Electro Harmonix Bad Stone Manual


Læs nedenfor 📖 manual på dansk for Electro Harmonix Bad Stone (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
1
BAD STONE
Congratulations on your purchase of the Bad Stone reincarnation of the highly sought , a
after Electro-Harmonix classic from the ‘70s, now in a nano package. The Bad Stone is a
six stage phase shifter with variable rate, feedback, and a manual shift control that allows
you freeze the phase and create new sonic landscapes. True bypass switching ensures to
your tone won’t be colored when the pedal is bypassed.
CONTROLS
RATE Knob Controls the speed by setting the frequency of the Bad Stone’s modulation
internal low frequency oscillator (LFO). The speed ranges from 0.05Hz to 32Hz. (Note:
The original Bad Stone’s LFO frequency range was 0.2Hz to 32Hz. We felt that altering the
original design to allow for slower phasing, thus making this pedal not a 100% true
reissue, made for a better overall product This control is disabled when the .)
AUTO/MANUAL toggle switch is set to MANUAL mode.
FEEDBACK Knob Controls the amount of signal fed back from the output of the phase
shifter circuit into the input of the phase shifter circuit. As you turn the feedback control
up, the phase shift effect will sound more pronounced and even sound resonant or peaky “ ”
at high settings.
MANUAL SHIFT Knob Sweeps through the phase creating a sort of shifter’s range,
“cocked wah” sound. For maximum effect, make sure the FEEDBACK knob is in its full CW
position. This knob is only active when the AUTO/MANUAL toggle switch is set to MANUAL
mode.
AUTO/MANUAL Switch In AUTO mode the Bad Stone’s LFO modulates the phase
shifter. In MANUAL mode the LFO is disconnected and the MANUAL SHIFT knob sweeps
through the full range of the phase shifter.
INPUT Jack This ¼” jack is the audio input of the Bad Stone. The input impedance is
95kΩ.
AMP Jack e audio output of the Bad Stone. The output impedance is This ¼” jack is th
4.7k Ω.
9V Power Jack The Bad Stone operates with a standard 9V battery or an optional 9VDC
AC Adaptor capable of delivering at least 25mA to the 9V power jack, such as the
EHX9.6DC-200. The AC Adapter must have a center negative plug. The battery may be
left in or taken out when using an AC Adapto The Bad Stone has a current draw of mA r. 18
at 9VDC.
CHANGING THE BATTERY
To change the 9V battery, you must remove the 4 screws on the bottom of th Bad Stone.e
Once the screws are removed, you can take the bottom plate and change the battery. off
Please do not touch the circuit board while the bottom plate is off for risk damaging a of
component.


Produkt Specifikationer

Mærke: Electro Harmonix
Kategori: Ikke kategoriseret
Model: Bad Stone

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Bad Stone stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Electro Harmonix Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Koenic

Koenic KVRWD 21624 Manual

24 December 2024
Koenic

Koenic KAP 2523 Manual

24 December 2024
Koenic

Koenic KWC 13725 Manual

24 December 2024
Koenic

Koenic KAF 2110 W Manual

24 December 2024
Philips

Philips HD9921 Manual

24 December 2024
Philips

Philips Senseo HD7008 Manual

24 December 2024
Onkyo

Onkyo IRK1804C Manual

24 December 2024
Onkyo

Onkyo IRK1553D Manual

24 December 2024
True

True VC1-0A-35 Manual

24 December 2024
Smeg

Smeg KIT6PX Manual

23 December 2024