Joranalogue Generate 3 Manual


Læs gratis den danske manual til Joranalogue Generate 3 (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 37 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 19 anmeldelser. Har du et spørgsmål om Joranalogue Generate 3, eller vil du spørge andre brugere om produktet?

Side 1/8
GENERATE 3
THROUGH-
ZERO MULTIPHONIC SIGNAL GENERATOR
1
INTRODUC TIO N
Any signal can be expressed in terms of a few
parameters: frequency, phase, amplitude and
timbre. It is through modulation of these aspects
that synthesists create electronic sound. With
Generate 3, it is now possible to create a signal
and control all its -parameters by through zero
modulation within a single 12 HP wide module.
Everything starts with the exceptionally precise
triangle-core voltage controlled oscillator (VCO)
at the module’s -heart. Through zero linear
frequency modulation (FM) enables rich yet
pitch-stable FM sounds, by allowing the oscillator
to run backwards into ‘negative frequencies’.
The resultant wave triangle is then processed by
the through -zero phase modulator, providing a
total phase shift range of 900°. Phase modulation
offers an interesting alternative for FM, as it
enables - deep FM type tones without actually
changing the oscillation frequency.
The timbre of a signal is determined by its
harmonic content. This full set of harmonics can
be grouped into three main parts: the
fundamental, even and odd harmonics.
Generate 3’s harmonics generator separates out
these three timbral ‘channels’. By adjusting their
relative amplitudes, a vast array of different
waveforms can be created, including but not
limited to the classic sine, saw and square waves.
While the amplitude adjusts can be ed manually,
each timbral channel -supports through zero
amplitude modulation, also known as balanced
or ring modulation. When -audio frequency
modulation signals are applied, the harmonics
become ‘split’, enriching the spectrum.
In addition to all the usual analogue synthesis
techniques, th set of modulation e extensive
options makes Generate 3 especially suited for
exploring multiphonic synthesis: a monophonic
source creating a complex timbre, much like
throat singing, yet by electronic means.
CONTENTS
In the Generate 3 box, you’ll find:
Product card, stating serial number and
production batch.
16- -10-to pin Eurorack power cable.
Mounting hardware: two black M3 x 6 mm
hex screws, two black nylon washers and a
hex key.
The Generate 3 module itself, in a protective
cotton bag.
If any of these items are missing, please contact
your dealer or support@joranalogue.com.
GENERATE 3
THROUGH-
ZERO MULTIPHONIC SIGNAL GENERATOR
2
CONTROLS & CONNECTIONS
1 R SWITCH FREQUENCY ANGE
This switch determines over which frequency
range Generate 3 will operate: low frequency
(VCLFO) or audio frequency (VCO).
2 F F K COARSE AND INE REQUENCY NOBS
The oscillation frequency is determined by these
knobs. In the audio frequency mode, with the
fine knob centred -and at default through zero
FM settings, the coarse knob has a range of 22 Hz
to 22 kHz at the fundamental signal output. The
f 5 6 ine knob’s range is % of the coarse knob (
semitones . in audio mode)
In low frequency mode, the total range is
2.8 6 180 mHz (a period of minutes) to Hz, with
1 Hz when both knobs are centred.


Produkt Specifikationer

Mærke: Joranalogue
Kategori: Ikke kategoriseret
Model: Generate 3

Har du brug for hjælp?

Hvis du har brug for hjælp til Joranalogue Generate 3 stil et spørgsmål nedenfor, og andre brugere vil svare dig