Electro Harmonix Operation Overlord Manual


Læs nedenfor 📖 manual på dansk for Electro Harmonix Operation Overlord (4 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
1
OPERATION OVERLORD
Stereo Multi-Instrumental Overdrive
Congratulations on your purchase of the OPERATION OVERLORD, an advanced,
full-featured stereo overdrive and distortion pedal. With the OVERLORD’s broad
range of options and controls you can dial in great drive sounds for keyboards,
synths, guitars, basses, and more. Active 3-band EQ controls, footswitchable
BOOST mode, and a dry blend provide versatility for different tones and
instruments. The OVERLORD also features two independent distortion channels
for use with stereo setups. Whatever your rig, use the OVERLORD to dial in your
tonal inspiration.
- MODES OF OPERATION: NORMAL VS. BOOST -
The OVERLORD operates in two modes: NORMAL and BOOST. The NORMAL
mode uses three amp-like JFET gain stages for low to medium gain sounds.
When in NORMAL mode, use the GAIN knob to control the amount of overdrive.
The BOOST mode adds a classic pedal-style overdrive circuit before the JFET
stages to increase overall distortion. BOOST is engaged with the BOOST
Footswitch and is active when the blue LED is lit. In BOOST mode, both the
GAIN and BOOST knobs are active, and the BOOST knob controls how much
additional gain from the BOOST circuit is fed into the main JFET circuit.
- USING BOOST MODE AS AN INDEPENDENT PEDAL
The BOOST circuit can also be configured to operate on its own, OVERLORD’s
without the NORMAL mode’s JFET gain stages. To enable this, remove the 4
screws on the bottom of the OVERLORD and locate the slide switch at the
bottom of the PCB. Being careful not to touch any components, slide the switch
in the direction labeled “BOOST INDEPENDENT ”.
When independent BOOST mode is enabled, the BOOST circuit is active by itself
when the BOOST LED is lit and the BYPASS (red) LED is off. In this setting, the
GAIN and BOOST knobs are disabled. All other controls function normally. When
NORMAL mode is engaged (red LED lit), the pedal functions as usual, with the
BOOST mode feeding into the JFET gain stages.


Produkt Specifikationer

Mærke: Electro Harmonix
Kategori: Ikke kategoriseret
Model: Operation Overlord

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Operation Overlord stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Electro Harmonix Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Philips

Philips HD9921 Manual

24 December 2024
Philips

Philips Senseo HD7008 Manual

24 December 2024
Onkyo

Onkyo IRK1804C Manual

24 December 2024
Onkyo

Onkyo IRK1553D Manual

24 December 2024
True

True VC1-0A-35 Manual

24 December 2024
Smeg

Smeg KIT6PX Manual

23 December 2024
Smeg

Smeg KIT6CX Manual

23 December 2024
Smeg

Smeg GTA-6 Manual

23 December 2024