Festo SFTE Manual


Læs nedenfor 📖 manual på dansk for Festo SFTE (4 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 3 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
Translation of the original instructions
1 Further applicable documents
All available documents for the product www.festo.com/pk.è
2 Safety
2.1 Intended use
The SFTE is intended for detecting the flow of gaseous media in piping systems or
terminals in the industry sector.
WARNING!
Risk of injury from prohibited media.
Use of the product in combination with prohibited media can result in personal
injury.
Do not use the product with flammable or corrosive gases.
NOTICE!
Product damage due to incorrect air quality class.
Condensation water, oil mist, foreign matter and other dirt in the compressed air
can damage the product and cause incorrect measurements and malfunctions.
Adhere to the specified air quality class for the operating medium.
2.2 General safety instructions
The product may only be used in its original status without unauthorised
modifications.
Only use the product if it is in perfect technical condition.
Take into consideration the ambient conditions at the location of use.
Comply with all applicable national and international regulations.
Do not use the product in combination with inflammable, caustic, vapour-
emitting or other hazardous media.
Check the operating medium to determine compatibility with the materials it
contacts.
Observe the specifications on the product labelling.
Remove all transport packaging. Recycle packaging material.
3 Service
If you have technical questions, contact the regional Festo contact at
èwww.festo.com.
4 Accessories
Accessories www.festo.com/catalogue.è
5 Product overview
5.1 Design
1Pneumatic connection (inlet)
2Electrical connection
3Pneumatic connection (outlet)
Fig. 1
5.2 Product variants and type code
Feature Value Description
Type SFTE Flow transmitter
-1 Max. 1 l/min
-2 Max. 2l/min
-5 Max. 5 l/min
Flow measuring range
-10 Max. 10 l/min
Flow input r Unidirectional
-Q3 Push-in connector 3mm
-Q4 Push-in connector 4mm
Pneumatic connection
-M5 M5
NoneThread type
F Female thread
-B 1…5 VElectrical output
-V 0…10 V
-2.5K Cable 2.5 m, open endElectrical connection
-0.3M8 Cable 0.3 m, with plug connect-
or M8
Tab. 1
6 Function
The SFTE detects the flow rate (standard flow rate, mass flow rate) with the aid of
a thermal procedure. Measurements are carried out using a micromechanical
sensor element with a downstream electronic evaluation unit. The connection to
higher-level systems is implemented through a non-linearized analogue output.
The analogue output is calibrated at zero point and at the maximum flow rate
è 12 Technical data. The characteristic curve of the analogue output results from
the raw signal of the sensor element. In addition to a fast response time, the non-
linearized characteristic has the advantage of high sensitivity in the lower flow
range.
NOTICE!
Damage as a result of overflow.
Strong overflow can destroy the sensor element.
Do not exceed the maximum overflow 12 Technical data.è
Avoid rapid changes in pressure, which cause impermissible overflow.
6.1 Characteristic curve
The following figures show the typical characteristic curve.
8035274
SFTE
Flow Transmitter
8035274
2018-06
[8035276]
Instructions|Operating
Festo SE & Co. KG
Ruiter Straße 82
73734 Esslingen
Germany
+49 711 347-0
www.festo.com


Produkt Specifikationer

Mærke: Festo
Kategori: Ikke kategoriseret
Model: SFTE

Har du brug for hjælp?

Hvis du har brug for hjælp til Festo SFTE stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Festo Manualer

Festo

Festo SFAB Manual

17 November 2024
Festo

Festo SASC-P4-A-M8-S Manual

17 November 2024
Festo

Festo SFAH Manual

17 November 2024
Festo

Festo DRRD-12 Manual

17 November 2024
Festo

Festo SDE3 Manual

17 November 2024
Festo

Festo SFTE Manual

17 November 2024
Festo

Festo CRVZS-5 Manual

17 November 2024
Festo

Festo DGC-8 Manual

17 November 2024
Festo

Festo CTEU-PN Manual

17 November 2024
Festo

Festo CTEU-EC Manual

17 November 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer