Digital Watchdog DWC-C232D Manual


Læs nedenfor 📖 manual på dansk for Digital Watchdog DWC-C232D (2 sider) i kategorien Overvågningskamera. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Ad
j
ustment of Back Focus
C232D
About this manaul
Adjustment of DC / VIDEO lenses
INSTRUCTION MANUAL
Before installing and using the camera, please read this manual
carefully. Be sure to keep it handy for future reference.
TROUBLESHOOTING
Do not open or modify
Do not open the cabinet exet during maintenance and
installation, as it may be dangerous and cause damages.
Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get insdie the camera. It could cause fire, short-circuits or
damages.
Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.
Install away from electric or magnetic fields.
Protect from humidity and dust.
Protech from high temperature
Be careful when installing colose to the ceiling , in a kitchen
or boiler room, as the temperature may raise to high levels.
Cleaning
Dirt can be removed from the cabinet only by wiping it
with a soft cloth moistened with a soft detergent solution.
Mounting Surface
The mounting surface material must be strong enough to
secure the camera.
PRECAUTIONS CAMERA LENS SETTINGS
Focus adjustment
1. Please check the lenes is C mount or CS mount.
To use C mount lens, please fix the lens into front camera after mounting included C ring to lens.
To use CS mount lens, please fix the lens directly into front camera without C ring.
2. To adjust the focus, slide the focus lever on the side of the front camera.
In case of the vari focal lens, adjust the focus lever where the lens is focused in fosing postion "wide" and "tele"
3. Please tighten the focus lever after the adjustment in order to prevent being out of focus.
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support: 1-866-446-3595 / 813-888-9555
Adjustment
of
DC
/
VIDEO
lenses
To adjust a lens with automatic iris (DC driven or video driven) to the camera, please proceed as follows:
2.
Slowly turn the Level potentiometer back until the monitor picture appears to be perfect and is not too bright anymore.
Then turn the potentiometer back to the right (in direction ”H”) just a little bit.
3.
Check the lens performance by using the camera under different and/or changing light conditions.
1.
Turn the Level potentiometer to the max. position H (turn right).
The monitor picture then appears to be too bright.
Before installing and using the camera, please read this manual
carefully. Be sure to keep it handy for future reference.
TROUBLESHOOTING
Before sending the camera out for repair, check the items
below. If the problem persists after checking these items,
contact your service center.
If no image appears
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
Do not open or modify
Do not open the cabinet exet during maintenance and
installation, as it may be dangerous and cause damages.
Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get insdie the camera. It could cause fire, short-circuits or
damages.
Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.
Install away from electric or magnetic fields.
Protect from humidity and dust.
Protech from high temperature
Be careful when installing colose to the ceiling , in a kitchen
or boiler room, as the temperature may raise to high levels.
Cleaning
Dirt can be removed from the cabinet only by wiping it
with a soft cloth moistened with a soft detergent solution.
Mounting Surface
The mounting surface material must be strong enough to
secure the camera.
PRECAUTIONS CAMERA LENS SETTINGS
Focus adjustment
1. Please check the lenes is C mount or CS mount.
To use C mount lens, please fix the lens into front camera after mounting included C ring to lens.
To use CS mount lens, please fix the lens directly into front camera without C ring.
2. To adjust the focus, slide the focus lever on the side of the front camera.
In case of the vari focal lens, adjust the focus lever where the lens is focused in fosing postion "wide" and "tele"
3. Please tighten the focus lever after the adjustment in order to prevent being out of focus.
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support: 1-866-446-3595 / 813-888-9555


Produkt Specifikationer

Mærke: Digital Watchdog
Kategori: Overvågningskamera
Model: DWC-C232D

Har du brug for hjælp?

Hvis du har brug for hjælp til Digital Watchdog DWC-C232D stil et spørgsmål nedenfor, og andre brugere vil svare dig




Overvågningskamera Digital Watchdog Manualer

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer

I-PRO

I-PRO WV-S2536LA Manual

17 December 2024
I-PRO

I-PRO WV-S2536LTA Manual

17 December 2024
I-PRO

I-PRO WV-S25500-F3L Manual

17 December 2024
I-PRO

I-PRO WV-S25500-F6L Manual

17 December 2024
I-PRO

I-PRO WV-S25600-V2L Manual

17 December 2024
I-PRO

I-PRO WV-S25500-V3L Manual

17 December 2024
I-PRO

I-PRO WV-S25500-V3LN1 Manual

17 December 2024
I-PRO

I-PRO WV-S25600-V2LG Manual

17 December 2024
I-PRO

I-PRO WV-S25700-V2LG Manual

17 December 2024
I-PRO

I-PRO WV-S25700-V2L Manual

17 December 2024