DeWalt DCB1800 Manual

DeWalt Generator DCB1800

Læs nedenfor 📖 manual på dansk for DeWalt DCB1800 (4 sider) i kategorien Generator. Denne guide var nyttig for 15 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/4

Device does not operate with portable power station/charger

• Consult manufacturer of device for use with modiﬁed sine wave.

Portable power station/charger does not charge

• Check the connection of the extension cord on both ends; be sure female end is securely plugged into Charger-In plug of the portable power station/charger.

• Check that electricity is ﬂowing to extension cord using another device (light, tool, etc.).

• Remove batteries and reinsert fully into the tool.

POWER-OUT MODE

How to Turn on Power-Out mode

1) Firmly install 4 charged 20V MAX* batteries

2) Unplug extension cord from Charger-In, if necessary

3) Starting with your tool or device off, plug into Power-Out receptacle

4) Press and Release On/Off button

5) Red side panel LED will illuminate solid red when running properly

CHARGER-IN MODE

How To Turn on Charger

1) Plug In female end of extension cord (sold separately) to Charger-In Plug

2) Plug male end of extension cord into wall

3) Fully insert 20V MAX* battery(ies) to charge

How to read Front Panel LED indicators in Power-Out Mode

• Slow ﬂashing yellow (and 10 beeps of 1 second) = low battery

• Solid yellow (and 10 beeps of 1 second) = hot battery

• 4 yellow scrolling (and two beeps every 30 seconds) = approaching low battery

• 2 yellow ﬂashing, alternating (and 10 beeps of 1 second) = system fault

WARNING: TO REDUCE THE RISK OF INJURY, USER MUST READ

INSTRUCTION MANUAL BEFORE OPERATING PRODUCT.

QUICK START GUIDE IS NOT A SUBSTITUTE FOR INSTRUCTION MANUAL.

DO NOT EXPOSE TO WATER, RAIN, SNOW, OR ANY TYPE OF MOISTURE.

DCB1800 QUICK START GUIDE

How to read Front Panel LED

indicators in Charger-In Mode

• Slow Flashing Red = battery(ies) charging

• Solid Red = battery(ies) charged

• Quick Flashing Red = hot/cold delay

BASIC TROUBLESHOOTING

Portable power station/charger does not operate or turn ON when ON/OFF button is pressed

• Check that all four batteries have sufﬁcient charge (at least 1 green LED light, ideally 2 or 3 green LED lights on battery fuel gauge, if equipped).

• Remove batteries and reinsert fully into the tool.