Behringer 112 Manual


Læs nedenfor 📖 manual på dansk for Behringer 112 (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 79 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Quick Start Guide
112 DUAL VCO
Legendary Analog Dual VCO
Module for Eurorack
Controls
(1) PW MOD IN – Accepts a voltage from another module to
control the pulse width.
(2) VCO OUT – Send the VCO signal to one or two sources via
3.5 mm TS cables.
(3) WAVEFORM – Select pulse, triangle or sawtooth
waveforms for the VCO.
(4) PULSE WIDTH Adjusts the pulse width modulation
based on the voltage received at the PW MOD IN jack.
(5) MOD MANUAL – Sets the ratio between the upper and
lower portions of the pulse wave.
(6) SYNC OUT – Sends a synchronization signal via 3.5 mm
TS cable.
(7) RANGE – Sets the pitch range of the VCO in octave steps.
(8) SYNC IN – Accepts a synchronization signal via 3.5 mm
TS cable.
(9) WEAK/STRONG Determines the accuracy
of synchronization.
(10) PITCH – Fine tunes the pitch.
(11) MOD LEVEL – Adjusts the level of the signal connected
to the associated MOD IN jack.
(12) MOD IN – Accepts voltages that control or modulate
the VCO pitch.
Power Connection
The module comes with the required power cable for connecting
to a standard Eurorack power supply system. Follow these
steps to connect power to the module. It is easier to make
these connections before the module has been mounted into
a rack case.
1. Turn the power supply or rack case power o and
disconnect the power cable.
2. Insert the 16-pin connector on the power cable into the
socket on the power supply or rack case. The connector has
a tab that will align with the gap in the socket, so it cannot
be inserted incorrectly. If the power supply does not have
a keyed socket, be sure to orient pin 1 (-12 V) with the red
stripe on the cable.
3. Insert the 10-pin connector into the socket on the back of
the module. The connector has a tab that will align with the
socket for correct orientation.
4. After both ends of the power cable have been securely
attached, you may mount the module in a case and turn on
the power supply.
(3)
(4)
(1) (2)
(12)
(10)
(11)
(5)
(6)
(7)
(8)
(9)
V 1.0


Produkt Specifikationer

Mærke: Behringer
Kategori: Ikke kategoriseret
Model: 112

Har du brug for hjælp?

Hvis du har brug for hjælp til Behringer 112 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Behringer Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Gigabyte

Gigabyte ODIN GT 550W Manual

23 November 2024
Stamos

Stamos S-PLASMA 60U Manual

23 November 2024
Velbus

Velbus VMBPIRO-W-20 Manual

23 November 2024
Honor

Honor 90 Pro Manual

23 November 2024
Honor

Honor 80 SE Manual

23 November 2024
Medela

Medela Safe & Dry Manual

22 November 2024
Jane

Jane First Potty Manual

22 November 2024