Erasing the Car2U Home Automation System buttons姞
Note: The system allows for three devices to be programmed. If you
need to change or replace any of the three devices after it has been
initially programmed, it will be necessary to erase the current settings
using the procedure below and then reprogramming all of the devices
being used.
To erase programming on the Car2U system (individual buttons cannot威
be erased), use the following procedure:
1. Firmly press the two outside Car2U system威
buttons simultaneously for approximately
20 seconds until the indicator lights begin to
blink rapidly. The indicator lights are located
directly above the buttons.
2. Once the indicator lights begin to blink,
release your fingers from the buttons. The
codes for all buttons are erased.
If you sell your vehicle equipped with the Car2U system, it is威
recommended that you erase the programming for security reasons.
FCC and RSS-210 Industry Canada Compliance
The Car2U system complies with Part 15 of the FCC rules and with威
RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received including interference
that may cause undesired operation.
Changes and modifications to the Car2U system transmitter by other威
than an authorized service facility could void authorization to use the
equipment.
6