AXESS AX-ADGM04 Manual


Læs nedenfor 📖 manual på dansk for AXESS AX-ADGM04 (12 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 22 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/12
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
AX-ADGM04
I N S TA L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 5/4/20 INSTAX-ADGM04
INTRODUCTION
INTERFACE FEATURES
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun, solder,
and heat shrink • Small flat-blade screwdriver
• Tape
• Wire cutter • Zip ties
TABLE OF CONTENTS
Connections to be made
For models
without
an amplifier .......................3
For models
with
an analog amplifier ................4
For models
with
a digital amplifier ...................5
12-pin pre-wired ASWC-1 harness ......................6
DIN jack ................................................................6
Installing & programming the AX-ADGM04
AX-ADBOX1 ...........................................................6
AX-ADBOX2 .......................................................... 7
Adjusting the AX-ADGM04 ....................................8
Extra features .........................................................9
GM Data Interface 2012-2016
APPLICATIONS
See inside front cover
The AX-ADGM04 harness is designed for, and must be used with, the
AX-ADBOX1 or AX-ADBOX2 interface (sold separately). Please refer to the
AX-ADBOX1 or AX-ADBOX2 for the 16-pin connector with stripped leads
.
Provides accessory power (12-volt 10-amp)
Maintains the retained accessory power
(R.A.P.) feature
Provides NAV outputs (parking brake,
reverse, speed sense)
Retains chimes
Retains OnStar / OE Bluetooth
Adjustable OnStar level
Retains RSE (rear seat entertainment)
Retains satellite radio
Retains the factory AUX-IN jack
Pre-wired ASWC-1 harness
(ASWC-1 sold separately)
Can be used in non-amplified, or analog/
digital amplified models
Retains balance and fade†
Micro-B USB updatable
INTERFACE COMPONENTS
• AX-ADGM04 harness
• 4-pin to 4-pin resistor pad harness
† To retain fade in digital amplified models, use the AX-ADBOX1


Produkt Specifikationer

Mærke: AXESS
Kategori: Ikke kategoriseret
Model: AX-ADGM04

Har du brug for hjælp?

Hvis du har brug for hjælp til AXESS AX-ADGM04 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret AXESS Manualer

AXESS

AXESS AXAMP-CH3 Manual

28 December 2024
AXESS

AXESS AXAMP-FD1 Manual

27 December 2024
AXESS

AXESS AXAMP-CH5 Manual

27 December 2024
AXESS

AXESS AX-LOC Manual

27 December 2024
AXESS

AXESS AXAMP-CH4 Manual

27 December 2024
AXESS

AXESS 99-6520B Manual

10 September 2024
AXESS

AXESS AXPIO-IN1 Manual

10 September 2024
AXESS

AXESS AXBUCS-MZ286V Manual

9 September 2024
AXESS

AXESS 99-7014HG Manual

6 September 2024
AXESS

AXESS AXGM-17 Manual

6 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer