Chief HB29S Manual


Læs nedenfor 📖 manual på dansk for Chief HB29S (2 sider) i kategorien Flad panel støtte. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
I N S TA L L A T I O N I N S T R U C T I O N S
Continued...
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F: 877.894.6918 / 952.894.6918
8803-000120
©2008 Milestone AV Technologies
9/30/08
MODEL: HB-29S Custom Projector Bracket
Unpack carton and verify contents. If any listed parts are miss by calling ing, immediately contact a Chief Customer Service representative
1-800-582-6480.
PARTS
Figure 1:
INSTALLATION
WARNING:
IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL INJURY! All components must be securely fastened
to each other and to the ceiling, and the ceiling must be capable of supporting five times the total weight of the installation.
CAUTION:
This HB bracket mount is designed to support the weight of only one projector per mount. DO NOT attempt to attach more
than one projector to the same mount!
1. Place custom HB bracket on underside of the projector and line up the four screw holes on the bracket with the four corresponding holes
on the projector. Ensure that the side hooks open towards back of the projector. (See Figure 1)
2. Attach HB bracket to projector using four M6-1.00 x 16mm Phillips machine screws through washers and spacers into projector. Install
each screw partially to make sure all screws are aligned correctly before tightening the screws to the bracket. (See Figure 1)
(1) BRACKET, Custom HB (4) NUT, Flange, Hex, 5/16-18
(4) SCREW, Phillips Machine, M6-1.00 x
16mm
(4) FLAT WASHER, Standard Machine
Screw 6mm
1
2
x 4
Toward front
of projector


Produkt Specifikationer

Mærke: Chief
Kategori: Flad panel støtte
Model: HB29S

Har du brug for hjælp?

Hvis du har brug for hjælp til Chief HB29S stil et spørgsmål nedenfor, og andre brugere vil svare dig




Flad panel støtte Chief Manualer

Chief

Chief PWCU Manual

15 Januar 2025
Chief

Chief MIWRFUB Manual

15 Januar 2025
Chief

Chief TILD1X5NE1-M Manual

15 Januar 2025
Chief

Chief MWRIWUB Manual

15 Januar 2025
Chief

Chief TILD1X4NE1-R Manual

15 Januar 2025
Chief

Chief TILD1X3NE1-L Manual

15 Januar 2025
Chief

Chief TILD1X3NE1-R Manual

15 Januar 2025
Chief

Chief KPP110B Manual

15 Januar 2025
Chief

Chief TILD1X4NE1-L Manual

15 Januar 2025
Chief

Chief TILD1X3NE1-M Manual

15 Januar 2025

Flad panel støtte Manualer

Nyeste Flad panel støtte Manualer