Frigidaire FGHN2868T Manual

Frigidaire Køleskab FGHN2868T

Læs nedenfor 📖 manual på dansk for Frigidaire FGHN2868T (1 sider) i kategorien Køleskab. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

DO NOT REMOVE this label until the refrigerator has been leveled.

Please follow all instructions for leveling your refrigerator.

P/N: A05972301

Doors

□ Handles are secure and tight

□ Door seals completely to cabinet on all sides

□ Fresh food doors are level

Leveling

□ Refrigerator is level, side to side and tilted

¼ inch (6 mm) front to back

□ Toe grille is properly attached to refrigerator

□ Cabinet is sitting solid on all corners

Electrical Power

□ House power turned on

□ Refrigerator plugged in

 Installation Check List

Preparing For Installation

Be sure to coordinate site preparation and installation

with your kitchen contractor.

Include these minimum guidelines in your site preparation:

• Choose a place near a grounded electrical outlet.

• Do not use an extension cord or an adapter plug.

• Avoid direct sunlight and close proximity to a range,

dishwasher or other heat source.

• Floor should be level and able to support a fully

loaded refrigerator.

• The refrigerator’s Ice Dispenser

requires water supply access.

• Plan for easy access to counter tops

when removing food.

• For complete access to drawers and

freezer baskets, doors must be able to

fully open.

• Load refrigerator from side of cabinet only.

• Do not run retaining straps over handles nor overtighten straps.

• Never use refrigerator handles to move the refrigerator.

Allow the following clearances for ease of installation, proper air

circulation, and plumbing and electrical connections: Sides & Top: 3/8 inch / Rear: 1 inch

Level Refrigerator

Frigidaire uses packing foam and tape to secure the internal parts of your refrigerator for

shipping. Once the refrigerator is in position, you can remove this material.

What’s Next?

Congratulations! You are ready to begin enjoying your new Frigidaire refrigerator.

• For important safety instructions and to learn how to operate your refrigerator, please read

the entire Use & Care Guide.

• You may want to start with the “Normal Operating Sights & Sounds” section of the Guide to

learn what to expect during typical operation.

• Please register your product. You can register online at www.frigidaire.com or you can

simply send in the Registration Card.

Guidelines for nal positioning of your refrigerator

 • Allfourcornersofthecabinetmustrestrmlyontheoor.

• The sides should tilt ¼ inch (6 mm) from front to

back (to ensure that doors close and seal properly).

• Doors should align with each other and be level.

Most of these conditions can be met by raising or

lowering the adjustable front rollers.

To level the cabinet using the front rollers:

1 You can raise or lower each door. Use a 3/8 inch socket

wrench to turn the adjustment screws (1 per side).

To raise: turn adjustment screw clockwise.

To lower: turn adjustment screw counterclockwise.

2 Ensure both doors are bind-free with their seals

touching the cabinet on all four sides and that cabinet

is stable.

3 After unit is leveled, lower anti-tip leg until it contacts

theoor.

To Connect Water Supply Line To Ice Maker Inlet Valve

1. Disconnect refrigerator from electric power source.

2. Place end of water supply line into sink or

bucket.TurnONwatersupplyandush

supply line until water is clear. Turn OFF

water supply at shutoff valve.

3. Remove plastic cap from water valve inlet

and discard cap.

4. If you use copper tubing - Slide brass nut,

then ferrule (sleeve) onto water supply line.

Push water supply line into water valve inlet

as far as it will go (¼ inch). Slide ferrule

(sleeve)intovalveinletandngertightennut

onto valve. Tighten another half turn with a

wrench; DO NOT overtighten. See Figure 1.

 Ifyouusebraided,exiblestainlesssteel

tubing - The nut is already assembled on the

tubing.Slidenutontovalveinletandnger

tighten nut onto valve. Tighten another half

turn with a wrench; DO NOT overtighten. See

Figure 2.

5. With steel clamp and screw, secure water

supply line (copper tubing only) to rear panel

of refrigerator as shown.

6. Coil excess water supply line (copper tubing

only), about 2½ turns, behind refrigerator

as shown and arrange coils so they do not

vibrate or wear against any other surface.

7. Turn ON water supply at shutoff valve and

tighten any connections that leak.

8. Reconnect refrigerator to electrical power source.

9. To turn ice maker on, lower wire signal arm

(freezer ice maker) or set the ice maker’s On/

Off power switch to the “ON” position (fresh

food ice maker).

Before Installing The Water Supply Line, You Will Need:

 • BasicTools:adjustablewrench,at-bladescrewdriver,and

PhillipsTM screwdriver

• Access to a household cold water line with water pressure

between 30 and 100 psi.

• A water supply line made of ¼ inch (6 mm) OD, copper

or stainless steel tubing. To determine the length of

tubing needed, measure the distance from the ice

maker inlet valve at the back of the refrigerator to your

cold water pipe. Then add approximately 7 feet, so the

refrigerator can be moved out for cleaning.

• A shutoff valve to connect the water supply line to your

household water system. DO NOT use a self-piercing type

shutoff valve.

• A compression nut and ferrule (sleeve) for connecting a copper water supply line to the

ice maker inlet valve.

*Please refer to your Use & Care Guide for more details.

Connect Water Supply

Ice Maker

□ House water supply connected to

refrigerator

□ No water leaks present at all connections

□ Ice Maker is turned ON.

Final Checks

□ Shipping material removed

□ Fresh Food and Freezer temperatures set

Raise

Lower

Anti-tip

Leg

Door

If you are not satised with the installation of your refrigerator, please contact the store where you purchased it or call 1-800-944-9044 for assistance.

Removing & Replacing Freezer Drawer

Remove Internal Shipping Materials

Installation Instructions* for French Door Bottom Freezer/Refrigerator

WARNING

To avoid electric shock, which can cause d eath or severe personal

injury, do not connect your refrigerator to an electrical power source

until you have completed Step 2 of these instructions.

CAUTION

• Shifting the refrigerator from side to side

may damage flooring.

• Do not block the toe grille on the lower

front of your refrigerator. Sufficient air cir-

culation is essential for proper operation.

IMPORTANT

If you are installing your refrigerator

without connecting it to a water

supply, make sure the ice maker’s

power switch is turned Off (see the

Use & Care Guide for more details).

NOTE

If you need to remove the doors to get your refrigerator into the house, please refer to “Removing Doors”

in the Use & Care Guide. These installation instructions are provided only as a possible customer option.

Frigidaire recommends that you use a service or kitchen contracting professional to install your refrigerator.

NOTE

Check with your local building authority for

recommendations on water lines and associated

materials prior to installing your new refrigerator.

Depending on your local/state building codes,

Frigidaire recommends for homes with existing

valves its Smart Choice 6 ft. Stainless Steel

Refrigerator Water Line Kit 5304490728

and for homes without an existing valve,

Frigidaire recommends its Smart Choice 20 ft.

Copper Refrigerator Water Line Installation Kit

5304490717 (with a with self-tapping saddle

valve). Please refer to www.frigidaire.com for

more information.

CAUTION

Room temperatures

below 55°F (13°C)

or above 110°F

(43°C) will impair

cooling ability of

your refrigerator’s

compressor.

NOTE

Please call 1-800-944-9044 if you

need assistance with this installation.

WARNING

To avoid electric shock,

which can cause death

or severe personal

injury, disconnect the

refrigerator from elec-

trical power before con-

necting a water supply

line to the refrigerator.

CAUTION

To Avoid Property Damage:

• Copper or Stainless Steel braided tubing is recommended for the wa-

ter supply line. Water supply tubing made of ¼ inch (6 mm) p lastic

is not recommended to be used. Plastic tubing greatly increases the

potential for water leaks, and the manufacturer will not be respon-

sible for any damage if plastic tubing is used for the supply line.

• Do not reuse compression fitting or use thread seal tape.

• DO NOT install water supply tubing in areas where temperatures fall

below freezing.

• Chemicals from a malfunctioning softener can damage the ice maker.

If the ice maker is connected to soft water, ensure that the softener

is maintained and working properly.

(Include enough tubing in loop to allow

moving refrigerator out for cleaning.)

Copper water line

from household water supply

(Include enough tubing in loop to allow

moving refrigerator out for cleaning.)

Ferrule

(Sleeve)

Copper

water line

Water Valve

Valve Inlet

Water Valve

Bracket

Steel

Clamp

Plastic Water

Tubing to

Filter Brass

Compression

Nut

Figure 1

Figure 2

Adjusting Doors (if necessary)

Removing Freezer Drawer

1. Remove 4 hex head drawer screws.

2. Lift up drawer to remove.

Remove

Hex Head

Drawer Screw

DO NOT

Remove

Other

Screws

DO NOT

Loosen

Remove

These 3

Hex

Screws

Replacing Freezer Drawer

1. Lower drawer back into place.

2. Replace 4 hex head drawer screws

and tighten.

Raise

To make nal door height adjustments:

1. Open freezer drawer to make lower hinge visible.

2. Insert 6 mm Allen wrench into the shaft of

the lower hinge.

3. Adjust the height by turning clockwise or

counterclockwise. Turning clockwise will

lower the door. Turning counterclockwise will

raise the door. Default setting is to the lowest

height when you receive your appliance.

Produkt Specifikationer

Mærke:	Frigidaire
Kategori:	Køleskab
Model:	FGHN2868T

Har du brug for hjælp?

Hvis du har brug for hjælp til Frigidaire FGHN2868T stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Køleskab Frigidaire Manualer

Frigidaire FRSG2115AV Manual

24 Oktober 2024

Frigidaire PRDA1922AF Manual

24 Oktober 2024

Frigidaire FRS6KR5JSW Manual

14 Oktober 2024

Frigidaire FFPT12F3MM Manual

14 Oktober 2024

Frigidaire FFHT1826LS Manual

11 Oktober 2024

Frigidaire FFHS2313LP Manual

4 Oktober 2024

Frigidaire FRT17G5JSB Manual

4 Oktober 2024

Frigidaire FRFS2823AD Manual

4 Oktober 2024

Frigidaire GLHT184TJW Manual

4 Oktober 2024

Frigidaire PHS69EHSS Manual

3 Oktober 2024

Køleskab Manualer

Nyeste Køleskab Manualer

Kaiser K 64750 AD Manual

23 December 2024

Philips TB510 Manual

23 December 2024

Miele KFN 8762 Sed Manual

23 December 2024

Miele KFN 28132 edt / cs Manual

23 December 2024

Miele KFN 29132 edt/cs Manual

23 December 2024

Miele KFN 4395 CD Manual

23 December 2024

Miele KFN 4795 CD Manual

23 December 2024

Miele K 7125 E Manual

23 December 2024

Miele K 7126 E Manual

23 December 2024

Miele K 7327 D Manual

23 December 2024