Honeywell equIP H3D1F Manual

Honeywell Overvågningskamera equIP H3D1F

Læs nedenfor 📖 manual på dansk for Honeywell equIP H3D1F (2 sider) i kategorien Overvågningskamera. Denne guide var nyttig for 3 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/2
Document 800-13169 – Rev A – 11/2012
H3 Series
ONVIF Indoor High Resolution TDN IP Indoor Minidome Cameras
Quick Install Guide
Document 800-13169 – Rev A – 11/2012
;
FCC Compliance Statement
Information to the User: This equipment has been tested and found to comply with the limits for a Class B digital device.
Pursuant to Part 15 of the FCC Rules, these limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference. For example, try reorienting or relocating
the receiving antenna, increasing the separation between the equipment and receiver, or connecting the equipment to an
outlet on a different circuit.
Caution Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
North America
The equipment supplied with this guide conforms to UL 60950-1 and CSA C22.2 No. 60950-1.
Manufacturer’s Declaration of Conformance
The manufacturer declares that the equipment supplied with this guide is compliant with the
essential protection requirements of the EMC directive 2004/108/EC and the General Product Safety Directive 2001/95/EC,
conforming to the requirements of standards EN 55022 for emissions, EN 50024 for immunity, and EN 60950 for Electrical
Equipment safety.
Introduction
Warnings
Installation and servicing should be performed only by qualified and experienced technicians to conform to all
local codes and to maintain your warranty.
WARNING! 24 V AC models require the use of CSA Certified/UL Listed Class 2 power adapters to ensure
compliance with electrical safety standards. Power over Ethernet (PoE) should meet the IEEE
802.3 af PoE standard.
WEEE (Waste Electrical and Electronic Equipment). Correct disposal of this product
(applicable in the European Union and other European countries with separate collection
systems). This product should be disposed of, at the end of its useful life, as per applicable
local laws, regulations, and procedures.
Contact Information
www.honeywellvideo.com
+1.800.323.4576 (North America only)
HVSsupport@honeywell.com
Document 800-13169 – Rev A – 11/2012
© 2012 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means
without written permission from Honeywell. The information in this publication is believed to be accurate in all respects.
However, Honeywell cannot assume responsibility for any consequences resulting from the use thereof. The
information contained herein is subject to change without notice. Revisions or new editions to this publication may be
issued to incorporate such changes.
Thank you for purchasing a Honeywell H3 Series Indoor High Resolution True Day/Night IP
Indoor Minidome Camera. Before installing the camera, please read this guide carefully and verify
your model:
equIP Series
H3D1F/H3D1FX, 720p resolution, 3.3 - 12 mm Vari-focal Auto Iris lens
H3D2F/H3D2FX, 1080p resolution, 3 - 9 mm Vari-focal Motorized Focus and Zoom lens
H3W1F/H3W1FX, Wide Dynamic 720p resolution, 3.3 - 12 mm Vari-focal Auto Iris lens
Performance Series
H3S1P/H3S1PX, 720p resolution, 3.3 - 12 mm Vari-focal Auto Iris lens
H3SVP/H3SVPX, VGA resolution, 3.3 - 12 mm Vari-focal Auto Iris lens
For detailed information for your specific camera, please refer to the appropriate user guide located on
the IP Utility DVD.
Before installing the camera, Honeywell recommends that you download the latest software
updates. Go to www.honeywellsystems.com/support/download-center/index.html and follow the
instructions on the page to logon, find your camera, and then download software updates.
The camera has a web client that enables you to view video and configure device settings
for the camera using a standard web browser. See the appropriate user guide located on
your software DVD to set up your web browser to view video. To log on to the web lient
application:
1. Launch Internet Explorer and enter the URL (IP address) for the network camera.
OR, launch the web client application from the IP Utility by clicking Launch Browser.
2. Select the User Name as admin or Guest.
3. Enter the case-sensitive password and click . The default passwords are 1234
(Administrator) or guest (Guest user).
5Camera Operation
Operating Notes
Power Supply This dome camera can operate on 24 V AC or PoE.
Operating Conditions Avoid:
• Viewing bright objects (for example, light fixtures) for extended
periods
• Operating or storing the unit in the following locations.
• Extremely humid, dusty, hot/cold environments (where the
operating temperature is outside the recommended range of
14°F to 122°F [-10°C to +50°C])
• Close to sources of powerful electromagnetic radiation, such
as radio or TV transmitters
• Close to fluorescent lamps or objects reflecting light
• Under unstable light sources (may cause flickering)
4Network Setup
Honeywell IP Utility
Note Before installing and using the Honeywell IP Utility, ensure that your camera is
connected to your network through a CAT5 Ethernet cable.
Note It is recommended that you disable any Norton’s AntiVirus software that might be
running on the workstation.
To discover the IP camera devices and configure their network settings, you must first install
the IP Utility. See the appropriate user guide located on your software DVD or on the
Honeywell product web site. You must have Windows administrator privileges for the
workstation on which the Honeywell IP Utility is being installed.
1. Insert the DVD. Autorun will start the installation. If autorun does not start, browse to the
DVD drive and run Honeywell IP Utility Setup.exe.
2. Follow the steps in the InstallShield Wizard.
3. Log on to the IP Utility by double-clicking the IP Utility icon ( ) on the desktop. The main IP
utility screen appears.
Note This camera supports the ONVIF™ specification for interoperability between network
video products. There is no support for legacy equIP and equIP2 products.
Configuring the Network
1. After you log on to the IP utility, the devices on the network are automatically
discovered and listed in the Discovery pane. After the initial discovery, auto-refresh
continues to discover newly added network devices.
2. Connect to your IP camera device by double-clicking it in the Discovery pane or by
selecting it and clicking .
3. Configure the IP network settings:
•Automatically. Connect to the device, click the System tab, select to Obtain an
IP Address automatically, enter the Device Name, and click Apply. The network
settings are automatically assigned from the network server.
•Manually. Connect to the device, click the System tab. Ensure Obtain an IP
Address automatically is not selected, then enter the Device Name, IP Address,
Subnet Mask, and Gateway. Click Apply.
Caution Check the IP network settings before clicking Apply. Incorrect values might cause
a failure when connecting the tool to the device.
Note Contact your network administrator if you have any network-related issues or
questions about your network.

Produkt Specifikationer

Mærke: Honeywell
Kategori: Overvågningskamera
Model: equIP H3D1F

Har du brug for hjælp?

Hvis du har brug for hjælp til Honeywell equIP H3D1F stil et spørgsmål nedenfor, og andre brugere vil svare dig


Overvågningskamera Honeywell Manualer

Honeywell

Honeywell HD3C Manual

23 September 2024
Honeywell

Honeywell iPCAM-PT Manual

24 August 2024
Honeywell

Honeywell Equip HD4HDIH Manual

20 August 2024
Honeywell

Honeywell HN30160200 Manual

16 August 2024
Honeywell

Honeywell HDZ30A Manual

13 August 2024
Honeywell

Honeywell Performance HD31H Manual

12 August 2024
Honeywell

Honeywell HD50 Manual

11 August 2024
Honeywell

Honeywell Equip HDZ30 Manual

10 August 2024
Honeywell

Honeywell Performance HBW8PR2 Manual

10 August 2024
Honeywell

Honeywell HC30W45R3 Manual

7 August 2024

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer

Sony

Sony SNC-DH160 Manual

16 November 2024
Bresser

Bresser DL-30MP Manual

15 November 2024
D-Link

D-Link DCS-6500LHV2 Manual

14 November 2024
D-Link

D-Link DCS-2803KT Manual

13 November 2024
D-Link

D-Link DCS-2804KT Manual

13 November 2024
D-Link

D-Link DCS-931L Manual

13 November 2024
D-Link

D-Link DCS-6100LHV2 Manual

13 November 2024
Philips

Philips Series 3000 HSP3800 Manual

13 November 2024
Emos

Emos H4060 Manual

13 November 2024
Philips

Philips Series 3000 HSP3500 Manual

13 November 2024