Mean Well RSD-200D-24 Manual


Læs nedenfor 📖 manual på dansk for Mean Well RSD-200D-24 (3 sider) i kategorien niet gecategoriseerd. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/3
Installaon Manual
Type
DC-DC converter Families PSD, SD, RSD
Introducon
A DC-DC converter is a device used to convert a DC source from one voltage level to another. Mean Well’s DC-DC
converters equipped with internal EMI lter stage that possess the required EMC performance.
Installaon
( )1Before commencing any installaon or maintenance work, please disconnect your system from the
ulity. Ensure that it cannot be re-connected inadvertently!
( )2For PCB type, at least 5mm insulaon distance around the unit should be kept.
( )3Allow good venlaon for the unit in use to prevent it from overheang. Also, a 10-15 cm clearance
must be kept when the adjacent device is a heat source.
( )4Mounng orientaons other than standard orientation or operate under high ambient temperature
may increase the internal component temperature and will require a de-rang in output current.
Please refer to the specicaon sheets to receive opmum mounng posion and informaon the
about the -rang curve.de
( )5Recommended input/output wires are shown as below.
AWG
18
16
14
12
10
8
Rated Current of
Equipment (Amp)
6A
6-10A
10- 16A
16 25A-
25 32A-
32 40A-
Cross-secon of
Lead(mm2 )
0.75
1.00
1.5
2.5
4
6
Note: Current each wire carries should be de-rated to 80% of the current
suggested above when using 5 or more wires connected to the unit.
( )6For PCB type, compable mang housing please refers to the specicaons
( )7 For enclosed type, make sure that all strands of each stranded wire enter the terminal connecon and the
screw terminals are securely xed to prevent poor contact.
( )8 For other informaon about the products, please refer to www.meanwell.com for details.
Warning / Cauon !!
( )1Risk of electrical shock and energy hazard. All should be examined by a qualied technician. failure
Please do not try to x the converter by yourself!
( )2Risk of irreparable damage. Do not reverse polarity, both input and output.
( )3Please do not install converters in places with high moisture or near the water.
( )4Please do not install converters in places with high ambient temperature or near re source. Please
refer to the specicaons about the maximum ambient temperature limitaons.
( )5Output current and output waage must not exceed the rated values on specicaons.
( )6The ground (FG) must be connected to earth ground.
( )7For system consideraons, PCB and enclosed type converters may require an addional inrush
current liming circuit to suppress high inrush current surges. If you are uncertain about that circuit,
contact Mean Well.
( )8 All of an WellMe ’s converters are designed in accordance with EMC regulaons and the related test reports
are available by request. Since they are belong to component power supplies and will be installed inside
system enclosure, when they are integrated into a system, the EMC characteriscs of the end system must be
re-veried again.


Produkt Specifikationer

Mærke: Mean Well
Kategori: niet gecategoriseerd
Model: RSD-200D-24

Har du brug for hjælp?

Hvis du har brug for hjælp til Mean Well RSD-200D-24 stil et spørgsmål nedenfor, og andre brugere vil svare dig




niet gecategoriseerd Mean Well Manualer

niet gecategoriseerd Manualer

Nyeste niet gecategoriseerd Manualer

IFM

IFM O6T207 Manual

16 September 2024
Güde

Güde LG 18-30 Manual

16 September 2024
Uniden

Uniden WPP 15W + D800 Manual

16 September 2024
JUNG

JUNG BTCCD508 Manual

16 September 2024
Samsung

Samsung AC036TN4PKC Manual

16 September 2024
Nedis

Nedis ACON2503AT Manual

16 September 2024
SVAN

SVAN SVTE050 Manual

16 September 2024
IFM

IFM EVC085 Manual

16 September 2024
IFM

IFM EVM042 Manual

16 September 2024
Denver

Denver VR-20 Manual

16 September 2024