Blade Chroma Manual

Blade Drone Chroma

Læs nedenfor 📖 manual på dansk for Blade Chroma (2 sider) i kategorien Drone. Denne guide var nyttig for 35 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

Charging Balancing Charging

complete

• A green LED cycles around the motor

pods counter-clockwise until GPS is

acquired

• Once GPS is acquired, the front LEDs

are white and the rear are green

• Intended for the beginner pilot

• Maximum distance of 100 m from

the pilot

• A purple LED cycles around the motor

pods counter-clockwise until GPS is

acquired

• Once GPS is acquired, the front LEDs

are white and the rear are purple

• Intended for the intermediate pilot

• Maximum distance of 100 m from

the pilot

NOTICE: If the Chroma™ quadcopter loses GPS signal while  ying in either Smart or AP Mode, the LEDs will  ash rapidly for 2 seconds and then

once every second. The quadcopter will default to a stable  ight mode with similar control response as AP Mode. Return Home will not function.

Please familiarize yourself with the controls in AP Mode to ensure a safe return of the quadcopter in the event of GPS signal loss.

For best results while using Smart Mode, it is recommended that the

pilot always turn to face the quadcopter while  ying.

Power

connected

Charger LED codes

Charge the Flight Battery (~75 min) Install the propellers

Install and Charge the ST-10+ Transmitter Battery

Install the Flight Battery

Extend the GPS MastRemove the Gimbal Cover Power Up Connect the CGO3 Camera

to the ST-10+ via Wi-Fi

Understanding the Flight Modes

1 2

4a 4b 6 7

8 9

CAUTION: All instructions and warnings must be followed exactly. Mishandling

of Li-Po batteries can result in a  re, personal injury and/or property damage.

Smart Mode

AP Mode

16 ft

(5 m)

Front

Pilot location

Home position

Placement at startup

SAFE Circle™

Pilot location

Right transmitter stick

Stick commands move

the Chroma™ quadcopter

relative to the pilot location

Stick commands move

the Chroma™ quadcopter

relative to its orientation

Right transmitter stick

Left transmitter stick

Front

Place the quadcopter outdoors on a  at,

level surface.

Set the top right transmitter switch to

Smart.

Power on the transmitter.

Power on the quadcopter.

Perform the compass calibration

as shown in the video at

www.KnowChroma.com.

The LEDs will show green, rotating

counter-clockwise around the motor

pods while the quadcopter acquires a gps

signal. The front LEDs will show white and the

rear will show green when the quadcopter is

ready for  ight.

Insert the LiPo battery into the

ST-10+ transmitter.

Connect the battery lead to the

transmitter noting the correct polarity.

Close the battery compartment.

10a

10b

Motor Start

Throttle control Flying and Landing After Your FlightControlling the Camera

Motor Stop

• Slide the fully charged battery in until it locks.

• Remove the battery by pressing the locking tab and

sliding the battery to the rear of the quadcopter.

12 1413

NOTICE: If you begin to lose control, release the control sticks and the

model will self-level.

NOTICE: Return home will only function if the quadcopter has GPS lock.

Pay close attention to the LEDs while  ying. If at any time the LEDs indicate

the  ight battery voltage is low, as shown in the LED reference guide, land the

quadcopter immediately and charge the  ight battery.

Climb

Descend

To land, you may either slowly lower the left

transmitter stick to descend and land,

stopping the motors as shown in step 10b:

• To maintain the current

altitude, allow the left

transmitter stick to return

to center.

or you may select on the top right switch on your transmitter:“Return Home”

Solid red

The quadcopter will return to the start position, land and stop the motors.

You may cancel the return to home function by switching back to Smart or

AP Mode on the top right switch on your transmitter.

Away from

the pilot

Toward

the pilot

CAUTION: Starting the motors sets the home location. The

quadcopter must be approximately 16 feet (5 meters) from where

the pilot will stand during  ight, pointing away from the pilot. If the aircraft

is pointed in any other direction, the feature will not function SAFE Circle™

as expected and may result in personal injury or damage to property. Once

the aircraft’s motors are started, do not change your position.

After the CGO3 camera powers on, the LED on the

gimbal will glow red for approximately 40 seconds.

When the LED changes to yellow, complete the

following steps to bind the CGO3 to the ST-10+:

• Select Flight Settings from the main menu on the

ST-10+.

• Select the Bind option.

• Under Camera, select the CGO3 network

(CGO3_******).

• Touch the Password line on the screen and enter

the password “1234567890” on the touchscreen.

• Select OK.

• The ST-10+ will indicate a successful connection.

Select OK.

• Return to the Main Menu.

The live video feed is now visible on the ST-10+

display.

Double tap on the image to expand the video to  ll the

display. Double tap again to return to the main menu

with live video.

Use the buttons on the top of the ST-10+ to control the camera functions.

Use the Camera Tilt Slider to

adjust the vertical angle of the

camera gimbal.

M A N U A L

WITH C GO3 4K CAMERA GIMBAL A ND ST-10+ PERSONAL GROUND STATION TRANSMITTER*

Connect the USB cable to an

appropriate USB power source

and to the charge port of the transmitter.

The screen will show a charging battery

icon. Disconnect the USB cable when the

onscreen battery icon shows full capacity.

Video

Start/Stop

Button

Photo

Button

Camera Tilt Slider

Hold 3 seconds

Hold until the motors stop

NOTICE: Do not press the Motor Stop button

while the aircraft is airborne. The motors could

stop, causing the aircraft to crash.

Tip: Replace the gimbal cover after  ying for storage and

transportation of the quadcopter to protect the gimbal.

* This aircraft is not compatible with Spektrum™ DSM®, DSM2® or DSMX® technology.

For information on additional  ight modes, including “Follow Me,” see the online video at www.KnowChroma.com.

For further information on controlling

the CGO3 camera with the ST-10

Ground Station, see the online video

at www.KnowChroma.com.

WARNING: Stopping the motors while

the quadcopter is still in  ight will cause

the quadcopter to crash. Crash damage is not

covered under warranty.

• The props and motor pods have a letter

code, either or molded in. Match “A” “B”

the props to the motor pods and the “A” “A”

“B” “B” props to the motor pods.

• The props thread on counter-clockwise.“A”

• The props thread on clockwise.“B”

• Tighten the props only  nger tight.

DO NOT overtighten.

Produkt Specifikationer

Mærke:	Blade
Kategori:	Drone
Model:	Chroma
Højde:	242 mm
Vægt:	1300 g
Produktfarve:	Hvid
Batterikapacitet:	5400 mAh
Batteriteknologi:	Lithium polymer (LiPo)
Understøttede videotilstande:	1080p
Frekvensbånd:	2.4/5.8 GHz
Megapixel:	16 MP
Maksimal driftstilstand:	600 m