La Crosse Technology 30024 Manual


Læs nedenfor 📖 manual på dansk for La Crosse Technology 30024 (2 sider) i kategorien Wekkerradio. Denne guide var nyttig for 11 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Page 3 Page 4Page | 2
.9-inch LED Alarm Clock
with USB Charging Port
Model: 30024 & 30025
DC: 011419
POWER UP
1. Insert the 120 volt power cord into an outlet, then into your
clock. Optional: Insert one 9 volt battery for backup.
2. 12:00 will flash as an indication to set the time and/or alarm.
TIME SETTING
1. Continuously hold down the TIME button, then:
Press the HOUR button to set your hour.
Press the MINUTE button to set your minutes.
Note: The PM indicator will appear when you advance to PM time.
2. Release the TIME button when the correct time is shown on the
display.
USB CHARGING PORT
• Connect your external device’s USB charging cable
(not included) to the USB charging port.
• USB Power Output: 5V 1A maximum current.
• Charge devices that are self-regulating.
TIME ALARM
ON: Slide the ALARM ON/OFF switch to the ON position to turn
the alarm ON. The alarm light indicator will appear.
OFF: Slide the ALARM ON/OFF switch to the OFF position to turn
the alarm OFF. The alarm light indicator will disappear.
ALARM ON/O FF
1. Continuously hold down the ALARM button, then:
Press the HOUR button to set your hour.
Press the MINUTE button to set your minutes.
Note: The PM indicator will appear when you advance to PM time.
2. Release the ALARM button when the correct alarm time is set.
SNOO Z E
When the alarm sounds press the SNOOZE/LIGHT button to
silence the alarm for 10 minutes.
Snooze may be repeated.
Note: This is a Ascending alarm. It will sound with increased
frequency for 2 minutes then shut o if no buttons are pressed.
• Always purchase the correct size and grade of battery most
suitable for ntended use.
• Clean the battery contacts and also those of your clock prior to
battery installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from equipment when it is not used for an
extended period of time.
• Promptly remove an expired battery.
CARE & MAINTENANCE
BATTERY BACKUP
• Insert one “9V” battery into the battery compartment on the back
of the clock. The battery will keep the alarm and time settings
until the power is restored.
• The LED display will not light-up but the alarm will sound at the
preset alarm time.
• If there is no battery installed but the power is interrupted, the
display will flash at 12:00 and the time and alarm need to be set
again.
Power: 120V power cord
Requires one 9V battery for back-up not included
Dimensions: 5.00 ”W x 2.00”D x 2.85”H
POWER REQUI REMENTS
BACKLI GHT
Your backlight has three levels: High, Low , and Off.
Press the SNOOZE/LIGHT button to adjust.


Produkt Specifikationer

Mærke: La Crosse Technology
Kategori: Wekkerradio
Model: 30024

Har du brug for hjælp?

Hvis du har brug for hjælp til La Crosse Technology 30024 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Wekkerradio La Crosse Technology Manualer

Wekkerradio Manualer

Nyeste Wekkerradio Manualer

AudioSonic

AudioSonic CL-1498 Manual

9 September 2024
Lexon

Lexon Flip Manual

9 September 2024
Ditalio

Ditalio CR2 Manual

8 September 2024
MT Logic

MT Logic CL-1492MT Manual

7 September 2024
Lenco

Lenco KCR-9 Manual

7 September 2024
Muse

Muse M-179 P Manual

6 September 2024
Elta

Elta 4574 Manual

6 September 2024
Elta

Elta 4248N Manual

6 September 2024
Elta

Elta 4250N Manual

6 September 2024
Elta

Elta 4569 Manual

6 September 2024