Microchip MD0101 Manual


Læs nedenfor 📖 manual på dansk for Microchip MD0101 (16 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/16
2020 Microchip Technology Inc. DS20005916A-page 1
MD0101
Features
Up to ±100V Input Voltage Protection
Low On-Resistance, 15Ω Typical
Integrated Clamp Diodes
Fast Switching Speed
Four Electrically Isolated Channels
No External Supplies Needed
Applications
Medical Ultrasound Imaging
Non-Destructive Testing Applications
Fast Resettable Fuses
High-Side Switches
Data Acquisition
General Description
The MD0101 is a four-channel high-voltage
current-limiting protection device. It is designed to
protect a low-noise receiver from high-voltage transmit
pulses in ultrasound applications and is commonly
referred to as a T/R (transmit-and-receive) switch.
Each channel has three terminals: TX, RX, and R
GND.
The analog switch terminals are TX and RX. RX has
integrated clamping diodes to RGND to protect the
receiver against high voltages. The output voltages will
be clamped by the anti-parallel diodes to RGND at
about ±0.6V.
The MD0101 can be considered as a normally closed
switch with a typical switch resistance of 15Ω, allowing
small signals to pass. Once the voltage drop across the
switch exceeds a nominal value of ±1V, the device
turns off. In the OFF state, the MD0101 can withstand
up to ±100V across its terminals. A small amount of
current (200 µA, typically) is allowed to flow through.
The MD0101 is not limited to just ultrasound
applications. It can also be used as resettable fuses to
protect power lines, for output short-circuit protection,
and for protection of data acquisition instruments. The
MD0101 is available in an 18-lead, 5 x 5 mm DFN
package.
Package Type
18-lead DFN
(Top view)
See Table 2-1 for pin information.
1
2
3
4
5
6
7
8
9
18
17
16
15
14
13
12
11
10
NC
Rx1
RGND1
Rx2
RGND2
Rx3
RGND3
Rx4
RGND4
NC
Tx1
NC
Tx2
NC
Tx3
NC
Tx4
NC
High-Voltage Protection T/R Switch with Clamp Diodes


Produkt Specifikationer

Mærke: Microchip
Kategori: Ikke kategoriseret
Model: MD0101

Har du brug for hjælp?

Hvis du har brug for hjælp til Microchip MD0101 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Microchip Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Märklin

Märklin 72886 Manual

24 Januar 2025
Märklin

Märklin 72797 Manual

24 Januar 2025
Märklin

Märklin 7001 Manual

24 Januar 2025
Hilti

Hilti KCC-WF Manual

24 Januar 2025
Märklin

Märklin 7051 Manual

24 Januar 2025
ATen

ATen KH1516Ai Manual

24 Januar 2025
Adonit

Adonit PD-3A2C Manual

24 Januar 2025
Adonit

Adonit Dash 4 Manual

24 Januar 2025