GE JXS77WW Manual

GE Ovn JXS77WW

Læs nedenfor 📖 manual på dansk for GE JXS77WW (2 sider) i kategorien Ovn. Denne guide var nyttig for 2 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/2
Installation Instructions
Body Side Kit For End of the Counter Installation
Tools Required:
#2 Phillips screw driver
Installing the Kit
This Body Side Kit must be installed prior to installing the Range in position.
Locate the body side keyway holes over the heads of the panel supports.
A
A1 Place the three panel supports in the 3 square holes of the vertical side trim and rotate 45° as shown below.
( May require Pliers) See illustration on back page.
A3 Insert 1” screw through shoulder rivet. Place the 1/2” spacer over the end of the 1” screw. Place the spacer-
shoulder rivet-screw assembly through washer. Install assembly in place of the screw removed in A2. (See
illustration on back page.)
A4
Pub. No. 31-10451
229C4053P434
Push the body side forward locking the slots of the keyway holes on the side panel supports.
A5
Place the longest screw (1-1/2” ) through the top hole of the body side at the rear of the range. Slide the spacer
(1-1/4”) over the screw and attach the screw to the hole in the rear of the range above the louvers. Do not tighten.(If
a backsplash kit is used in conjunction with this kit, use the shorter spacer found in the backsplash kit.) See
illustration on back page.
A6
Lift the rear of the body side to close the gap between the cooktop glass and the body side. Tighten the screws
from steps A6 and A7.
A7
Place the short (3/8” long) hex head screw through the bottom hole in the rear of the body side and attach to the
lower section of the range. See illustration on back page, Do Not Tighten.
A8
To stabilize the bottom front corner of the body side-range assembly, place the clip over the inside flange of the
body side and the outside flange of the vertical side trim, as shown in illustration. Start by raising the front corner
of the range by turning the leveling leg downward, to provide more clearance for attaching clip. See illustration on
back page for details of attaching clip. (Hold the body side and the vertical side trim close for easier assembly
of the clip.) See Illustration on back page.
A9
Refer to the Installation Instructions included with the range to place the range into kitchen location.
A10
1/4” Nut Driver
Pliers
Parts Supplied:
3 Panel Supports
1 Body Side
1/2” Spacer
1-1/4” Spacer
Clip
Shoulder Rivet
Washer
#8-3/8” Long
Hex Screw
#8-1” Long Screw
#8-1-1/2” Long Screw
Use these instructions to mount the Body Side Kit on either side of the Slide-In Range.
Remove the hex head screw at the top end of the vertical side trim as shown in the illustration on back page.
A2
1

Produkt Specifikationer

Mærke: GE
Kategori: Ovn
Model: JXS77WW

Har du brug for hjælp?

Hvis du har brug for hjælp til GE JXS77WW stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ovn GE Manualer

GE

GE PSA1200 Manual

15 December 2024
GE

GE JTP70WMWW Manual

15 December 2024
GE

GE JB750EFES Manual

15 December 2024
GE

GE Café CTD90FP2MS1 Manual

7 December 2024
GE

GE Café CGP60362TS1 Manual

7 December 2024
GE

GE EER4000NBB Manual

7 December 2024
GE

GE Café CGP60302TS1 Manual

7 December 2024
GE

GE Café CXPR8HKPTCU Manual

7 December 2024
GE

GE Café CXPR6HKPTSS Manual

7 December 2024
GE

GE EGR3000EHWW Manual

7 December 2024

Ovn Manualer

Nyeste Ovn Manualer

Bosch

Bosch PID61RHB1E Manual

21 December 2024
Bosch

Bosch NGM5059UC Manual

21 December 2024
Bosch

Bosch NGM5453UC Manual

21 December 2024
Electrolux

Electrolux GK58TSITO Manual

21 December 2024
Electrolux

Electrolux EOT2515XG Manual

21 December 2024
Electrolux

Electrolux EOT3215XFG Manual

21 December 2024
Electrolux

Electrolux EOT1513XG Manual

21 December 2024
Bosch

Bosch HEG517BB4 Manual

21 December 2024
Bosch

Bosch HEG217AB4 Manual

21 December 2024
Bosch

Bosch HEG278AB3 Manual

21 December 2024