Edimax ES-3116P Manual

Edimax Skifte ES-3116P

Læs nedenfor 📖 manual på dansk for Edimax ES-3116P (1 sider) i kategorien Skifte. Denne guide var nyttig for 14 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
(2) LED
Table 1-1 LED description
Power is supplied
No power
LED Color Status Description
PWR
(Power) Green Lit
Off
A valid link is established
No link is established
Data packets received
Off
LNK/ACT
(Link/Activity)
SPEED
(10/100M)
Green
Yellow
Lit
Off
Lit This port run at 100Mbps
This port run at 10Mbps
Flash
5/8/16 Port Fast Ethernet Switch
2
2Installation
1. Operating Environment
This switching hub must be installed and operated within the limits of
specified operating temperature (32-1310F) and humidity (10-95%
Noncondensing). Do not place objects on top of the unit. Do not obstruct any
vents at the sides of the unit. Do not position the unit near any heating source
such as heater, radiator, or direct exposure to sun. Prevent entering of water
and moisture into the unit. If necessary, use dehumidifier to reduce humidity.
2. Connecting to network devices
The RJ-45 ports on the switch support Auto-MDI/MDI-X function which
allow using straight-through or cross-over type cables to connect this switch
to workstation or hub.
Connect one end of the network cable to the RJ-45 port on the rear panel, and
connect the other end of the network cable to the RJ-45 port on the network
device. Follow the same procedure to connect all the RJ-45 ports of the
switch. The UTP network cables must comply with EIA/TIA 568
specifications and Category 5 standard for 100Mbps data transmission.
Maximum length, using UTP cable, between the switch and connected device
is 100 meters (300ft). Once the network cable is connected to both ends and
the attached network device is powered on, the green LNK/ACT LED should
be lit.
3. Connecting the power
Connect the output end of the power
adapter to the power connector on the
rear panel of the unit. Connect the
power adapter to the power outlet.
The green Power LED on the front
panel should be lit. Figure 2-1 Connect the AC power adapter
DC Power
AC Power
External Power Adapter
3
3Trouble-shooting
1. Power LED is not lit
zCheck if the power cord is properly connected to the external power
adapter and the power outlet. Make sure the DC power jack is firmly
plugged into the power socket of the switch.
2. Link/Activity is not lit when connect to 100Mbps device
zCheck the power switch of the network device attached to the switch;
make sure it is turned ON.
zCheck the network cable; make sure it is properly connected to the
switch and the network device.
zCheck the network cable; make sure the UTP cables comply with
EIA/TIA 568 and Category 5 specification.
[!] Contact your dealer if problem persist.
1
1Physical Description
(1) Panel
Figure 1-1 Panel description
Power LED
LED Panel
RJ45 Connectors
Power Connector
POWER
100M
LNK/ACT
Fast Ethernet Switch
41 52 63 7 8
10/100M LED
Link/Activity LED
8-Port 10/100Mbps
LED Panel
Power LED 100/10Mbps LED
Link/Activity LED
POWE R
10 0M
LNK/ACT
Fast Ethernet Switch 12345
RJ45 Connectors
Power Connector
5-Port 10/100Mbps
POWER
100M
LN K/ ACT
3 112 101 94 125 136 147 158 16
Fast Ethernet Switch
LED Panel
RJ45 Connectors
Power Connector
100/10Mbps
Link/Activity LED
Power LED
16-Port 10/100Mbps
5-Port
8-Port
16-Port


Produkt Specifikationer

Mærke: Edimax
Kategori: Skifte
Model: ES-3116P

Har du brug for hjælp?

Hvis du har brug for hjælp til Edimax ES-3116P stil et spørgsmål nedenfor, og andre brugere vil svare dig




Skifte Edimax Manualer

Edimax

Edimax IGS-1105P Manual

4 Oktober 2024
Edimax

Edimax ES-1008P Manual

26 September 2024
Edimax

Edimax GS-5008E Manual

30 August 2024
Edimax

Edimax EK-08RE Manual

5 August 2024
Edimax

Edimax EK-PSK4 Manual

3 August 2024
Edimax

Edimax ES-5224RM+ Manual

2 August 2024
Edimax

Edimax GS-1008PL Manual

1 August 2024

Skifte Manualer

Nyeste Skifte Manualer

Powerfix

Powerfix PSSS 2 A1 Manual

14 Januar 2025
D-Link

D-Link DES-1024D Manual

13 Januar 2025
TRENDnet

TRENDnet TEG-S5g Manual

13 Januar 2025
INOGENI

INOGENI CAM230 Manual

13 Januar 2025
Schneider

Schneider CCT15225 Manual

13 Januar 2025
Luxul

Luxul XMS-5248P Manual

13 Januar 2025
Luxul

Luxul AMS-2624P Manual

13 Januar 2025
Luxul

Luxul XGS-1005 Manual

13 Januar 2025
Luxul

Luxul AGS-1008M Manual

13 Januar 2025