Bauknecht GSIP 6130 Manual


Læs nedenfor 📖 manual på dansk for Bauknecht GSIP 6130 (8 sider) i kategorien Opvaskemaskine. Denne guide var nyttig for 29 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/8
5019 496 01156
Before using the dishwasher, read the installation and maintenance instructions carefully!
1
GB GSIP 6130
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra
functions, different settings, water supply temperatures, water hardness and power supply voltage.
2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories: for detailed information on the EN/Standard
loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been proven in collaboration with the Pasteur Institute of Lille (France), in conformity with. Standard NF EN 13697 of
November 2001.
1. OVERVIEW
Programme selection button
Press the button (repeatedly) until the indicator lamp of the
desired programme lights up (see table 1.1).
At the end of the wash cycle, the last programme selected is
memorized.
Half Load/Multizone
Load the upper or lower rack only.
Factory setting = Wash upper and lower rack (both indicator
lamps light up)
Press once = Wash lower rack (the indicator lamp lights up)
Press twice = Wash upper rack (the indicator lamp lights up)
At the end of the programme, the most recently selected setting
remains memorised.
If the upper rack is not being washed, the “Wash lower rack”
indicator lamp should be lit.
Antibacterial rinse 3)
This function activates an antibacterial rinse at the end of the
wash cycle, guaranteeing a further reduction of bacteria. Press
the button to activate or deactivate the function. This function
can be used with those programmes marked with the relative
symbol in table 1.1.
The dishwasher door must be kept shut for the entire duration
of the programme in order to guarantee reduction of bacteria. If
the door is opened the indicator lamp starts flashing.
At the end of the programme, the most recently selected setting
remains memorised.
Detergent setting upon initial use and when using a different
type of detergent
Indicator lamp off = Powder/gel detergent (factory setting).
If using combined detergents, press and hold the button for 3
seconds; the indicator lamp lights up = rinse aid and salt
indicators are deactivated.
From water hardness level 5, the salt indicator remains active.
At the end of the programme, the most recently selected setting
remains memorised.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:min),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (e. g. h 01). If using a sensor
programme, a dotted line indicates that the calibration process
is underway (lasting up to 20 minutes).
In the presence of a fault indication “F.. / E..”, refer to Section 5
“What to do if....
Delayed Start button
Push the button (repeatedly) to delay the start of the
programme. Adjustable from 1 to 24 hours. With each
successive touch of the button, the delayed start indicator
increases by 1 hour, and after “h 24” returns to “h 00”. Then
press the START button. The wash programme will start after
the set time.
Start/Resume button
The indicator lamp lights up during operation, flashes when the
programme is interrupted before completion and switches off
at the end of the programme.
Cancel/Off button
Press the button to switch the dishwasher off or to interrupt
the selected programme.
If the Cancel/Off indicator lamp flashes repeatedly, this indicates
a fault: see chapter 5 “What to do if...”.
Salt level indicator and rinse aid level indicator
These light up at the end of the programme if salt or rinse aid
needs topping up.
Only add just before starting a wash cycle.
Table 1.1.
Programme Table Detergent
dispenser Consumption 1)
PProgrammes Additional
options Description of programme large small Litres kWh Minutes
1 Sensor 40-70°C Normally or heavily soiled crockery,
including pots and pans. X X 7-14 0.99-1.80 70-185 ± 1)
2 Pre-Rinse cold Crockery to be washed later. 4.0 0.03 14 ± 1)
3 Glasses 40°C Light soiling, for example glasses and
cups. X 10.0 0.85 100 ± 1)
4 Quickwash 45°C Lightly soiled crockery, with no dried-on
food. X 11.0 0.80 30 ± 1)
5Bio Normal 2) 50°C Normally soiled crockery.
Energy-saving programme. X X 11.0 1.05 170 ± 1)
6 Daily 60°C Normally to heavily soiled crockery. X X 13.0 1.25 120 ± 1)


Produkt Specifikationer

Mærke: Bauknecht
Kategori: Opvaskemaskine
Model: GSIP 6130

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht GSIP 6130 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Opvaskemaskine Bauknecht Manualer

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Siemens

Siemens SN45M283SK Manual

3 December 2024
Bosch

Bosch SGS44E72EU Manual

29 November 2024
Samsung

Samsung DW60M9550BB Manual

26 November 2024
Bosch

Bosch SMS63M18AU Manual

26 November 2024
Kogan

Kogan KABNCHTPDWA Manual

26 November 2024
Siemens

Siemens SX64M080EU Manual

26 November 2024
Bosch

Bosch SGU53E15AU Manual

25 November 2024
Samsung

Samsung DW60M5044FS Manual

24 November 2024
Samsung

Samsung DW60DG550B00 Manual

24 November 2024
Samsung

Samsung DW60DG540FSR Manual

24 November 2024