Electro Harmonix Bass Mono Synth Manual


Læs nedenfor 📖 manual på dansk for Electro Harmonix Bass Mono Synth (8 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 4 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/8
BASS MONO SYNTH
Congratulations on your purchase of the Electro-Harmonix Bass Mono Synth The .
Bass Mono Synth allows you to transform your bass guitar into one of eleven
different synthesizers, from vintage synth emulations, to thick stacked voices, to
deep pulsing sounds for an array of sonic landscapes and textures. The Bass Mono
Synth was designed to work on your bass guitar without any modifications or
special pickups. Plug in your bass and immediately join the synth race!
WARNING: Your Bass M S comes equipped with an Electro-Harmonix 9.6DC-ono ynth
200BI power supply (same as used by Boss® & Ibanez®: 9.6 Volts DC 200mA). The Bass
M S requires 125 at 9VDC with a center negative plug. Using the wrong ono ynth mA
adapter or a plug with the wrong polarity may damage your Bass M S and void ono ynth
the warranty.
GETTING STARTED
Connect the supplied power adapter to the 9V power jack. Plug your instrument
into the INPUT jack. Connect your amp or other effects pedals to the SYNTH
OUTPUT jack. Set the DRY knob to minimum (fully counterclockwise) and set the
other top row knob TYPE and step on the BYPASS s to 12 o’clock. Select a
footswitch to turn on the LED. Play your bass and adjust controls to your liking.
ONE NOTE AT A TIME
The Bass Mono Synth is a multi-oscillator monophonic instrument. It synthesizes
one note at a time per oscillator. The oscillators have been pre-tuned for each
synth type only the synth type SPECTRE allows for user control over an oscillator.
Additionally it can handle only one note from your bass at a time. It does not work
properly when chords or two note intervals are played. The Bass Mono Synth
behaves unpredictably and erratically when it receives more than one note at the
INPUT jack.
SYNTH TYPE DESCRIPTIONS
1. LASER deep, pulsating synth.
CTRL: this knob adjusts the attack and decay times of the filter envelope.
As CTRL is turned clockwise both the attack and decay times slow down.
EXP: the expression pedal controls the cutoff frequency of the filter and
sets the jump-off frequency for the envelope sweep. As the pedal travels
from heel to toe the filter frequency goes from bass to treble.
2. X-FADE multi VCO synth with some dry signal added to the filter sweep.
SENS: sets filter sweep envelope follower depth and synth volume.
CTRL: adjusts the decay time of the filter envelope.


Produkt Specifikationer

Mærke: Electro Harmonix
Kategori: Ikke kategoriseret
Model: Bass Mono Synth

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Bass Mono Synth stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Electro Harmonix Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Koenic

Koenic KVRWD 21624 Manual

24 December 2024
Koenic

Koenic KAP 2523 Manual

24 December 2024
Koenic

Koenic KWC 13725 Manual

24 December 2024
Koenic

Koenic KAF 2110 W Manual

24 December 2024
Philips

Philips HD9921 Manual

24 December 2024
Philips

Philips Senseo HD7008 Manual

24 December 2024
Onkyo

Onkyo IRK1804C Manual

24 December 2024
Onkyo

Onkyo IRK1553D Manual

24 December 2024
True

True VC1-0A-35 Manual

24 December 2024
Smeg

Smeg KIT6PX Manual

23 December 2024