LD Systems IE HP 2 Manual

LD Systems Hovedtelefoner IE HP 2

Læs nedenfor 📖 manual på dansk for LD Systems IE HP 2 (2 sider) i kategorien Hovedtelefoner. Denne guide var nyttig for 18 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

LD Systems® is a registered brand of the Adam Hall Group

Adam Hall GmbH | Adam-Hall-Str. 1 | 61267 Neu-Anspach | Germany

Phone: +49 6081 9419-0 | .com adamhall

IE HP 2

PROFESSIONAL IN-EAR HEADPHONES

INCLUDED:

• in-ear headphones with detachable cable, wire-reinforced cable ends and 3.5 mm stereo jack plug

Pin assignment:

• one pair each of silicon ear moulds in sizes S, M and L (M pre-installed)

• one pair each of foam ear moulds in sizes S, M and L (M pre-installed)

• carrying case

• user manual

OPERATION

Carefully install the correct-tting ear moulds for your ear canals to the headphone earpieces. The

ear moulds must be comfortable and secure in order to achieve optimum sound and optimum noise

reduction. Insert the in-ear headphones into the ear canal as shown, observing the markings R for right

and L for left on the inner sides of the earpieces. To ensure optimum freedom of movement, insert the

wire-reinforced cable ends behind the auricle, shape it to suit your requirements and run the cable

over your shoulder down your back. To replace the cable, disconnect the connection between the

special connector and the earpiece (separate connector and earpiece, do not pull on the cable). When

reconnecting, ensure that left and right sides remain in-situ and are not exchanged (see markings on

plug and earpiece). Using light pressure, push the gold plated connector into the gold-plated socket on

the earpiece, until the connector clicks into place.

SAFETY INFORMATION

1. Please read this manual carefully.

2. Keep all information and instructions in a safe place.

3. Follow the instructions.

4. Observe all warnings. Do not remove any safety instructions or other information from the device.

5. Use the device only in the prescribed manner.

6. Observe safety regulations applicable in your country during installation.

7. Do not place ignition sources such as burning candles on the device.

8. Do not use the device in the immediate vicinity of water (does not apply to special outdoor devices

– in this case, please observe the following special instructions). Do not bring the device into

contact with combustible materials, liquids or gases.

9. Ensure that dripping or splashing water cannot penetrate into the device.

10. Ensure that no objects are able to fall into the device.

11. Operate the device only with accessories of the type recommended and supplied by

the manufacturer.

12. Do not open the device and do not perform any modications.

13. After connecting the device, ensure that all cables are routed so as to avoid damage or accidents,

such as from tripping.

14. During transport, ensure that the device is unable to fall down and cause damage to property or

injury to persons.

15. If your device should no longer function properly, if liquids or foreign objects have penetrated it, or

the device has been damaged in any way, turn it off immediately and unplug it from the mains

socket (in so far as this relates to an active device). The device may be repaired only by authorised

repair technicians.

16. Use a dry cloth to clean the device.

17. Observe all disposal laws applicable in your country. Please dispose of the plastic and paper or

cardboard packaging separately.

18. Product, packaging and accessories must be kept out of the reach of children and pets to prevent

accidents and avoid risk of asphyxiation.

CAUTION: HIGH VOLUME AUDIO PRODUCTS!

This device is designed for professional use. The commercial operation of this device is

subject to the applicable national regulations and guidelines for accident prevention. As

the manufacturer, Adam Hall is legally obliged to inform you explicitly of potential health

risks. Hearing damage caused by high volumes and long-term exposure: When using this

product, high sound pressure levels (SPL) can be created that could lead to irreparable

hearing damage. Avoid prolonged exposure to high volume levels over 90 dB. In order to

prevent possible hearing damage, avoid listening at high volume levels for long periods.

Even for short periods, loud sounds can cause hearing damage. Please always keep the

volume at a pleasant level.

CAUTION! DANGER TO LIFE

Do not use in-ear headphones in trafc (while driving or as a pedestrian) or in situations

where hearing must not be impeded (e.g. on a construction site). Acoustic perception is

drastically impaired by in-ear headphones.

HEALTH RISK!

Clean the ear moulds at regular intervals to prevent the formation of bacteria and minimi-

se the risk of ear infection. Do so by removing the ear moulds from the headphones and

cleaning them with soapy water. Allow the ear moulds to dry completely before reuse.

Model name: LDIEHP2

Product type Headphones

Type Stereo-In-Ear Headphones

Frequency response 20 - 18000 Hz

Converter principle Dynamic

Impedance 32 Ohm(s)

Connection type 3.5 mm TRS

Cable length 1.55 m (separable)

Weight 0.022 kg

Accessories (included) 3 pairs of foam earpieces, 3 pairs of silicone earmolds, Transport case

Optional accessories Spare cable LDIEHP2CABLE

SPECIFICATIONS

Produkt Specifikationer

Mærke:	LD Systems
Kategori:	Hovedtelefoner
Model:	IE HP 2

Har du brug for hjælp?

Hvis du har brug for hjælp til LD Systems IE HP 2 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Hovedtelefoner LD Systems Manualer

LD Systems IE HP 2 Manual

3 September 2024

LD Systems HP 800 PRO Manual

26 Juli 2024

Hovedtelefoner Manualer

Nyeste Hovedtelefoner Manualer

Celly Sparco SPHEADPHONEPRO Manual

24 December 2024

Adam Studio Pro SP-5 Manual

24 December 2024

24 December 2024

24 December 2024

24 December 2024

24 December 2024

24 December 2024

Marshall Major V Manual

24 December 2024

Defender FreeMotion B695 Manual

24 December 2024

Kogan KAOEBCSHSRB Manual

23 December 2024