Bosch TDA2651GB Manual

Bosch Strygejern TDA2651GB

Læs nedenfor 📖 manual på dansk for Bosch TDA2651GB (2 sider) i kategorien Strygejern. Denne guide var nyttig for 31 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
004 TDA26..GB/07/12
Customer Service
Great Britain
Bosch Customer Service
Grand Union House
Old Wolverton Road
Milton Keynes
MK12 5PT
UK +44 (0)844 892 8923
IRL +353 (0)1450 2655
www.bosch-home.co.uk
Operating instructions
Solving Minor Problems Yourself
Problem Possible Causes Solution
The iron does
not work or is not
heating up.
Temperature control (I)
on a very low setting.
Turn the temperature control to
the desired position.
Connection problems. Check that the plug is inserted
into the mains socket correctly.
The clothes tend
to stick.
Temperature control (I)
setting is too high.
Turn the temperature control to
a lower setting.
Water comes out
of the soleplate
together with
steam.
Temperature control (I)
setting is too low.
Turn the temperature control to
a higher setting.
Steam regulator (A)
is set too high in
conjunction with a low
temperature.
Turn the steam regulator to a
lower setting.
You have pressed the
shot of steam button
(L) repeatedly wihhout
waiting for 5 seconds
between each press.
Wait 5 seconds between each
press of the shot of steam
button.
Tap or part distilled
water has not been used
(see“Filling the water
tanksection) or other
products such as fragant
water have been added
to the tank.
Mix distilled water with tap
water as directed in the „Filling
the water tank“ section, and
never add any other products
to the water tank.
Iron is not
steaming.
Steam regulator (A) in
“0” or “calc” position.
Turn the steam regulator to “1”
or “2” position.
No water in tank. Fill the tank.
Scale obstruction of
internal components.
Remove the steam regulator
(A) and clean it. If this does not
help contact an Authorised
Technical Service Centre.
Spray does not
work.
No water in the tank. Add water to the water tank.
Obstructed mechanism. Contact an Authorised
Technical Service Centre.
Water comes
out from the
soleplate before
plugging the
iron in.
The steam regulator (A)
is not properly closed.
Place the steam regulator in the
“0” position.
Deposits come
out through
the holes in the
soleplate.
Traces of lime scale are
coming out of the steam
chamber.
Carry out a cleaning cycle “(see
“Multiple de-scaling system”
section)
The iron begins
to smoke when
switched on.
During first use: Certain
components on the
appliance have been
lightly greased at
the factory and may
produce a little smoke
when initially heated.
This is completely normal and
will stop after a short while.
Flashing lamp on
top of handle (*)
Auto-shut off has been
activated.
Move the iron gently fromside
to side to re-start it.
The lamp will then flash once
before it re-heats.
ca lc
TDA 26..
sensi B1xx
(*) Model dependent
You can download this manual from the local homepages of Bosch
Thank you for buying the TDA26 steam iron from Bosch. This iron has a
lightweight design and is built to perform.
These instructions contain valuable information about the unique features
of this iron and some hints to make ironing easier for you.
Please visit www.bosch-home.co.uk for more product information
or to register your product, just follow the link to the Online
guarantee registration.
Before using the Iron for the first time
Please carry out the following steps:
1. Remove the protective cover from the soleplate before using the iron.
2. While the iron is unplugged, fill the water tank (E) with tap water and
set the temperature control (I) to “max” by lining it up with the pointer
(H).
3. Plug the appliance into the mains and when the iron has reached the
correct temperature (the pilot light [K] goes out), set the steam regulator
(A) to the “2” position.
4. Hold the iron horizontally and repeatedly press the shot of steam button
(L). Any residue should come out of the soleplate (G). It may smoke
and smell – this is normal and will cease after a short while.
5. If necessary, carefully clean the soleplate down with a dry, folded cloth.
Cleaning and Maintenance
! Attention! Risk of burns!
For general cleaning, follow the information below:
Problem Solution
Dirty/lightly marked iron
body or soleplate
Clean the body of iron or soleplate with a
damp cloth then dry it..
Mark develops on
soleplate during use
Set the iron to its maximum temperature
setting. Rub the iron a few times over with
a dry cotton cloth folded several times.
Heavily stained soleplate
While the iron is cold, iron a linen cloth
soaked in white vinegar. Then dampen a
cloth with water and wipe the soleplate
clean and dry thoroughly.
DO NOT de-scale or clean the water tank with cleaning products or
solvents, as these could cause the iron to drip when using the steam
function.
DO NOT use a “professional steam cleaner” for cleaning the appliance.
DO NOT use sharp objects or abrasive products to clean the soleplate or
any other part of the appliance. To keep the soleplate in good condition,
do not allow it to come into contact with metal objects.
GUARANTEE TERMS
The terms of the guarantee for this appliance are in accordance with that
stated by our representative for the country in which it is sold. Details
of those conditions can be obtained from the retailer from whom the
appliance was purchased. The SALES RECEIPT must be presented when
making any claims against the terms of this guarantee. We reserve the
right to make technical modifications.
Environmental Care
This iron has been designed according to ecological criteria related to
sustainable development; analysing its whole lifecycle, from material
selection to its later reuse or recycling; evaluating the improvement
possibilities from a technical, ecological and environmental point of view.
Before throwing a used appliance away, you should make it noticeably
inoperable e.g. cut off the mains lead and be certain to dispose of it in
accordance with current laws and regulations.
Your retailer, town council or local council can give you detailed
information about these.
This appliance is labelled in accordance with
European Directive 2002/96/EG concerning used
electrical and electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the framework for the
return and recycling of used appliances as applicable
throughout the EU.
Important
This iron has been designed according to ecological criteria,
related to the sustainable development; analyzing its whole
lifecycle, from material selection to its later reusing or recycling;
evaluating the improvement possibilities, from a technical,
economical and environmental point of view.
This appliance has been designed exclusively for domestic use
and must not be used for industrial purposes.
Carefully read through the operating instructions for the appliance
and safeguard them for future reference.
General safety instructions
The iron must not be left unattended while it is
connected to the supply mains.
Remove the plug from the socket before filling the
appliance with water or before pouring out the
remaining water after use.
The appliance must be used and placed on a stable
surface.
When placed on its stand, make sure that the surface
on which the stand is placed is stable.
The iron should not be used if it has been dropped,
if there are visible signs of damage or if it is leaking
water. It must be checked by an authorized Technical
Service Centre before it can be used again.
With the aim of avoiding dangerous situations, any
work or repair that the appliance may need, e.g.
replacing a faulty mains cable, must only be carried
out by qualified personnel from an Authorised
Technical Service Centre.
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without
supervision.
Keep the iron and its cord out of reach of children less
than 8 years of age when it is energized or cooling
down.
This appliance is to be connected and used in accordance with the
information stated on its characteristics plate.
This appliance must be connected to an earthed socket. If it is
absolutely necessary to use an extension cable, make sure that it is
suitable for 16A and has a socket with an earth connection.
If the safety fuse fitted in the appliance blows, the appliance will be
rendered inoperative. To restore normal operation the appliance will
have to be taken to an authorised Technical Service Centre.
In order to avoid that, under unfavourable mains conditions, phenomena
like transient voltage drops or lighting fluctuations can happen, it is
recommended that the iron is connected to a power supply system
with a maximum impedance of 0.27 . If necessary, the user can ask Ω
the public power supply company for the system impedance at the
interface point.
The appliance must never be placed directly under the tap to fill the
water tank.
Unplug the appliance from the mains supply after each use, or if a fault
is suspected.
The electrical plug must not be removed from the socket by pulling
the cable.
Never immerse the iron in water or any other fluid.
Do not leave the appliance exposed to weather conditions (rain, sun,
frost, etc.)


Produkt Specifikationer

Mærke: Bosch
Kategori: Strygejern
Model: TDA2651GB

Har du brug for hjælp?

Hvis du har brug for hjælp til Bosch TDA2651GB stil et spørgsmål nedenfor, og andre brugere vil svare dig




Strygejern Bosch Manualer

Strygejern Manualer

Nyeste Strygejern Manualer