GMG Yepp Easyfit carrier Manual

GMG Diverse Yepp Easyfit carrier

Læs nedenfor 📖 manual på dansk for GMG Yepp Easyfit carrier (2 sider) i kategorien Diverse. Denne guide var nyttig for 14 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Installation instructions for the Yepp® Easyfit carrier
1
Installation instructions for the Yepp® Easyfit carrier
Installation instructions for the Yepp® Easyfit carrier
The Yepp Easyfit carrier is suitable for fitting to standard bicycle luggage carriers with a load capacity of
at least 60 lbs. The Yepp Easyfit carrier has a special installation frame for the Yepp Easyfit and the
Yepp Junior rear seat as well as to the GMG Classic 911 model child seats. The maximum width of the
carrier is 6.75 inches.
Installing the Yepp Easyfit carrier
Position the Yepp Easyfit carrier on the luggage carrier and insert the 4 bolts from above into the four
large slots. See the picture below for the proper positioning (pic.1).
Insert the bolts into the 4 clamps positioned under the Yepp Easyfit carrier. Note the proper position
of the clamps (pic.2).
Position the Yepp Easyfit carrier exactly on your luggage carrier and tighten the bolts firmly.
Pic. 1 Pic 2.
Warnings and Safety advices:
WARNING: Check the bolts frequently and tighten them again if necessary.
The Yepp Maxi Easyfit can be quickly and simply fitted after the installation.
The position of the child seat depends on the type and size of the cycle.
WARNING: The centre of gravity of the Yepp Maxi Easyfit model child seat must never be further
than 10 cm / 3.75 inches behind the rear axle (see the user instructions for the Yepp Maxi Easyfit).
WARNING The Yepp Easyfit carrier can only be installed on luggage carriers with a load capacity of at
least 60 lbs.
If the Yepp Easyfit carrier is used with the Classic junior 911 model child cycle seat, the luggage carrier
must have a load capacity of 78 lbs.
If you are installing a Yepp Maxi Easyfit model child seat, please check whether the bicycle
could tip over backwards when the child is in the seat. If so, move the Yepp Easyfit carrier
forwards.
Check frequently to ensure that all fittings are sufficiently tight.
Use the Yepp Easyfit carrier only on a bicycle that is in good working order, of a type suitable
for carrying the additional load, and of proper size and adjustment for the rider.
Check the owner’s manual that accompanied the bicycle or contact the bicycle manufacturer
or distributor to obtain this information.
The Yepp Easyfit carrier must not be used on motorised vehicles (including mopeds, scooters,
etc.) apart from E-bikes.
Never modify the carrier in any way.
Do not use the carrier if any part of it appears damaged.
RECOMMENDATION:
Use a good two-legged bicycle stand.


Produkt Specifikationer

Mærke: GMG
Kategori: Diverse
Model: Yepp Easyfit carrier

Har du brug for hjælp?

Hvis du har brug for hjælp til GMG Yepp Easyfit carrier stil et spørgsmål nedenfor, og andre brugere vil svare dig




Diverse GMG Manualer

Diverse Manualer

Nyeste Diverse Manualer

Walkera

Walkera Goggle 3 Manual

15 Oktober 2024
Walkera

Walkera Goggle 4 Manual

15 Oktober 2024
Navman

Navman NavBus Manual

5 Oktober 2024
Trelock

Trelock LS 320 Manual

5 Oktober 2024
Tanita

Tanita 1210N Manual

5 Oktober 2024
Somfy

Somfy Telis Lounge Manual

4 Oktober 2024
Enduro

Enduro BT1201 Manual

23 September 2024