CDA TT25ANI Manual
Læs nedenfor 📖 manual på dansk for CDA TT25ANI (2 sider) i kategorien Vandhane. Denne guide var nyttig for 26 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/2
For Service & Technical Support Call 01949 862012
TT25 – Traditional monobloc
Five Year warranty:
In the unlikely event that you should experience any defect in the materials or workmanship of your new mixer within years FIVE of purchase,
the purchaser’s sole remedy shall be the replacement (at the manufacturer’s discretion) of all or any part of the product that is defective. All
working parts and valves are guaranteed for a period of year FIVE s from purchase. Decorative surface finishes and O-rings are guaranteed
for ONE year from the date of purchase provided that our advice concerning care has been observed. This is provid that guarantee valid ing
the mixer hastap been used for normal domestic purposes in the UK and that the care, installation and maintenance instructions have been
observed. The warranty extends to the original purchaser only. You should retain a copy of your dated invoice as proof of purchase to validate
any claims under this guarantee.
Care Instructions for your Kitchen Sink Mixer:
To maintain the appearance of this tap, ensure that it is regularly cleaned only using a clean, soft damp cloth. A solution of warm water and
a mild liquid detergent may be used where necessary, and then the fitting rinsed thoroughly and wiped dry. Any other cleaning action will
invalidate your warranty. If the tap has a diffuser it should be cleaned periodically.
Abrasive cleaners, scouring cleaners and acidic cleaners under any circumstances. Avoid contact with all solvents must not be used
(including chlorinated solvents, ketones or acetones as these may result in surface deterioration or etching). Also avoid contact with any
harsh household chemicals such as oven cleaners, drain cleaners, rust removers, paint strippers and toilet bowl cleaners, bar keepers friend
or Brasso.
Important Technical Data:
Minimum operating pressure 0.3 bar Maximum hot water temperature 70°C*
Maximum operating pressure 5.5 bar* Recommended hot water temperature 46°C
*If these temperatures or pressures are exceeded, even for short periods, damage can result.
CDA taps are either WRAS approved or manufactured in accordance with recognised European standards. Please ensure that your
Kitchen mixer is fitted in accordance with Local Water Byelaws.
These installation guidelines have been prepared for your direction and you must exercise due care at all times. We do not accept
responsibility for problems that may occur through improper installation. Whilst assembling the tap take care not to accidentally loosen any
screwed assemblies.
Installation Preparation:
Before installing the new mixer it is essential that you thoroughly flush through the supply pipes in order to remove any remaining solder,
swarf or impurities from your system. Failure to carry out this simple procedure could cause problems or damage to the workings of the
mixertap.
We strongly recommend installing particle filter strainers and isolation valves to both the hot and cold feed pipes in an accessible position.
This will help to prevent premature failure of the valves and ease any future maintenance.
All parts should be removed from their packaging and inspected for any transport damage prior to installation.
Shut off your water heating system and ensure that your mains stopcock is closed. Open the lowest hot and cold taps in the house and
allow the water to run until the cold-water storage tank and pipes are fully empty. Please note, the hot water storage cylinder (if applicable)
will always remain full.
This mixertap requires a 35mm∅ tap hole, if replacing an existing tap, remove the tap & clean the end of the feed pipes using wire wool the
tap hole area should be free from dirt and sealant.
Loosely position the tap and tail pipes to check if any alteration to the existing pipework is required, if this is the case do this now.
Produkt Specifikationer
| Mærke: | CDA |
| Kategori: | Vandhane |
| Model: | TT25ANI |
Har du brug for hjælp?
Hvis du har brug for hjælp til CDA TT25ANI stil et spørgsmål nedenfor, og andre brugere vil svare dig
Vandhane CDA Manualer
15 Marts 2024
13 Januar 2024
10 December 2023
7 Oktober 2023
13 August 2023
29 Maj 2023
10 Maj 2023
31 Marts 2023
3 Februar 2023
7 Januar 2023
Vandhane Manualer
- Vandhane Ikea
- Vandhane Siemens
- Vandhane Concept
- Vandhane Teka
- Vandhane Ernesto
- Vandhane Etna
- Vandhane Hansgrohe
- Vandhane Smeg
- Vandhane Miomare
- Vandhane KitchenAid
- Vandhane Svedbergs
- Vandhane Caple
- Vandhane Franke
- Vandhane Brita
- Vandhane Elba
- Vandhane Damixa
- Vandhane Oras
- Vandhane Grohe
- Vandhane Netatmo
- Vandhane Inventum
- Vandhane Mueller
- Vandhane Oliveri
- Vandhane Delta
- Vandhane Elkay
- Vandhane Moen
- Vandhane Suprema
- Vandhane American Standard
- Vandhane Puretec
- Vandhane Sussex
- Vandhane Zurn
- Vandhane Karran
- Vandhane Jacuzzi
- Vandhane ProFlo
Nyeste Vandhane Manualer
11 December 2024
11 December 2024
11 December 2024
11 December 2024
11 December 2024
11 December 2024
11 December 2024
3 December 2024
3 December 2024
2 December 2024