Brother P-touch PT-P750W Manual

Brother Etiketprinter P-touch PT-P750W

Læs nedenfor 📖 manual på dansk for Brother P-touch PT-P750W (4 sider) i kategorien Etiketprinter. Denne guide var nyttig for 18 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
Follow these guidelines to avoid the risk of fire, burns, injury, electric
shocks, rupture, overheating, abnormal odors or smoke.
Always use the specified voltage and the included AC adapter (AD-E001) for the
P-touch labeler to prevent any damage or failure.
Do not touch the P-touch labeler during a lightning storm.
Do not use the P-touch labeler/AC adapter in places of high humidity such as
bathrooms.
Do not overload the power cord.
Do not place heavy objects on, or damage the P-touch labeler, power cord or plug.
Do not forcibly bend or pull the power cord. Always hold the AC adapter when
disconnecting from the power outlet.
Make sure that the plug is fully inserted in the power outlet. Do not use an outlet that
is loose.
Do not allow the P-touch labeler/AC adapter/power plug/batteries to get wet, for
example, by handling them with wet hands or spilling beverages on to them.
Do not disassemble or modify the P-touch labeler/AC adapter/batteries.
Do not allow a metal object to contact both the plus and minus ends of a battery.
Do not use sharp objects, such as tweezers or a metallic pen, to change the batteries.
Do not throw the batteries into fire or expose to heat.
Disconnect the AC adapter, remove batteries immediately and stop using the
P-touch labeler if you notice abnormal odor, heat, discoloration, deformation or
anything unusual while using or storing it.
Do not use a damaged or leaking battery as the fluid may get on your hands.
Do not use a deformed or leaking battery or one whose label is damaged. There is
a possibility of damaging the P-touch labeler.
Since loss of eyesight may result if leaked fluid from batteries gets into your eyes,
immediately rinse your eyes with a large amount of clean water, and then seek
medical attention.
Follow these guidelines to avoid personal injury, liquid leakage, burns
or heat.
When the P-touch labeler is not being used, store it out of the reach of children. In
addition, do not allow children to put any P-touch labeler parts or labels in their
mouths. If any object has been swallowed, seek medical attention.
Do not touch metal parts around the print head immediately after printing.
Do not touch the cutter blade. (See Unpacking the PT-P750W & Parts Description.)
If leaked fluid from batteries gets on your skin or clothes, immediately rinse them
with clean water.
Remove the batteries and disconnect the AC adapter if you do not intend to use the
P-touch labeler.
Do not use any batteries other than those specified. Do not use combinations of old
and new batteries or combinations of different types, different charging levels,
different manufacturers or different models. Do not insert a battery with its plus and
minus ends reversed.
Do not drop or hit the P-touch labeler/AC adapter.
Do not put your finger inside the P-touch labeler when you close the cassette cover.
Before using Ni-MH rechargeable batteries, carefully read the instructions for the
batteries and battery charger, and be sure to use them correctly.
When using Ni-MH rechargeable batteries, charge the batteries with a specialized
battery charger before using the batteries.
Do not put your finger inside the tape exit slot. You could be injured by the cutter blade.
Depending on the location, material, and environmental conditions, the label may
unpeel or become irremovable, the color of the label may change or be transferred
to other objects. Before applying the label, check the environmental conditions and
the material.
Do not use the P-touch labeler in any way or for any purpose not described in this
guide. Doing so may result in accidents or damage to the P-touch labeler.
Use only Brother TZe tapes with the P-touch labeler. Do not use tapes that do not
have the mark.
Only use a soft, dry cloth to clean the P-touch labeler; never use alcohol or other
organic solvents.
Use a soft wipe to clean the print head; never touch the print head with your fingers.
Do not put any foreign objects into the tape exit slot, the AC adapter connector or
battery compartment, etc.
Do not place the P-touch labeler/batteries/AC adapter in direct sunlight or rain, near
heaters or other hot appliances, in any location exposed to extremely high or low
temperatures (e.g., on the dashboard or in the back of your car), high humidity, or
in dusty locations.
Do not try to print if the cassette is empty; it will damage the print head.
Do not pull the tape while printing or feeding; it will damage the tape and the P-touch
labeler.
Any data stored in memory will be lost due to failure or repair of the P-touch labeler,
or if the batteries expire.
The P-touch labeler is not equipped with a charging feature for rechargeable batteries.
The length of the printed label may differ from the displayed label length on the
computer.
A protective clear plastic sticker is placed over the top panel during manufacturing
and shipping. This sticker should be removed prior to use.
When printing multiple copies of a label or using the numbering function printing, the
P-touch labeler will not detect the end of the tape cassette and will continue operating.
When using Heat Shrink Tube, the printing area will be smaller than when using
normal tape.
If you connect a mobile device to the P-touch labeler using the NFC function without
installing a specialized application, the Apps section of Google Play may be
displayed on your mobile device automatically.
You may be charged a communication fee for this service.
Open Source Licensing Remarks
This product includes open-source software.
To see the open source licensing remarks, please go to the manual download
selection on your model's home page of Brother Solutions Center at
http://support.brother.com/.
The available scientific evidence does not show that any health problems are associated with
using low power wireless devices. There is no proof, however, that these low power wireless
devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency
energy (RF) in the microwave range while being used. Whereas high levels of RF can produce
health effects (by heating tissue), exposure of low-level RF that does not produce heating
effects causes no known adverse health effects. Many studies of low-level RF exposures have
not found any biological effects. Some studies have suggested that some biological effects
might occur, but such findings have not been confirmed by additional research. PT-P750W has
been tested and found to comply with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines.
Trademarks and Copyrights
BROTHER is either a trademark or a registered trademark of Brother Industries, Ltd.
P-TOUCH is a trademark or registered trademark of Brother Industries, Ltd.
© 2014 Brother Industries, Ltd. All rights reserved.
Microsoft, Windows Vista, Windows Server and Windows are either registered
trademarks or trademarks of Microsoft Corp. in the United States and/or other countries.
Apple, Macintosh, Mac OS, iPhone, iPad and iPod are trademarks of Apple Inc.,
registered in the United States and other countries.
The names of other software or products used in this document are trademarks or
registered trademarks of the respective companies that developed them.
Wi-Fi and Wi-Fi Alliance are registered trademarks of the Wi-Fi Alliance.
Each company whose software title is mentioned in this manual has a Software
LicenseLicence Agreement specific to its proprietary programs.
Any trade names and product names of companies appearing on Brother products,
related documents and any other materials are all trademarks or registered trademarks
of those respective companies.
Safety Precautions
WARNING Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injuries.
CAUTION Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injuries.
General Precautions
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Federal Communications Commission (FCC) Declaration of
Conformity (For USA Only)
Responsible Party: Brother International Corporation
200 Crossing Boulevard
P.O. Box 6911
Bridgewater, NJ 08807-0911 USA
TEL : (908) 704-1700
Product Name : Brother P-touch Electronic Labeling System
Model Number : PT-P750W
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
PT-P750W is equipped with FCC ID:B3Q8VA652.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Important
The enclosed interface cable should be used in order to ensure compliance with
the limits for a Class B digital device.
Changes or modifications not expressly approved by Brother Industries, Ltd.
could void the user's authority to operate the equipment.
* In case WLAN Interface is in use.
CAUTION: To maintain compliance with FCC’s RF exposure guidelines, use only
the supplied antenna. Unauthorize antenna, modification, or attachments could
damage the transmitter and may violate FCC regulations.
ELECTRONIC LABELING SYSTEM
English
Users Guide
Español
PT-P750W
Read this guide before you start using your P-touch labeler.
Keep this guide in a handy place for future reference.
LAE838001


Produkt Specifikationer

Mærke: Brother
Kategori: Etiketprinter
Model: P-touch PT-P750W

Har du brug for hjælp?

Hvis du har brug for hjælp til Brother P-touch PT-P750W stil et spørgsmål nedenfor, og andre brugere vil svare dig




Etiketprinter Brother Manualer

Etiketprinter Manualer

Nyeste Etiketprinter Manualer

Toshiba

Toshiba B-EX4T1-GS12 Manual

10 Oktober 2024
Bixolon

Bixolon SRP-F310 Manual

20 September 2024
Leitz

Leitz Icon MAC Manual

18 September 2024
Dymo

Dymo 2000 Manual

15 September 2024
Dymo

Dymo LetraTag Plus Manual

10 September 2024
Dymo

Dymo 4200 Kit Manual

10 September 2024
Honeywell

Honeywell PC42E-T Manual

3 September 2024
Brady

Brady M511 Manual

3 September 2024