Hotpoint I3 D81B UK Manual

Hotpoint Tørretumbler I3 D81B UK

Læs nedenfor 📖 manual på dansk for Hotpoint I3 D81B UK (4 sider) i kategorien Tørretumbler. Denne guide var nyttig for 26 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/4
CARE LABEL
Always check the care labels, especially when placing garments
in the tumble dryer for the  rst time. Below are the most
commonly used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
THANK YOU FOR BUYING AN INDESIT PRODUCT.
In order to receive a more complete assistance, please
register your product on www.indesit.eu/register
EN
Quick guide
Before using the appliance carefully read the Safety
Instructions.
FIRST TIME USE
Remove all the tapes used to hold items on the machine.
Before you use it, clean the inside of the drum to remove any
dust that could have accumulated during transport. Slight odour
or vapour may be found if you open the door during its rst use,
this is normal and should only last a few minutes.
Make sure that the water tank is correctly inserted. Make sure
that the drain hose on the back of the dryer is properly
connected, either to the dryers's water tank or to your domestic
drainage system.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying cycle.
- remember to clean your condenser unit regularly
(monthly).
- remember to clean your lter after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions on
clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door lter. Do not load items that
are dripping wet. Do not tumble dry large, very bulky items.
3. Close the door.
4. Press the "On/O" button.
5. Select the most suitable programme
for the type of fabric in that
load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Pull the load out
immediately to prevent the formation of creases on laundry.
9. Turn the machine o by pressing the "On/O" button, open the
door and pull the clothing out. If the machine is not switched o
manually, after about a quarter of an hour from the end of the
cycle , the appliance turns o automatically to save energy.
Note that some programme/option accords with "Crease Care"
system. This means that for some hours, after the end of the
drying cycle, the drum rotates at regular intervals to prevent the
formation of creases.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle.
OPENING THE DOOR DURING THE CYCLE
Laundry can be checked while the drying cycle runs and any
garments already dry can be removed, while drying continues for
the remaining items. After closing the door, press the "Start/Pause"
button to resume machine operation.
TRANSPORT AND HANDLING
Never lift the dryer by holding on to its top side.
1. Unplug the dryer
2. Remove the water from the water tank completely.
3. Make sure that door and water tank are properly closed.
4. If the drain hose is connected to your drainage system, re-connect
it to the back of the dryer (see "Installation" section in the Safety
Instructions).
PUSH & GO
This function allows you to start an automatic drying cycle with just a
few simple gestures.
It is always necessary to follow points 1, 2, 3 and 4 of the “Daily
Use” section.
Press and hold the “Push & Go” button after turning on the machine,
regardless of the position of the knob. The light on indicates that
the cycle has started. This programme does not allow setting other
options.
This cycle is suitable for cotton and synthetic items, max load 4 kg
(cycle duration 100’).
CONTROL PANEL
1 ON/OFF Button (hold to Reset)
2 Programme Selection Knob
3 Start/Pause
Options Buttons*
4 Push & GO
5 Dryness Level
6 Start Delay
7 Timed Drying
8 Cycle End Signal
9 Light Dry (hold for Key Lock)
10 Crease Care hold to Mute)(
INDICATORS
Dryness Level: Iron Dry - Hanger Dry - Cupboard Dry - Extra Dry
Program Status: ENDDrying - Cool Down - End of Cycle
Empty water tank Clean door lter - - Clean the condenser unit
Refer to troubleshooting section: Call after sales service.
Failure:
END
EN
EN
EN
END
D
D
D
1
3
2
4
10
8
9
5 6 7
h
h
h
h
h
h

Produkt Specifikationer

Mærke: Hotpoint
Kategori: Tørretumbler
Model: I3 D81B UK

Har du brug for hjælp?

Hvis du har brug for hjælp til Hotpoint I3 D81B UK stil et spørgsmål nedenfor, og andre brugere vil svare dig


Tørretumbler Hotpoint Manualer

Hotpoint

Hotpoint NT M11 82XB IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 8X3K IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 9X3SKY IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 82K IT Manual

13 December 2024
Hotpoint

Hotpoint NTS M11 9X3E IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 8X3SKY IT Manual

13 December 2024
Hotpoint

Hotpoint NT M11 92WK IT Manual

13 December 2024
Hotpoint

Hotpoint EU NTDG92 SK IT Manual

12 December 2024
Hotpoint

Hotpoint NVL333EBCC Manual

29 September 2024
Hotpoint

Hotpoint H2D81WUK Manual

17 September 2024

Tørretumbler Manualer

Nyeste Tørretumbler Manualer

LG

LG RH90V9ZVEN Manual

19 December 2024
LG

LG TD-C70030EB Manual

19 December 2024
LG

LG RH80V5AV0N Manual

19 December 2024
Whirlpool

Whirlpool awz 8813 Manual

18 December 2024
Bosch

Bosch WTN832M1NL Manual

18 December 2024
Altus

Altus ADP80W Manual

17 December 2024
Ufesa

Ufesa Pro Ionic Style Manual

17 December 2024
Ufesa

Ufesa Pro Ionic-Shine Manual

17 December 2024
Haier

Haier HD100-A3959E-IT Manual

17 December 2024
Haier

Haier HD110-A3959E-IT Manual

17 December 2024