Continental Edison CECWC12BS Manual


Læs nedenfor 📖 manual på dansk for Continental Edison CECWC12BS (2 sider) i kategorien Wijnklimaatkast. Denne guide var nyttig for 11 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
CONSIDER BEFORE EACH USE
1. Choose the correct ladder or work platform for the speci c task.
If unsure, consult the factory.
2. Metal ladder stands and work platforms conduct electricity. Keep away from
energized electrical circuits. Contact could cause electrocution.
3. Use in accordance with instructions and warnings provided.
4. Common sense and good judgment must be used at all times.
Do not use
• If in poor health
• If subject to fainting.
• If using drugs (including prescribed medication which could affect equilibrium)
or alcohol.
5. Wear appropriate footwear. High heel shoes and shoes with slippery soles
are dangerous.
INSPECT BEFORE EACH USE
1. Inspect thoroughly for missing, damaged or worn components.
2. Inspect for loose fasteners.
3. See that all caster assemblies including lock steps operate freely
(see “MAINTENANCE”).
Remove damaged or malfunctioning (units which do not roll and lock properly or
do not sit square and level) ladders and work platforms from service. Do not make
temporary repairs.
PROPER USE OF MOBILE LADDER STANDS AND MOBILE
WORK PLATFORMS
GENERAL SAFETY
1. Users are cautioned to take proper safety measures when a ladder or work platform
is used in areas where electrical lines exist. Prevent any contact or possible contact
with an energized uninsulated circuit or conductor in order to avoid electric shock,
short circuit and serious injury.
2. Do not use on uneven or sloping surfaces.
3. Do not overload - observed posted capacity.
4. Do not move/roll an occupied ladder or platform. On lockstep ladder, make
sure ladder is in the climbing position (front legs secured rmly to the oor
before climbing).
5. Shifting weight on a ladder equipped with spring-loaded casters alters spring
compression, causing light “ oat” feeling. User should be aware of this characteristic
in order to expect and compensate for it.
6. Handrails (if equipped) should be used when climbing or descending the ladder.
7. On 59º slope ladder, always face the ladder when climbing or descending. Step
slope is too steep to face outward. 50º slope ladders allow forward facing descent.
8. Keep body centered on ladder or work platform. Avoid shifting weight suddenly
and do not push, pull, lean over, etc. in any way that may cause ladder legs or casters
to lift off oor.
9. Do not over-reach. Keep unit close to the work. If necessary, descend and relocate
the unit to prevent overreaching.
10. Do not place any object on the top step or platform in order to gain additional
height.
11. Do not climb on rails.
12. Do not store materials or equipment on steps.
13. Do not enter or exit any step of the unit to/from another elevated surface unless
the unit has been positively secured against movement.
14. Do not place an occupied ladder or work platform in front of a door unless the
door is secured in an open position, locked, or attended.
15. Mobile ladder stands are designed for use by one (1) person only.
MAINTENANCE
Periodic* inspection and maintenance should include the following:
1. Inspect ladder periodically for wear, damage and corrosion e.g., rust, worn or
broken treads, broken welds, bent parts and frame members, etc.
2. Ch g - un shoul str t and square and ho d s l on the eck ali nment it d be aigh s ul it leve oor.
3. Ladders equipped with spring-loaded casters:
• Remove and inspect all casters and springs.
• Look for excessive or uneven wear on caster stems.
• Be sure wheel is round and rotates freely in fork.
• Check caster sleeve on ladder base making sure
sleeve is straight.
• Check inside of caster sleeve and remove any foreign material.
• Hole in top of caster sleeve should be round. If not,
caster assembly may not operate properly.
• Clean caster stems and springs. Apply a thin coat of oil.
• Replace caster assembly checking to assure smooth operation.
NOTE: Replace any broken, worn or missing casters or springs. In order to provide
the proper replacement parts, advise factory of model number; or if unknown, the
number of steps, width of steps and if ladder has handrails or not. Ladder may not
function properly and may even be dangerous if wrong casters and/or springs are
installed.


Produkt Specifikationer

Mærke: Continental Edison
Kategori: Wijnklimaatkast
Model: CECWC12BS

Har du brug for hjælp?

Hvis du har brug for hjælp til Continental Edison CECWC12BS stil et spørgsmål nedenfor, og andre brugere vil svare dig




Wijnklimaatkast Continental Edison Manualer

Wijnklimaatkast Manualer

Nyeste Wijnklimaatkast Manualer

Boretti

Boretti BPWKN88 Manual

17 September 2024
Candy

Candy CWC 021 MK Manual

16 September 2024
Liebherr

Liebherr WTes 5872-22 Manual

15 September 2024
Danby

Danby DWC172BL Manual

13 September 2024
Thermex

Thermex Winemex Black Manual

11 September 2024
Nabo

Nabo WS 9636 Manual

11 September 2024
Nabo

Nabo WS 4314 Manual

11 September 2024
Igloo

Igloo IGLWC18WDSS Manual

6 September 2024
Igloo

Igloo IGLWC12WDSS Manual

6 September 2024