Honeywell Voyager 1400g Manual
Honeywell
Stregkodelæser
Voyager 1400g
Læs nedenfor 📖 manual på dansk for Honeywell Voyager 1400g (216 sider) i kategorien Stregkodelæser. Denne guide var nyttig for 23 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/216

™
Voyager™ 1400g Series
Area-Imaging Scanner
User’s Guide

Disclaimer
Honeywell International Inc. (“HII”) reserves the right to make changes in speci-
fications and other information contained in this document without prior notice,
and the reader should in all cases consult HII to determine whether any such
changes have been made. The information in this publication does not repre-
sent a commitment on the part of HII.
HII shall not be liable for technical or editorial errors or omissions contained
herein; nor for incidental or consequential damages resulting from the furnish-
ing, performance, or use of this material. HII disclaims all responsibility for the
selection and use of software and/or hardware to achieve intended results.
This document contains proprietary information that is protected by copyright.
All rights are reserved. No part of this document may be photocopied, repro-
duced, or translated into another language without the prior written consent of
HII.
2012-2014 Honeywell International Inc. All rights reserved.
Web Address: www.honeywellaidc.com
Microsoft® Windows® is a trademark or registered trademark of Microsoft Cor-
poration.
Other product names or marks mentioned in this document may be trademarks
or registered trademarks of other companies and are the property of their
respective owners.

Product Agency Compliance
USA
FCC Part 15 Subpart B Class B
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radi-
ate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for
help.
If necessary, the user should consult the dealer or an experienced radio/
television technician for additional suggestions. The user may find the fol-
lowing booklet helpful: “Something About Interference.” This is available at
FCC local regional offices. Honeywell is not responsible for any radio or
television interference caused by unauthorized modifications of this equip-
ment or the substitution or attachment of connecting cables and equipment
other than those specified by Honeywell. The correction is the responsibil-
ity of the user.
Use only shielded data cables with this system. This unit has been tested
with cables less than 3 meters. Cables greater than 3 meters may not meet
class B performance.
Caution: Any changes or modifications made to this equipment not
expressly approved by Honeywell may void the FCC authorization to oper-
ate this equipment.

vii
Replacing an Interface Cable .............................. 11-2
Troubleshooting a Voyager 1400g Scanner.............. 11-2
Chapter 12 - Customer Support
Appendix A - Reference Charts
Symbology Charts....................................................... A-1
Linear Symbologies...............................................A-1
2D Symbologies .................................................... A-3
Postal Symbologies...............................................A-3
ASCII Conversion Chart (Code Page 1252) ...............A-4
Lower ASCII Reference Table ....................................A-5
ISO 2022/ISO 646 Character Replacements ............A-10
Unicode Key Maps ....................................................A-13

viii

1 - 1
1
Getting Started
About This Manual
This User’s Guide provides installation and programming instructions for the
Voyager™ 1400g area-imaging scanner. Product specifications, dimensions,
warranty, and customer support information are also included.
Note: The selections in this User’s Guide are dependent on the Voyager 1400g
model you have purchased.
PDF bar codes can only be read by models 1400gPDF or 1400g2D and
cannot be read by model 1400g1D.
2 dimensional bar codes can only be read by model 1400g2D and cannot
be read by models 1400gPDF or 1400g1D.
Honeywell bar code scanners are factory programmed for the most common
terminal and communications settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide.
An asterisk (*) next to an option indicates the default setting.
Unpacking Your Device
After you open the shipping carton containing the product, take the following
steps:
• Check for damage during shipment. Report damage immediately to the
carrier who delivered the carton.
• Make sure the items in the carton match your order.
• Save the shipping container for later storage or shipping.
Connecting the Device
Connecting with USB
A scanner can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the device first, then to the
computer.

1 - 2
2. The scanner beeps.
3. Verify the scanner operation by scanning a bar code from the Sample
Symbols in the back of this manual.
The unit defaults to a USB PC Keyboard. Refer to page 2-4 for other USB
terminal settings.
For additional USB programming and technical information, refer to “USB
Application Note,” available at www.honeywellaidc.com.
Connecting with Keyboard Wedge
A scanner can be connected between the keyboard and PC as a “keyboard
wedge,” where the scanner provides data output that is similar to keyboard
entries. The following is an example of a keyboard wedge connection:
1. Turn off power and disconnect the keyboard cable from the back of the
terminal/computer.
2. Connect the appropriate interface cable to the device and to the
terminal/computer.
Produkt Specifikationer
Mærke: | Honeywell |
Kategori: | Stregkodelæser |
Model: | Voyager 1400g |
Har du brug for hjælp?
Hvis du har brug for hjælp til Honeywell Voyager 1400g stil et spørgsmål nedenfor, og andre brugere vil svare dig
Stregkodelæser Honeywell Manualer

29 December 2024

29 December 2024

3 Oktober 2024

13 September 2024

28 August 2024

28 August 2024

28 August 2024

21 August 2024

20 August 2024

18 August 2024
Stregkodelæser Manualer
- Stregkodelæser Nilox
- Stregkodelæser IFM
- Stregkodelæser Motorola
- Stregkodelæser Nedis
- Stregkodelæser Casio
- Stregkodelæser Palm
- Stregkodelæser Trimble
- Stregkodelæser König
- Stregkodelæser Deltaco
- Stregkodelæser Digitus
- Stregkodelæser Zebra
- Stregkodelæser Olympia
- Stregkodelæser ELO
- Stregkodelæser Intermec
- Stregkodelæser Datalogic
- Stregkodelæser Newland
- Stregkodelæser Renkforce
- Stregkodelæser Manhattan
- Stregkodelæser DeLOCK
- Stregkodelæser Opticon
- Stregkodelæser Qian
- Stregkodelæser Godex
- Stregkodelæser Steren
- Stregkodelæser Argox
- Stregkodelæser IC Intracom
- Stregkodelæser Adesso
- Stregkodelæser POSline
- Stregkodelæser Metapace
- Stregkodelæser Wasp
- Stregkodelæser Approx
- Stregkodelæser Brady
- Stregkodelæser Baracoda
- Stregkodelæser Posiflex
- Stregkodelæser Datamax-O'neil
- Stregkodelæser CipherLab
- Stregkodelæser Cypress
- Stregkodelæser DENSO
- Stregkodelæser Socket Mobile
- Stregkodelæser Mach Power
- Stregkodelæser QUIO
- Stregkodelæser EC Line
- Stregkodelæser Tecno
- Stregkodelæser ZBA
- Stregkodelæser Code Corporation
- Stregkodelæser Hamlet
- Stregkodelæser Qoltec
- Stregkodelæser Vultech
- Stregkodelæser Psion
- Stregkodelæser Koamtac
- Stregkodelæser Unitech
- Stregkodelæser Atlantis Land
- Stregkodelæser ID-Tech
- Stregkodelæser Code
- Stregkodelæser Bluebird
- Stregkodelæser Cognex
Nyeste Stregkodelæser Manualer

24 Marts 2025

24 Marts 2025

26 Februar 2025

23 Februar 2025

23 Februar 2025

23 Februar 2025

23 Februar 2025

23 Februar 2025

21 Februar 2025

20 Februar 2025