Epson Stylus C42 Manual

Epson Printer Stylus C42

Læs nedenfor 📖 manual på dansk for Epson Stylus C42 (1 sider) i kategorien Printer. Denne guide var nyttig for 27 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

Unpacking

Unpacking Unpacking

1. Unpack the printer.

2. Attach the printer parts.

cCaution:

If the printer comes on when you plug in the power cord, turn off the

printer by pressing down the Ppower button until the printer lights

go out.

3. Connect the printer.

Setting

Setting Setting up

up up

Installing the Printer Software

For Windows

1. Make sure that the printer is off.

2. Insert the printer software CD in the CD-ROM

drive.

If the Installer dialog box does not appear,

double-click SETUP.EXE in the CD-ROM.

3. Select Install Software, and then click .

4. Follow the on-screen instructions. After

installing the printer software, the on-screen instructions continue with

the installation of the ink cartridges.

For Macintosh (Stylus C42UX only)

cCaution:

Turn off all virus protection programs before you install the printer

software.

For users of Mac OS 9 or earlier

1. Insert the printer software CD in the CD-ROM drive.

2. Double-click the EPSON icon, select Install Software, and then click .

3. Follow the on-screen instructions to install

the printer software.

4. After installing the software, choose

Chooser from the Apple menu, and then

select the icon for your printer and the

port that your printer is connected to.

For Mac OS X users

1. Insert the printer software CD in the

CD-ROM drive.

2. Double-click the Mac OS X Driver folder, and then double-click the

C42Series.pkg icon inside it.

If the Authorization window opens, click the key icon, enter the

administrator’s name and password, click OK, and then click Continue.

3. Follow the on-screen instructions to install the printer software.

4. After installing the software, follow the instruction below to select your

printer:

Double-click Macintosh HD. → Double-click the Application folder. →

Double-click the Utilities folder. → Double-click the Printer Center icon. →

Click Add. → Select EPSON USB. → Select your printer. → Click Add.

Installing the Ink Cartridges

1. Turn on the printer.

2. Remove the new ink cartridges

from their protective bag.

3. Insert the ink cartridges.

Note:

Install all ink cartridges. The printer will not work unless all cartridges are

installed properly.

4. Press the Hink button.

The printer begins ink charging. It

takes about one and a half minutes.

While charging, the printer produces

a variety of mechanical sounds. This is

normal. When the green lamp stops

blinking, ink charging is complete.

cCaution:

❏ Do not turn the power off during the ink charging process.

❏ Do not load paper until ink charging is complete.

Note:

The ink cartridges packaged with your printer are partly used during

initial setup. In order to produce high quality printouts, the print head in

your printer will be fully charged with ink. This one-off process consumes

a quantity of ink and subsequent cartridge sets will last for their full rated

life.

The contents may vary in certain locations.

Setup

Do not touch this part.

Do not remove or tear the label on the cartridge.

Checking th

Checking th Checking the Print

e Print

e Printe Printer

erer

Loading Paper

Your printer is now ready to use.

See “Printing Basics” on the online Reference Guide for detailed instructions

when printing for the first time.

The online Reference Guide also contains information on the following:

❏ Various printing options

❏ How To

❏ Problem Solver

❏ Product Information

❏ Safety Instructions

Please refer to it for more details.

Accessing the Online Reference Guide

Follow these steps to access the online Reference Guide.

1. Insert the printer software CD in the CD-ROM drive.

2. For Windows, select User Guides in the dialog box, and then click .

For Macintosh, double-click the EPSON icon, select User Guides, and

then click .

On Mac OS X, the dialog box does not appear when the printer software CD

is inserted. To access the online Reference Guide, double-click English\User

Guides\ \ .REF_G INDEX.HTM

Problem Solver

Online problem-solving

The EPSON’s Technical Support Web Site provide you with tips to help solve problems.

Access the Technical Support in the following ways:

For Windows users

❏ You can also access them by clicking Technical Support in the Status Monitor 3 dialog box

or on the Main menu of the printer software.

For further information on the customer support services available in your area, see the

online Reference Guide.

For Macintosh users

1. Insert the CD in the CD-ROM drive.

2. Double-click EPSON icon.

3. Select Technical Support Web Site and click .

For further information on the customer support services available in your area, see the

online Reference Guide.

Error indicators

You can identify many common problems using the lights on the printer’s control panel.

Use the following table of light patterns to diagnose the problem, and then follow the

recommended corrective measures.

O = on, N = off, F F = flashing

Safety Instructions

Read all of the instructions in this section when setting up and using your printer.

When choosing a place for the printer

❏ Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer

away from direct sunlight, strong light, or heat sources.

❏ Avoid places subject to dust, shocks, and vibrations.

❏ Leave enough room around the printer to allow for sufficient ventilation.

❏ Place the printer near a wall outlet where the plug can be easily unplugged.

❏ Place the printer on a flat, stable surface that extends beyond the printer base in all

directions. If you place the printer by the wall, leave more than 10 cm between the back

of the printer and the wall. The printer will not operate properly if it is tilted at an angle.

❏ When storing or transporting the printer, do not tilt it, put it vertically or turn it upside down;

otherwise, ink may leak from the cartridge.

When choosing a power source

❏ Use only the type of power source indicated on the printer’s label.

❏ Be sure your AC power cord meets the relevant local safety standard.

❏ Do not use a damaged or frayed power cord.

❏ If you use an extension cord with the printer, make sure that the total ampere rating of the

devices plugged into the extension cord does not exceed the cord’s ampere rating. Also,

make sure that the total ampere rating of all devices plugged into the wall outlet does not

exceed the wall outlet’s ampere rating.

❏ If you plan to use the printer in Germany, the building installation must be protected by a

10 or 16 amp circuit breaker to provide adequate short-circuit protection and over-current

protection for this printer.

When handling ink cartridges

❏ Do not open the ink cartridge packages until just before you install them.

❏ Do not shake the used ink cartridges; this can cause leakage.

❏ Keep ink cartridges out of the reach of children. Do not allow children to drink from or

otherwise handle the cartridges.

❏ Be careful when you handle used ink cartridges, as there may be some ink remaining

around the ink supply port. If ink gets on your skin, wash the area thoroughly with soap and

water. If ink gets into your eyes, flush them immediately with water. If discomfort or vision

problems remain after a thorough flushing, see a doctor immediately.

❏ Do not touch or remove the green IC chip that is located on the side of the cartridge.

❏ Do not remove or tear the label on the cartridge; this can cause leakage.

❏ Store each ink cartridge so that the bottom of its packaging faces down.

When using the printer

❏ Do not put your hand inside the printer or touch the ink cartridges during printing.

❏ Do not block or cover the openings in the printer’s cabinet.

❏ Do not attempt to service the printer yourself.

❏ Unplug the printer and refer servicing to qualified service personnel under the following

conditions:

The power cord or plug is damaged; liquid has entered the printer; the printer has been

dropped or the cabinet damaged; the printer does not operate normally or exhibits a

distinct change in performance.

❏ Do not insert objects through the slots in the printer’s cabinet.

❏ Take care not to spill liquid on the printer.

❏ Leave the ink cartridges installed. Removing the cartridges can dehydrate the printer head

and may prevent the printer from printing.

Information for United Kingdom Users

Use of options

EPSON (UK) Limited shall not be liable against any damages or problems arising from the

use of any options or consumable products other than those designated as Original EPSON

Products or EPSON Approved Products by EPSON (UK) Limited.

Safety information

wWarning:

Refer to the rating plate for the voltage and check that the appliance voltage corresponds

to the supply voltage.

Important: The wires in the mains lead fitted to this appliance are coloured in accordance

with the following code:

Blue — Neutral

Brown — Live

If you have to fit a plug:

As the colours of the mains lead of this appliance may not match the coloured markings

used to identify the terminals in a plug, please observe the following:

❏ The blue wire must be connected to the terminal in the plug marked with the letter N.

❏ The brown wire must be connected to the terminal in the plug marked with the letter L.

❏ If the plug is damaged, replace the cord set or consult a qualified electrician.

❏ Replace fuses only with fuses of the correct size and rating.

printable side up

left edge guide

output tray extension

Windows

Macintosh

Lights Problem and Solution

O b Paper out No paper is loaded in the printer.

Load paper in the sheet feeder, and then press the bmaintenance button. The

printer resumes printing and the light goes out.

O b Paper jam Paper has jammed in the printer.

Press the bmaintenance button to eject the jammed paper. If the error does not

clear, open the printer cover and remove all of the paper inside, including any torn

pieces. Then, reload the paper in the sheet feeder and press the bmaintenance

button to resume printing.

F b Ink low The black or color ink cartridge is nearly empty.

Obtain a replacement black (T036) or color (T037) ink cartridge. To determine which

cartridge is nearly empty, check the ink level using EPSON Status Monitor 3 (Windows)

or EPSON StatusMonitor (Macintosh).

O b Ink out The black or color ink cartridge is empty or not installed.

Replace the black (T036) or color (T037) ink cartridge with a new one.

N P

O b Carriage error The print head carriage is obstructed by jammed paper or

other foreign material and cannot return to the home

position.

Turn off the printer. Open the printer cover and remove any paper or other

obstructions from the paper path by hand. Then, turn the printer back on.

If the error does not clear, contact your dealer.

F P

F b Unknown printer error An unknown printer error has occurred.

Turn off the printer and contact your dealer.

English

4022277-00

C01

All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SEIKO EPSON

CORPORATION. The information contained herein is designed only for use with this EPSON printer. EPSON is not responsible for any use of this information as applied to other printers. Neither SEIKO EPSON CORPORATION nor its affiliates shall be liable

to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by the purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or

(excluding the U.S.) failure to strictly comply with SEIKO EPSON CORPORATION's operating and maintenance instructions.

SEIKO EPSON CORPORATION shall not be liable for any damages or problems arising from the use of any options or any consumable products other than those designated as Original EPSON Products or EPSON Approved Products by SEIKO EPSON

CORPORATION. SEIKO EPSON CORPORATION shall not be held liable for any damage resulting from electromagnetic interference that occurs from the use of any interface cables other than those designated as EPSON-Approved Products by SEIKO

EPSON CORPORATION. EPSON is a registered trademark and EPSON Stylus is a trademark of SEIKO EPSON CORPORATION. Microsoft and Windows are registered trademarks of Microsoft Corporation.

General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. EPSON disclaims any and all rights in those marks.