Electrolux EPWD257UTT Manual


Læs nedenfor 📖 manual på dansk for Electrolux EPWD257UTT (3 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/3
P/N: A13990902 (1902)
IMPORTANT
Total weight closed drawer or IN
combination of and IN ON TOP OF
open drawer should not exceed 65 lb.
(29.5 kg).
WARNING
Failure to disconnect from power
source before stacking could
result in personal injury or even
death.
Improper installation of dryer
venting could result in personal
injury or damage to property.
To avoid back or other injury,
have more than one person move
or lift the washer or dryer.
Do not stack a dryer on top of
washer already installed on
pedestal.
2
1. If washer or dryer is new and has not been installed
yet, skip to step 4.
2. If dryer is already installed, disconnect dryer from
electrical and gas connections and exhaust venting.
On models with Steam Option, turn off cold water
supply and disconnect water supply hose to dryer.
3. If washer is already installed, disconnect washer
from electrical connection. Turn off hot and cold
water supply and disconnect hot and cold water
supply hoses from water supply outlets. Disconnect
drain hose from drain pipe.
4. Protect floor and unit with cardboard or rug and
carefully lay the appliance on its and screw LEFT
each leg completely into the base.
Prepare Appliance For Mounting
For support in the U.S. call 1-877-4ELECTROLUX (1-877-435-3287) or visit www.electroluxappliances.com. For support in Canada call 1-800-265-8352 or visit www.electroluxappliances.ca.
1Materials and Tools Needed for Installation:
NOTE
Due to higher center of gravity
of appliance on pedestals, some
side-to-side rocking is normal during
operation. Vibration can be minimized
by assuring appliance is installed
properly, including being level and
solid on all four (4) legs by following
these directions.
Installation Instructions*Electrolux 15Pedestal
Kit components:
A 2 Front brackets
B 2 Rear brackets
A
Screw Kit Components
C 14 #10 (16 x .500) screws
B
Tools needed:
Adjustable wrench Carpenter’s levelPhillips screwdriver
OR AND AND
9/16" or 14 mm
box wrench
26.5"
(67 cm)
42.5"
(108 cm)
15
"
(38 cm)
27
"
(68.5 cm)
IMPORTANT
TURN ON TO LEFT SIDE ONLY. DO NOT use open dispenser drawer of washer or dispenser
cavity as hand-hold location when tipping washer on its side. Serious damage could occur to your
washer.
LEFT SIDE RIGHT SIDE FRONT BACK
IMPORTANT
If feet are not completely screwed in,
mounting holes in appliance will not
align to mounting holes in brackets.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more
than one person move or lift the appliance.
3Prepare Pedestal Before Mounting
1. Locate pedestal to within a few inches of
its final location.
NOTE
Allow for approximately 5 in. (12.5 cm) behind the pedestal for clearance of back of washer or
dryer to the wall. Allow an additional 3/4 in. (2 cm) for water inlet on Steam Model Dryers and
additional space if venting dryer upward or downward.
2. Level the pedestal front-to-back and
side-to-side by adjusting each leveling leg.
Keep leg extension to a minimum.
3. Rock the pedestal from corner-to-corner
to check for stability. Repeat leveling and
rocking until all four (4) feet are sturdy on
the floor and pedestal is level.
4. Without turning the rubber foot, lock each
pedestal leg in place by tightening its lock
nut tight against the pedestal base.
DO NOT remove
foam!
Raise Lower
Adjustable
Wrench
Lock nut
Attach Mounting Brackets
Attach front mounting brackets
4
Attach each front bracket to outer-most set of
holes with 2 screws.
Drawer
Front brackets
from kit.
Attach rear mounting brackets
Tab A
Tab B
Each rear bracket has tabs marked “A” and
“B” and 2 arrows indicating bracket direction
when mounted on the pedestal.
Direction Indicator
Arrows
Each pedestal has slots in the rear marked “1”,
“2” and “3”.
1. Determine your appliance type (washer
or dryer).
Dryer:
Tab A into Slot 1
with arrow pointing
to back.
2. Orient rear brackets for your particular
model.
3. Attach each bracket with 2 screws through
the holes that line up on pedestal.
Slot 1
Slot 2
Slot 3
1. Turn pedestal on its side to match orientation to appliance.LEFT
2. Slide pedestal up to appliance and line up holes in mounting brackets with holes in appliance
base.
3. Attach rear and front brackets to appliance base with supplied screws into aligning holes -
one in each front bracket and two in each rear bracket.
4. Using more than one person, carefully return appliance and pedestal to upright position.
Attach Pedestal to Appliance
5
Dryer
Washer
Installing or Re-installing Appliance
6
Washer on pedestal:
Dryer on pedestal:
1. Slide washer/pedestal into place.
2. Check for levelness and rock all four (4) legs again. Repeat until level and solid.
3. Refer to Washer Installation Instructions for complete details on installing water, drain,
or electrical.
1. Slide dryer/pedestal into place.
2. Check for levelness and rock all four (4) legs again. Repeat until level and solid.
3. Refer to Dryer Installation Instructions for complete details on installing electrical, gas, or
exhaust venting.
Warranty and Registration
7
Warranty
Your pedestal is covered by a two year limited warranty. For two years from your original date of
purchase, Electrolux will repair or replace any parts of this pedestal that prove to be defective in
materials or workmanship when such appliance is installed, used, and maintained in accordance
with the provided instructions.
Exclusions
This warranty does not cover the following:
Service calls which do not involve malfunction or defects in materials or workmanship, or for
appliances not in ordinary household use or used other than in accordance with the provided
instructions.
Any Labor or in-home service costs.
Damages to the finish of appliance or home incurred during transportation or installation,
including but not limited to floors, cabinets, walls, etc.
Damages caused by: services performed by unauthorized service companies; use of parts other
than genuine Electrolux parts or parts obtained from persons other than authorized
service companies; or external causes such as abuse, misuse, inadequate power supply,
accidents, fires, or acts of God.
If You Need Service
Keep your receipt, delivery slip, or some other appropriate payment record to establish the
warranty period should service be required. Service under this warranty must be obtained by
contacting Electrolux at the addresses or phone numbers listed in your Use and Care manual.
This warranty only applies in the USA, Puerto Rico and Canada. In the USA and Puerto Rico, your
appliance is warranted by Electrolux Major Appliances North America, a division of Electrolux Home
Products, Inc. In Canada, your appliance is warranted by Electrolux Canada Corp. Electrolux
authorizes no person to change or add to any obligations under this warranty. Obligations for service
and parts under this warranty must be performed by Electrolux or an authorized service company.
Product features or specifications as described or illustrated are subject to change without notice.
Product Record
In the space below, record the date of purchase and model number of the product.
Model No.: Date of Purchase: ___________________________________________ ____________
Save these instructions and your sales receipt for future reference.
5. After retuning appliance upright, loosen each
mounting screw going into appliance base.
Allow the appliance to settle in the brackets
and retighten each mounting screw.
C
Washer:
Tab A into Slot 2
with arrow pointing
to front.


Produkt Specifikationer

Mærke: Electrolux
Kategori: Ikke kategoriseret
Model: EPWD257UTT

Har du brug for hjælp?

Hvis du har brug for hjælp til Electrolux EPWD257UTT stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Electrolux Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Smeg

Smeg KIT6PX Manual

23 December 2024
Smeg

Smeg KIT6CX Manual

23 December 2024
Smeg

Smeg GTA-6 Manual

23 December 2024