Mean Well MSP-100-12 Manual


Læs nedenfor 📖 manual på dansk for Mean Well MSP-100-12 (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 15 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Installaon Manual
Type
Enclosed Type Switching Power Supply
(Families: G3, NE, LRS, SE, PFC, HSP, SPV, USP, RST, G5, MSP)
Introducon
Enclosed type switching power supplies possess a metal or plasc case for covering their internal PCB and will be
installed inside the case of the end system. Mean Well’s enclosed type power supplies include 2 dierent groups of
power supplies, with built-in fan and without built-in fan, depending on their rated power or design concept.
Installaon
( )1 Before any installaon or maintenance work, please disconnect your system from the ulity.
Ensure that it can’t be re-connected inadvertently!
( )2 Keep enough insulaon distance between mounng screws and internal components of power supplies. Please
refer to case drawing on specicaons to receive the maximum length of mounng screw.
( )3 Mounng orientaons other than standard orientaon or operate under high ambient temperature may
increase the internal component temperature and will require a de-rang in output current. Please refer to
the specicaon sheets to receive the opmum mounng posion and informaon about the -rang curve. de
( )4 Fans and venlaon holes must be kept free from any obstrucons. Also a 10-15 cm clearance must be kept
when the adjacent device is a heat source.
( )5 Recommended wires are shown as below.
AWG
18
16
14
12
10
8
Rated Current of
Equipment (Amp)
6A
6-10A
10- 16A
16 25A-
25 32A-
32 40A-
Cross-secon of
Lead(mm
2 )
0.75
1.00
1.5
2.5
4
6
Note: Current each wire carries should be de-rated to 80% of the current
suggested above when using 5 or more wires connected to the unit.
Make sure that all strands of each stranded wire enter the terminal connecon and the screw terminals are
securely xed to prevent poor contact.
( )6 For other informaon about the products, please refer to www.meanwell.com for details.
Warning / Cauon !!
( )1 Risk of electrical shock and energy hazard. All failure should be examined by a qualied technician. Please do
not remove the case of the power supply by yourself!
( )2 Please do not install power supplies in places with high moisture or near the water.
( )3 Please do not install power supplies in places with high ambient temperature or near re source. The
maximum ambient temperature please refer to their specicaons.
( )4 Output current and output waage must not exceed the rated values on specicaons.
( )5 The ground(FG) must be connected to earth ground.
( )6All MW’s PSUs are designed in accordance with EMC regulaons and the related test reports are available by
request. Since they are belong to component power supplies and will be installed inside system enclosure,
when they are integrated into a system, the EMC characteriscs of the end system must be re-veried again.


Produkt Specifikationer

Mærke: Mean Well
Kategori: Ikke kategoriseret
Model: MSP-100-12

Har du brug for hjælp?

Hvis du har brug for hjælp til Mean Well MSP-100-12 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Mean Well Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Wagner

Wagner 2K Smart Manual

4 November 2024
Moen

Moen EB500-E Manual

3 November 2024
Moen

Moen Aspen 5824CH Manual

3 November 2024
Luxman

Luxman MQ-88uSE Manual

3 November 2024
Luxman

Luxman CL-38uSE Manual

3 November 2024
Luxman

Luxman CL-1000 Manual

3 November 2024
Moen

Moen Aspen 5802CH Manual

3 November 2024
Luxman

Luxman SQ-38u Manual

3 November 2024
Moen

Moen Aspen 5818CH Manual

3 November 2024