DIRECTED COULD RESULT IN UNSAFE

PRESSURE BUILD-UP WHICH CAN RESULT IN PRODUCT FAILURE,

SERIOUS INJURY OR DEATH AND/OR SEVERE PROPERTY

DAMAGE AND VOID THE PRODUCT WARRANTY.

Chlorine & Aggressive Water: The water quality

can significantly influence the life of this Product.

You should test for corrosive elements, acidity, total solids and other

relevant contaminants, including chlorine and treat your water

appropriately to insure satisfactory performance and prevent

premature failure.

This product can expose you to chemicals including

lead, which is known to the State of California to

cause cancer and birth defects or other reproductive harm. For more

information go to www.P65Warnings.ca.gov.

EXTROL®

EXPANSION TANKS FOR HYDRONIC HEATING & CHILLED WATER SYSTEMS

INSTALLATION & OPERATION INSTRUCTIONS

NOTE: Inspect for shipping damage. Notify freight carrier or store where purchased immediately if damage is present. To avoid risk of personal injury

and property damage, if the product appears to be malfunctioning or shows signs of corrosion, call a qualified professional immediately. Current copies