Boss VO-1 Manual
Boss
Guitar forstærker
VO-1
Læs nedenfor 📖 manual på dansk for Boss VO-1 (1 sider) i kategorien Guitar forstærker. Denne guide var nyttig for 2 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/1
Owner’s Manual
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate sheet).
After reading, keep the document(s) where it will be available for immediate reference.
Precautions When Connecting
5 To prevent malfunction and equipment failure, always turn
down the volume, and turn o all the units before making any
connections.
5 Once the connections have been completed, turn on power to
your various devices in the order specied. By turning on devices
in the wrong order, you risk causing malfunction and/or damage
to speakers and other devices.
When powering up: Turn on the power to your guitar amp last.
When powering down: Turn o the power to your guitar amp rst.
5 Immediately after the unit is powered-on, the eect is on.
Use of Battery
5 A battery was installed in the unit before it left the factory. The life
of this battery may be limited, however, since its primary purpose
was to enable testing.
5 If you handle batteries improperly, you risk explosion and uid
leakage. Make sure that you carefully observe all of the items
related to batteries that are listed in “USING THE UNIT SAFELY” and
“IMPORTANT NOTES” (supplied on a separate sheet).
5 When operating on battery power only, the unit’s indicator will
become dim when battery power gets too low. Replace the
battery as soon as possible.
5 Batteries should always be installed or replaced before connecting
any other devices. This way, you can prevent malfunction and
damage.
5 If operating this unit on battery, please use alkaline battery.
MODE Knob
Switches the vocoder mode.
MODE Explanation
VINTAGE Produces a unique vocoder eect as if you were
playing a keyboard instrument.
ADVANCED Produces a new vocoder eect with greater clarity
than VINTAGE.
TALK BOX Produces a talk-box sound without requiring a hose.
CHOIR
Automatically adds voices that are matched to your
playing, adding spaciousness and depth to your
sound. You can also use this without connecting a
mic.
COLOR Knob
Adjusts the following, depending on the mode that’s selected.
MODE Explanation
VINTAGE
ADVANCED
Turning the knob toward the left makes the eect
sound more masculine; turning it toward the right
makes the eect sound more feminine.
TALK BOX Adjusts the amount of distortion for the eect sound.
CHOIR Adjusts the character of the voices that are added.
Playing the Vocoder
While playing your guitar, vocalize into the connected mic.
* In modes other than CHOIR, you won’t hear any eect sound
unless you’re vocalizing into the mic.
Changing the Battery
1. Hold down the pedal and loosen
the thumbscrew ,
then open the pedal upward.
* The pedal can be opened without
detaching the thumbscrew completely.
2. Remove the old battery from
the battery housing , and
remove the battery snap
connected to it.
3. Connect the battery snap to the new battery, and place
the battery inside the battery housing.
* Be sure to carefully observe the battery’s polarity (+ versus -).
4. Slip the coil spring onto the spring base on the
back of the pedal, and then close the pedal.
* Carefully avoid getting the battery snap cord caught in the
pedal, coil spring, and battery housing.
5. Insert the thumbscrew into the guide bush hole and
tighten it securely.
Specications
Nominal Input Level INPUT, RETURN: -20 dBu
MIC: -40 dBu (MIC SENS: LOW)
Input Impedance INPUT, RETURN: 1 MΩ
MIC: 4 kΩ
Nominal Output
Level OUTPUT, SEND: -20 dBu
Output Impedance OUTPUT, SEND: 1 kΩ
Recommended Load
Impedance 10 kΩ or greater
Power Supply Alkaline battery (9 V, 6LR61)
AC adaptor (PSA series: sold separately)
Current Draw 70 mA
* Expected battery life under continuous use:
Alkaline: 4 hours
These gures will vary depending on the
actual conditions of use.
Dimensions 73 (W) x 129 (D) x 59 (H) mm
2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches
Weight 430 g / 1 lb (including battery)
Accessories Leaet (“USING THE UNIT SAFELY,” “IMPORTANT
NOTES,” and “Information”)
Alkaline battery (9 V, 6LR61)
Options
(sold separately) AC adaptor (PSA-series)
* 0 dBu = 0.775 Vrms
* This document explains the specications of the product at the
time that the document was issued. For the latest information,
refer to the Roland website.
9 V Battery
English
Main Features
Panel Descriptions
7This is a vocoder for guitar or bass that provides unique and high-impact vocoder sound just as if you were playing a keyboard instrument.
7TALK BOX mode lets you use your voice to create a variety of performance expressions without having to keep a hose gripped in your mouth; simply connect a mic and your guitar or bass.
7You can also use CHOIR mode to add spaciousness and depth to your playing without connecting a mic.
INPUT jack
Connect your guitar/bass to this jack.
* Connect your guitar/bass directly to this jack. If you want
to connect an eect unit before the VO-1, use the SEND/
RETURN jacks.
* The INPUT jack doubles as the power switch. Power to the
unit is turned on when you plug into the INPUT jack; the
power is turned o when the cable is unplugged. To prevent
unnecessary battery consumption, be sure to disconnect
the plug from the INPUT jack when not using the eects
unit.
AC Adaptor
(PSA series: optional)
LEVEL knob
Adjusts the overall volume.
BLEND knob
Adjusts the balance of the guitar/bass input sound and the eect sound.
If you’re using the RETURN jack, this knob adjusts the balance of the audio signal
that’s input to the RETURN jack and the eect sound.
TONE knob
Adjusts the brightness of the eect sound.
COLOR knob/MODE knob
* Refer to “COLOR Knob,“ “MODE Knob.“
MIC jack
Connect your mic to this jack.
Use the MIC SENS switch located beside the DC IN jack
to select the appropriate input sensitivity for your mic.
The normal setting is LOW, but you should set this to
HIGH if the sensitivity is insucient.
DC IN jack
Accepts connection of an AC Adaptor (PSA series; optional). By using an AC Adaptor, you can play without
being concerned about how much battery power you have left.
* Use only the specied AC adaptor (PSA series; optional), and connect it to an AC outlet of the correct
voltage. Do not use any other AC adaptor, since this may cause malfunction.
* If the AC adaptor is connected while a battery is installed, the power supply is
drawn from the AC adaptor.
* We recommend that you keep batteries installed in the unit even though
you’ll be powering it with the AC adaptor. That way, you’ll be able to
continue a performance even if the cord of the AC adaptor gets accidently
disconnected from the unit.
CHECK indicator
This indicator shows whether the eect is on or o, and also doubles as the battery check
indicator. The indicator lights when the eect is on.
* If you’re powering the unit with a battery and the CHECK indicator goes dim— or doesn’t
light at all—when you try to turn the eect on, the battery is near depletion and should be
replaced. For instructions on changing the battery, refer to “Changing the Battery.”
OUTPUT jack
Connect this jack to your amp or to the
input of another eect unit.
SEND/RETURN jacks
Connect the SEND jack to the input of an eect unit that you’re
using to process the audio signal of your guitar/bass.
* If you connect a distortion-type or other eect unit to the
SEND/RETURN jacks, you can perform with your preferred
guitar/bass sound heard together with the vocoder eect.
Pedal switch
This switch turns the eect on/o.
Thumbscrew
When this screw is loosened, the
pedal will open, allowing you to
change the battery.
* For instructions on changing
the battery, refer to “Changing
the Battery.”
MIC SENS
LOW HIGH
* This instrument is equipped with balanced (XLR) type jacks.
Wiring diagrams for these jacks are shown as the illustration.
Make connections after rst checking the wiring diagrams of
other equipment you intend to connect.
* This unit does not provide phantom power.
1: GND
2: HOT
3: COLD
GUITAR/BASS MIC
EFFECT OFF BYPASS OFF
© 2016 Roland Corporation 02
Produkt Specifikationer
| Mærke: | Boss |
| Kategori: | Guitar forstærker |
| Model: | VO-1 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Boss VO-1 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Guitar forstærker Boss Manualer
16 December 2024
16 December 2024
16 December 2024
16 December 2024
16 December 2024
16 December 2024
16 December 2024
16 December 2024
16 December 2024
16 December 2024
Guitar forstærker Manualer
- Guitar forstærker VOX
- Guitar forstærker Peavey
- Guitar forstærker Behringer
- Guitar forstærker Roland
- Guitar forstærker Yamaha
- Guitar forstærker Marshall
- Guitar forstærker Hartke
- Guitar forstærker ART
- Guitar forstærker TC Electronic
- Guitar forstærker Electro Harmonix
- Guitar forstærker Fender
- Guitar forstærker Empress Effects
- Guitar forstærker Blackstar
- Guitar forstærker Harley Benton
- Guitar forstærker Mooer
- Guitar forstærker Bugera
- Guitar forstærker Hughes & Kettner
- Guitar forstærker Palmer
- Guitar forstærker Laney
- Guitar forstærker Ashdown Engineering
- Guitar forstærker Dimavery
- Guitar forstærker Markbass
- Guitar forstærker Fishman
- Guitar forstærker NUX
- Guitar forstærker Orange
- Guitar forstærker AER
- Guitar forstærker EBS
- Guitar forstærker Rivera
- Guitar forstærker Suhr
- Guitar forstærker Two Notes
- Guitar forstærker GR Bass
- Guitar forstærker Voodoo Lab
- Guitar forstærker AMT
- Guitar forstærker DV Mark
- Guitar forstærker DACS Audio
Nyeste Guitar forstærker Manualer
15 December 2024
12 December 2024
9 December 2024
2 Oktober 2024
2 Oktober 2024
2 Oktober 2024
2 Oktober 2024
2 Oktober 2024
21 September 2024
16 September 2024