Elro SX-1B Manual


Læs nedenfor 📖 manual på dansk for Elro SX-1B (1 sider) i kategorien Dørklokke. Denne guide var nyttig for 34 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Volume
Mode Light
Volume
Mode Light
CR2032 3V
Lithium Battery
Remove
Isolation
Strip
Wireless Door Chime Kit with Flashing Light SX-1B/ SX-1R
Wireless Door Chime Kit with Flashing Light SX-1B/ SX-1R
100m
1
Push Button
• Open up the push button by pushing in the tab at the
bottom of the push with a small flat screwdriver.
• Remove the isolation strip from the battery
compartment then it is ready to use.
• When replacing the battery, ensure the battery polarity
matches the internal markings (“+” facing upwards),
then press the battery down so that it is sitting firmly
in its compartment.
2
Door Chime
• Slide open the battery compartment.
• Insert 2 x 1.5volt alkaline batteries (“AA”, UM3 & LR6
- not included) into the battery compartment, ensuring
the battery polarity matches the internal markings.
• Close the battery door then it is ready to use.
3 4
Digital Code Set Up
• Press the Push Button once, a new operation code is
generated randomly and sent to the Door Chime unit.
• The Door Chime will sound to indicate that a new
operation code is registered and memorised.
5
Push Button Installation
• Using the holes on the back of push button as a
template, mark the fixing position for the unit.
• Drill holes and fit wall plugs and secure the push button
unit to the wall with screws.
• Do not mount it on any metal surface or UPVC door
frame.
6
Door Chime Installation
Place the Door Chime unit on any table top or flat
surface, then it is ready to use.
7
Operation
• Press the button on the Push Button unit once, it sends
a wireless signal to the Door Chime and your Door
Chime unit will sound.
• Operate the Door Chime unit within the operation range,
test it before final installation.
Push Button unit
Power: 1 x 3volt Lithium battery (CR2032 - included)
Door Chime unit
Power: 2 x 1.5volt alkaline batteries (“AA”, UM3 & LR6 - not included)
Melody Selection
There are 8-melodies for selection -
1) Tubular 3-notes
2) Big Ben
3) Tubular 2-notes
4) Solo
5) Tubular Scare
6) Clarinet
7) Saxophone
8) Morning Dew
Additional Byron “SX” range products can be purchased for compatibility.
Digital Code Set Up
The Door Chime kit is equipped with an advanced random and self-learning operation coding ability therefore
no setting is needed. Read the following instructions before use.
1. First time operation:
After battery installation on the Push Button and Door Chime units, press the Push Button once and it will
generate a new operation code randomly and send a wireless signal to the Door Chime unit. The door chime
unit will sound to indicate that new operation code is registered and memorised.
2. Interference from a similar unit operating nearby:
a) Simply remove the batteries from the Push Button and Door Chime units and rest for 10 seconds, this
will erase the memory.
b) Insert the batteries into the Push Button and the Door Chime units, the door chime unit will give 2-beeps
to indicate that it is ready for the new code registration. Press the Push Button once, it will generate a
new operation code randomly and send a wireless signal to the Door Chime and it will sound to indicate
that new operation code is registered and memorised.
3. Front and back door Bell Push operation:
a) Remove the batteries from the Push Buttons (Front & Back Door) and Door Chime units and rest for 10
seconds, it will erase the memory.
b) Insert the batteries into the Push Buttons and Door Chime units; the door chime unit will give 2-beeps to
indicate that it is ready for the new code registration.
c) Press the front door Push Button once, it will generate a new operation code randomly and send a
wireless signal to the door chime unit and it will sound to indicate that a new operation code is registered
and memorised.
d) After, (within 2 minutes) press the back door Push Button once, it will generate a new operation code
randomly and send a wireless signal to the door chime unit and it will sound to indicate that new
operation code is registered and memorised. The door chime unit has the ability to memorise both
operation codes.
e) Test to ensure correct operation before final installation.
Door Chime Operation
The function (Mode) selector is located at the back of the unit; press the button to select one of the following
functions to operate the chime unit accordingly:
a) Sound and Light: The Door chime will sound as well as the Super Bright LED Light will flash to maximizing
attention
b) Light Only: The Super Bright LED Light on the Door Chime unit will flash
c) Sound Only: Door Chime unit will sound
The door chime will start operate at “Sound Only” function initially.
For repeat sound, press the button again. Holding the button in will NOT repeat the sound.
Byron No.SX1B/SX1R Size: A4 Date: 11 Oct 2007
8
Mode Light Volume
Melody Selector
Melody Selection
Press the melody selector once to select a melody as
your door chime sound. There is a total of 8 melodies
for selection:
1) Tubular 3-notes
2) Big Ben
3) Tubular 2-notes
4) Solo
Additional Byron “SX” range products can be purchased
for compatibility.
5) Tubular Scare
6) Clarinet
7) Saxophone
8) Morning Dew
Adjust the volume
Use a small flat screwdriver to adjust the sound volume.
Mode Selector
Press the mode selector to select the following functions:
a)Sound and Light b) Light Only c) Sound Only
Flashing Light Pattern
When (a) Sound + Light, OR (b) Light Only mode is selected, press the flashing light pattern button “Light” at
the back of the chime unit to select the operation in the following pattern:
1) Sound + Light mode - When the door chime sound, it will flash in following pattern:
a) Slow flashing for 5 seconds
b) Fast flashing for 5 seconds
c) Flashing intermittent, 2 seconds “On”, 1 second “Off” and 2 seconds “On” again
2) Light Only mode - The door chime will flash in following pattern without the chime sound:
a) Slow flashing for 10 seconds
b) Fast flashing for 10 seconds
c) Flashing intermittent, 2 seconds “On”, 1 second “Off” and 2 seconds “On” again for 2 times.
Important
1. Do not mount either unit close to fireplace or expose to high temperatures.
2. Do not expose the Door Chime unit to direct sunlight or moisture
3. Always use alkaline battery. Please dispose of old, defective batteries in an environmentally friendly manner
in accordance with the relevant legislation.
4. Make sure that no naked flame sources, such as lighted candles, should be placed on the unit.
5. The unit should not be exposed to dripping or splashing and no objects filled with liquids, such as vases,
should be placed on the unit.
6. Replace only with the same or equivalent type of battery that is recommended by the CAUTION:
manufacturer.
7. Make sure batteries are installed correctly as per the internal markings.CAUTON:
8. Danger of explosion if battery is incorrectly installed or replaced.CAUTION:
9. IMPORTANT: There are no serviceable parts in the units, do not attempt to repair it.
Trouble Shooting & User Hints
In case of the door chime unit does not sound, please check the followings:
a) Flat batteries in either Push Button or Door Chime units - change the batteries.
b) Wrong battery polarity in either Push Button or Door Chime units - re-insert the batteries.
c) Push Button and Door Chime units are not on the same operation codes - re-set the code (see digital code
set up).
d) Units are out of range - Operate the Chime unit within the operation range.
Specification
Operating Temperature: -10C - +40C
Operating Distance: 100metre (330ft approx. - in open field & at suitable condition)
Selectable Tone: Total Eight (8) melodies available
Selectable Digital Code: Total two hundred fifty six (256) possible digital codes
“Type R2 Device - device where the sound output is created by the
initial operation of the control and where the period of sound
output continues for the designed duration irrespective of
condition of the control.
Signal Sent Indicator Light
433MHz
R&TTE
APPROVED
CH Byron Electrical United Kingdom. www.chbyron.com
CH Byron Electrical Ltd
Byron House
34 Sherwood Rd, Astonfield
Bromsgrove, B60 3DR
UK
Tel: 0845 2301231
e: support@chbyron.com
w: www.chbyron.com


Produkt Specifikationer

Mærke: Elro
Kategori: Dørklokke
Model: SX-1B

Har du brug for hjælp?

Hvis du har brug for hjælp til Elro SX-1B stil et spørgsmål nedenfor, og andre brugere vil svare dig




Dørklokke Elro Manualer

Elro

Elro DB245 Manual

29 September 2024
Elro

Elro DVC04C Manual

13 September 2024
Elro

Elro HE820 Manual

9 September 2024
Elro

Elro DB3000 Manual

28 August 2024
Elro

Elro DB222 Manual

27 August 2024
Elro

Elro SX14EU Manual

2 August 2024
Elro

Elro SX41I Manual

1 August 2024

Dørklokke Manualer

Nyeste Dørklokke Manualer

EQ-3

EQ-3 HM-OU-CFM-TW Manual

16 December 2024
Cata

Cata EXTENDER 600 Manual

16 December 2024
Cata

Cata EXTENDER 700 Manual

16 December 2024
Cata

Cata CORONA 90 BK Manual

16 December 2024
Vimar

Vimar ELVOX 40962 Manual

15 December 2024
Vimar

Vimar ELVOX R975 Manual

15 December 2024
Vimar

Vimar ELVOX 2501 Manual

15 December 2024
Emos

Emos P5733S Manual

12 December 2024
Emos

Emos P5729 Manual

12 December 2024
Emos

Emos P5728T Manual

12 December 2024