Hunter Outdoor Original 25602 Manual

Hunter Ventilator Outdoor Original 25602

Læs nedenfor 📖 manual på dansk for Hunter Outdoor Original 25602 (8 sider) i kategorien Ventilator. Denne guide var nyttig for 13 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/8
1
41556-01 8/08/03 © 2003 HUNTER F A N CO.
S I N C E 1 8 8
6
®
INSTALLATION INSTRUCTIONS FOR
HUNTER ORIGINAL® CEILING FANS
!
WARNINGS
!
To avoid possible electrical shock, before wir-
ing fan, disconnect power by turning off the cir-
cuit breakers both to the outlet box and to its
associated wall switch location. If you cannot
lock the circuit breakers in the “OFF” position,
securely fasten a prominent warning device,
such as a tag, to the service panel.
All wiring must be in accordance with national
and local electrical codes. If you are unfamiliar
with wiring, you should use a qualified electri-
cian.
To reduce the risk of personal injury, install the
fan to the building structure according to these
instructions and use only the hardware sup-
plied.
IMPORTANT!
READ AND SAVE THESE
INSTRUCTIONS!
!
CAUTIONS
!
NEVER REST THE FAN ON THE SWITCH HOUS-
ING. As you prepare the fan for installation, rest
the motor in the liner in which it was packed.
Be sure to put full contents of the oil tube into
the fan according to the instructions.
If this fan is used as a replacement for an Origi-
nal® Old-Tyme non-reversible fan, it must be in-
stalled per the instructions included with this
fan. Failure to do so could result in the fan fall-
ing. DO NOT HANG THIS FAN ON A SINGLE
“J” HOOK.
To reduce the risk of noise and to ensure proper
fan operation, do not use a solid-state speed
control with this fan. Use Hunter speed con-
trols for Hunter Original® ceiling fans only.
Do not use an abrasive cleaner on the fan. A
mild detergent will clean and restore most units
to their original beauty.
Installing Your Hunter® Ceiling
Fan
Note To Installers: Please leave this manual with
the home owner.
Tools needed:
• Pliers • 3/8” Socket Wrench
• Flat blade screwdriver • Phillips screwdriver
• Electric drill • 11/64” drill bit
• 4” x 1-1/2” standard octagon electrical box
Step 1: Pre-Installation
1. Select the installation site: Normally this is
near the center of the room, often replacing a light
fixture. Make certain that ample clearance is left
for the rotating fan blades. For maximum effi-
ciency, no obstructions (walls, posts, etc.) should be
within 24” of the tips of the blades. See Figure 1.
NOTE: Mounting should also meet the precautions listed
in Step 3.
Read this entire manual thoroughly before begin-
ning installation.
24”
Minimum
Clearance
7’ Minimum
Clearance To
Floor
8’Minimum
to Ceiling
Figure 1
2. Fan mounting height: Your Hunter fan
comes with the proper hardware to hang the fan
from a standard 8 foot ceiling so that the fan blades
will be 12” from the ceiling and approximately 7
feet from the floor. See Figure 1.
NOTE: On vaulted ceilings, up to 45° pitch, you must
use the Hunter Vaulted Ceiling Mounting Kit.


Produkt Specifikationer

Mærke: Hunter
Kategori: Ventilator
Model: Outdoor Original 25602

Har du brug for hjælp?

Hvis du har brug for hjælp til Hunter Outdoor Original 25602 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ventilator Hunter Manualer

Hunter

Hunter Fonthill Manual

12 November 2024
Hunter

Hunter Warrant Manual

12 November 2024
Hunter

Hunter Bennett Manual

11 November 2024
Hunter

Hunter Solaria 51476 Manual

25 September 2024
Hunter

Hunter Gilmour 51330 Manual

25 September 2024
Hunter

Hunter Havoc 59470 Manual

6 September 2024

Ventilator Manualer

Nyeste Ventilator Manualer

Be Cool

Be Cool BC121TU2201F Manual

19 November 2024
Emerio

Emerio FN-114204.11 Manual

16 November 2024
Ardes

Ardes Freddy AR5T75 Manual

16 November 2024
Midea

Midea FTS30-9BR Manual

16 November 2024
OK

OK OSF 4332 B RC Manual

16 November 2024
Biltema

Biltema 83-017 Manual

12 November 2024
Biltema

Biltema 83-021 Manual

12 November 2024
Biltema

Biltema 83-014 Manual

12 November 2024