Electro Harmonix Pitch Fork Manual


Læs nedenfor 📖 manual på dansk for Electro Harmonix Pitch Fork (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Pitch Fork
POLYPHONIC PITCH-SHIFTER/HARMONY PEDAL
Congratulations on your purchase of the Electro-Harmonix , a compact, Pitch Fork
battery powered, polyphonic pitch-shifter/harmony pedal. The transposes Pitch Fork
the pitch of your instrument over a range of up to +/- 3 octaves. Three different
available pitch-shifting modes allow the pitch to be transposed up, down or both
simultaneously in Dual mode. The pitch shift amount can be set to a fixed interval or
continuously varied by an expression pedal control voltage. Tor he Pitch Fork’s
footswitch features two different modes of operation: Latch and Momentary.
Momentary allows rapid toggling between effect and bypass for quick blasts of pitch
bending The BLEND knob is a wet/dry control allowing you create the perfect mix . to
of your dry and transposed signals.
WARNING: Your PITCH FORK comes equipped with an Electro-Harmonix 9.6DC-200BI power
supply (same as used by Boss® & Ibanez®: 9.6 Volts DC 200mA). The PITCH FORK requires
30mA at 9VDC with a center negative plug or runs off a 9Volt battery. Using the wrong adaptor
or a plug with the wrong polarity may damage your PITCH FORK and void the warranty.
GETTING STARTED
Connect the output plug of the supplied power adaptor to the 9V power jack Plug .
your strument into the INPUT jack; connect your amp to the OUTPUT jack Set the in .
toggle switch to UP arrow and press the LATCH button so it is down. Turn BLEND
fully clockwise and set SHIFT to 1, as in 1 octave up. Press the footswitch until the
LED lights up. You will hear all your notes shifted up 1 octave. Connect an optional
expression pedal to continuously y the pitch from unity up to 1 octave. var
Press the LATCH button it is up. The footswitch now has a momentary action: so
when pressed the effect activates and pitch is shifted; when released, the effect is
bypassed Connect an expression pedal to control glissando rate of the momentary .
footswitch. If the EXP jack is vacant, pitch will change at the default glissando rate of
60ms (this is user adjustable).
BLEND KNOB
The BLEND knob mixes between the untreated, analog dry signal and the effected
signal. At BLEND’s full clockwise position, the output is 100% wet.
SHIFT KNOB
The SHIFT knob selec the maximum interval of chromatic transposition. The chart ts
below shows how the pitch will be shifted relative to the original pitch.
D
m2
M2
M3
P4
P5
m7
1
2
3
Detune
Minor
2nd
Major
2nd
Major
3rd
Perfect
4th
Perfect
5th
M r ino
7th
1
Oct
2
Oct
3
Oct
MODE TOGGLE SWITCH
The MODE toggle switch selects whether the pitch is shifted up, down or both
simultaneously relative to the root. Dual mode outputs two pitch-shifted signals One .
of the shifted signals follows the SHIFT knob as if in UP mode. The other shifted
signal creates a musically useful harmony according to the SHIFT knob setting.
DUAL mode SHIFT knob Settings:
D
m2
M2
M3
P4
P5
M6
m7
1
2
3
Detune
Deep
Detune
M2
up
+
M6
up
M3
up
+
P5
up
P4
up
+
P5
down
P5
up
+
1 Oct
down
M6
up
+
P5
down
m7
up
+
M6
up
1 Oct
up
+
1 Oct
down
2 Oct
up
+
1 Oct
down
3 Oct
up
+
1 Oct
down
LATCH BUTTON
The LATCH button selects Latch or Momentary mode This affects how the footswitch .
and EXP jack input behave. When the LATCH button is down, Latch mode is enabled.
The footswitch toggles between effect and bypass each time you press and release
the footswitch; the EXP input continuously varies pitch. When the LATCH button is in
the up position, Momentary mode is selected. The effect is only on while the
footswitch is held down, otherwise the Pitch Fork is bypassed; the EXP input varies
the glissando rate of the momentary footswitch.
BYPASS FOOTSWITCH & STATUS LED
The footswitch toggles between effect on and buffered bypass. In Latch mode, each
press and release of the footswitch toggles between effect and bypass modes. In
Momentary mode, when the footswitch is held down, the effect is on, when the
footswitch is released, the Pitch Fork enters bypass. The status LED lights when in
Effect mode.
EXP JACK
EXPression input jack accepts a TRS expression pedal connector a T -Sleeve 0- or ip 5V
control voltage input expression pedal should ideally use a 10k potentiometer . The
with linear rather than audio taper. It must have the wiper connected to TIP and toe-
down connected to RING. Pedals made by some manufacturers do not conform to
this convention, and would need a special cable to swap RING and TIP. Some
suggested Expression Pedals: EHX Expression Pedal, M-Audio® -P, MoogEX ® -2 EP &
EP-3, Roland® -5 or BossEV ® -500L. FV
LATCH MODE - the Expression/CV input controls pitch shift amount,
ranging from unity, or no pitch shift, in the heel position to the interval set
by the SHIFT knob for the toe position. Pitch varies continuously from heel
to toe in all settings.
MOMENTARY MODE - the Expression/CV put controls glissando rate for in
the Pitch Fork’s footswitch. When the bypass footswitch is pressed, the Pitch
Fork jumps from bypass to the pitch shift interval set by the SHIFT knob.
The amount of time it takes to reach the interval setting is the SHIFT knob’s
glissando rate When the footswitch is released, pitch will return to unity by .
the same rate. When your expression pedal is heel-down the rate is 4ms, in


Produkt Specifikationer

Mærke: Electro Harmonix
Kategori: Ikke kategoriseret
Model: Pitch Fork

Har du brug for hjælp?

Hvis du har brug for hjælp til Electro Harmonix Pitch Fork stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Electro Harmonix Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Stamos

Stamos S-PLASMA 60U Manual

23 November 2024
Velbus

Velbus VMBPIRO-W-20 Manual

23 November 2024
Honor

Honor 90 Pro Manual

23 November 2024
Honor

Honor 80 SE Manual

23 November 2024
Medela

Medela Safe & Dry Manual

22 November 2024
Jane

Jane First Potty Manual

22 November 2024
Stamos

Stamos SPT10P805 Manual

22 November 2024