Hotpoint H8 D94WB UK Manual

Hotpoint Tørretumbler H8 D94WB UK

Læs nedenfor 📖 manual på dansk for Hotpoint H8 D94WB UK (4 sider) i kategorien Tørretumbler. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/4
THANK YOU FOR BUYING A HOTPOINT PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.hotpoint.eu/register
EN
Quick guide
Before using the appliance read the Safety Instructions carefully.
Eco Monitor
This indicator shows the energy consumption level according to
the programme and the options set. The consumption is
proportional to the lines on the display, by the ecomonitor icon.
OPENING THE DOOR DURING THE CYCLE
Laundry can be checked while the drying cycle runs and any
garments already dry can be removed, while drying continues for
the remaining items. After closing the door, press the "Start/Pause"
button to resume machine operation.
Keep the door closed until the cycle end to save time and energy.
NAVIGATION
The " " and " " buttons are used to navigate the available UP DOWN
menus.
• Press the OK button to conrm the selection.
• Press the Option button at the symbol, where present on the
display, to return to the previous screen.
If no selection is conrmed, after about 2 minutes, the display
return to the main screen.
SETTINGS
To access the Settings menu, press and hold the relevant button for a
few seconds.
• Set language shows the available languages on the display.
• Sounds allows to enable or disable the sounds (some sounds, as
warnings, will remain active anyway).
• Brightness allows to modify the display brightness.
• Factory Default allows to reset the default settings. After having
selected the setting, press and hold the OK button for a few
seconds.
FIRST TIME USE
When starting the appliance the rst time, the control panel will
automatically show the set language menu. The UP and DOWN
buttons are used to show the languages available in the
machine. Press the to conrm. The machine cannot OK button
be used without having selected the language.
Make sure that the water tank is correctly inserted.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
Before using the dryer make sure it has been in an upright
position for at least 6 hours.
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying cycle.
- remember to clean your lters after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments always refer to instructions on ;
clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door lter. Do not load items that
are dripping wet. Do not tumble dry large, very bulky items.
3. Close the door.
4. Press the "On/O" button.
5. Select the most suitable programme
for the type of fabric in that
load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Pull the load out
immediately to prevent the formation of creases on laundry.
9. Turn the machine o by pressing the "On/O" button, open the
door and pull the clothing out. If the machine is not switched o
manually, after about a quarter of an hour from the end of the
cycle , the appliance turns o automatically to save energy.
Note that some programme/option accords with "Crease Care"
system. This means that for some hours, after the end of the
drying cycle, the drum rotates at regular intervals to prevent the
formation of creases.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle.
*MAX LOAD 9 Kg (Dry load)
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
INDICATORS
Cycle phase: ENDDrying - Cool Down - End of Cycle
Empty water tank - Clean secondary lter - door - Eco Monitor Clogged lters Autoclean -
Refer to Troubleshooting section: Failure call After-sales Service -
DEMO
Demo Mode
CONTROL PANEL
1 Programme selection knob
2 On/O button
3 Start/Pause button
Options buttons
4 Gentle Power
5 Crease Care
6 Cycle End Signal
7 Cycle Options (hold for Settings)
8 Dryness Level
9 Timed Drying
10 Start Delay
Navigation buttons and Key Lock
11 UP
12 DOWN
13 CONFIRM OK (hold for Key Lock)
1
7
8 9 10
6
5
13
4
3
2
11
SYNTHETICS
1:35
-:-- -:--
12
EXTRA

Produkt Specifikationer

Mærke: Hotpoint
Kategori: Tørretumbler
Model: H8 D94WB UK

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint H8 D94WB UK stil et spørgsmål nedenfor, og andre brugere vil svare dig


Tørretumbler Hotpoint Manualer

Hotpoint

Hotpoint NT M11 82XB IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 8X3K IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 9X3SKY IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 82K IT Manual

13 December 2024
Hotpoint

Hotpoint NTS M11 9X3E IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 8X3SKY IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 92WK IT Manual

13 December 2024
Hotpoint

Hotpoint EU NTDG92 SK IT Manual

12 December 2024
Hotpoint

Hotpoint NVL333EBCC Manual

29 September 2024
Hotpoint

Hotpoint H2D81WUK Manual

17 September 2024

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

LG

LG RH90V9ZVEN Manual

19 December 2024
LG

LG TD-C70030EB Manual

19 December 2024
LG

LG RH80V5AV0N Manual

19 December 2024
Whirlpool

Whirlpool awz 8813 Manual

18 December 2024
Bosch

Bosch WTN832M1NL Manual

18 December 2024
Altus

Altus ADP80W Manual

17 December 2024
Ufesa

Ufesa Pro Ionic Style Manual

17 December 2024
Ufesa

Ufesa Pro Ionic-Shine Manual

17 December 2024
Haier

Haier HD100-A3959E-IT Manual

17 December 2024
Haier

Haier HD110-A3959E-IT Manual

17 December 2024