Midland LXT500VP3 Manual


Læs nedenfor 📖 manual på dansk for Midland LXT500VP3 (4 sider) i kategorien Walkie-talkies. Denne guide var nyttig for 26 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
Welcome to the world of Midland electronics
Congratulations on your purchase of a high quality MIDLAND
product. Your 2-way radio represents state-of-the-art high-tech
engineering. Designed for FRS (Family Radio Service) operation, this
compact package is big on performance. It is a quality piece of
electronic equipment, skillfully constructed with the finest
components. The circuitry is all solid-state and mounted on a rugged
printed circuit board. Your two-way radio is designed for reliable and
trouble-free performance for years to come.
Features
- 22 FRS Channel
- Call Alert
- Scan Function
- Roger Beep Tone
- Silent Operation
- Keypad Lock
- Power HI/LO Settings
- Auto Squelch
- Speaker / Microphone Jacks
- Battery Life Extender
- Battery Low Indicator
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device does not
cause harmful interference, and (2) this radio must accept any
interference that may cause undesired operation.
To maintain compliance with FCC’s RF exposure guidelines, for
body-worn operation, this radio has been tested and meets the
FCC RF exposure guidelines when used with Midland Radio
Corp. accessories supplied or designated for this product. Use of
other accessories may not ensure compliance with FCC RF
exposure guidelines.
LCD DISPLAY
1. LOW BATTERY ICON Indicates the
battery level is low.
2. TRANSMIT (TX) ICON Indicates
radio is transmitting a signal.
3. CHANNEL NUMBER Changes from
1~22 on FRS band.
4. KEY LOCK ICON Indicates KEY
LOCK mode is on.
5. RECEIVE (RX) ICON Indicates
radio is receiving a transmission.
6. TRANSMIT POWER LEVEL ICON
Indicates TX Power setting (H/L)
1
CONTROLS
7. PTT Button Press and hold to
transmit voice communication.
8. CALL/LOCK Button Press to send
a CALL Alert signal. Press and hold to
turn KEY LOCK on/off.
9. MIC Built-in microphone.
10. SPEAKER Built-in speaker.
11. ANTENNA
12. EXTERNAL SPEAKER/MIC/CHG.
JACK
13. POWER / MENU Button Press and
hold for at least 3 seconds to turn the
radio on/off. Press momentarily to
access Menu mode.
14. SCAN Button Press to enter SCAN
mode.
15. UP s
s
s
ss and DOWN t
t
t
tt Buttons
Make adjustments in MENU mode.
14
13
12
10
9
8
7
6
5
4
3
2
11
BATTERY INSTALLATION
Your radio operates with either a NiMH battery pack or optional 4 AAA
alkaline batteries. The belt clip should be removed to ease installation or
removal of the batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see
diagram on the next page) for easy access, then remove the Battery
Cover by pressing down on the top center and sliding it down from the
radio.
2. Insert 4 AAA batteries observing the polarity as shown. Installing
the batteries incorrectly will prevent the unit from operating or may
damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the
belt clip, making sure it locks into place.
15
MIDLAND RADIO CORPORATION
MIDLAND RADIO CORPORATION
MIDLAND RADIO CORPORATION
MIDLAND RADIO CORPORATIONMIDLAND RADIO CORPORATION
5900 Parretta Drive
Kansas City, MO 64120
Call 816.241.8500
We’d love to hear from you! Let us know what you
think of your new Midland product on
or by visiting us at
midlandusa.com
Note: Features & Specifications are subject to change without
notice. MIDLAND is not responsible for unintentional errors or
omissions on its packaging.
BATTERY
COMPARTMENT
BATTERY
COMPARTMENT
COVER
Press here and
push down to open
BELT CLIP
LOCK TAB
BELT CLIP
LATCH
INSTALLING THE BELT CLIP
To install the BELT CLIP, slide the clip up into the slot on the back of
the radio until the BELT CLIP LATCH clicks. To remove the BELT
CLIP LOCK TAB, press the up, then gently pull the belt clip down
toward the bottom of the radio.
CHARGING THE BATTERY PACK
Your radio is equipped to use a rechargeable NiMH battery pack
which can be recharged with the optional desktop charger (as
described below). The radio can also be charged by inserting the AC
adapter into the radio charge jack. Initial charge time is 24 hours.
Charge time is about 12 hours thereafter. For maximum battery life,
we recommend charging the battery pack when the low battery icon
comes on. Remove the radios from the charger when the charge time
expires.
To charge using a Desktop Charger:
1. Place the rechargeable battery packs in the radios.
2. Connect the AC adapter into an AC wall outlet.
3. Insert the AC adapter plug (or DC Cigarette Lighter adapter if
charging in vehicle) into the desktop charger jack.
4. Place the units into the desktop charger slot and note that the LED
indicator with color will light up, indicating charging function. RED
In order to ensure that the battery pack is fully charged, it is
recommended that the battery pack be charged for at least 12
hours with the radio turned OFF.
1. Only use our NiMH battery pack and AC adapter.
2. Do not attempt to charge alkaline batteries or any batteries
or battery packs other than the one indicated in the manual.
This may cause leakage and damage to the radio.
3. For long term storage of the radio, turn the radio OFF and
remove the batteries from the radio.
LOW BATTERY LEVEL INDICATOR
When the battery voltage gets low, the LOW BATTERY ICON
will blink along with the message ” on the display. When usingbt Lo
the rechargeable battery pack, the low battery icon will indicate that
you are very close to the batteries being exhausted. When using AAA
Alakaline batteries, the low battery icon means you have about 50%
of battery life remaining.
!
POWER ON/OFF AND VOLUME
Press the button for at least 3 seconds to turn thePOWER/MENU
radio on/off. During Power On, the radio will beep 3 times with
different tones, the LCD will display all icons for 1 second and the
LCD display will indicate the last channel selected.
To increase/decrease the volume level, press the s
s
s
ss t
t
t
tt\buttons
during or RX STANDBY mode.
TRANSMITTING AND RECEIVING A CALL
To communicate, all radios in your group must be set to the same
channel.
1. For maximum clarity, hold the radio at least 1 inch (2.5 cm) from
your mouth.
2. Press and hold the button and speak in a normal voice PTT
into the icon will appear continuously on microphone. The TX
the LCD display while transmitting.
3. To receive a call, release the icon will appearPTT button. The RX
on the display when your radio is receiving a transmission.
OPERATING YOUR RADIO
ABOUT RANGE
Your LXT Series radios are designed to give you maximum range
under optimum conditions.
Optimum Conditions are:
lOver water
lOpen rural areas without obstructions
lFlat areas where you can see the other person
To ensure you get maximum range:
lBe sure to use fresh or fully charged batteries - low batteries will
cause low power conditions.
lBe sure to set your radio to use Hi power.
LXT Series QUICK REFERENCE CHART
SCAN
Your radios can scan all 22 channels for activity. To enter, quickly
press the button. Repeat the same procedure to exit. YourSCAN
radio will rapidly scan each of the 22 channels and stop on any active
channel for 4 seconds before resuming scan.
When you press the button to transmit on an active channel, thePTT
scanning function will stop and remain on the active channel. To
resume scanning, quickly press the SCAN button.
MENU Channel
1~22
Roger Beep
On/Off
Power
H/L
Silent Operation
On/Off
Rev J
IMPORTANT NOTICE
Exposure To Radio Frequency Energy
Your Midland radio is designed to comply with the following national and
international standards and guidelines regarding exposure of human
beings to radio frequency electromagnetic energy:
- United States Federal Communications Commission, Code of Federal
Regulations: 47 CFR part 2 sub-part J
- American National Standards Institute (ANSI)/Institute of Electrical &
Electronic Engineers (IEEE) C95. 1-1992
- Institute of Electrical and Electronic Engineers (IEEE) C95. 1-1999
Edition
- National Council on Radiation Protection and Measurements (NCRP) of
the United States, Report 86, 1986
- International Commission on Non-lonizing Radiation Protection
(ICNIRP) 1998
To control your exposure and ensure compliance with the general
population or uncontrolled environment exposure limits, transmit no more
than 50% of the time. The radio generates measurable RF energy
exposure only when transmitting.
Body-Worn Operation
If you wear the radio on your body when transmitting always use Midland-
supplied or approved belt clip, holster, case, or body harness for this
product. Use of any accessories not supplied or approved by Midland may
exceed FCC/Health Canada RF exposure guidelines. If you do not use
any accessories supplied or approved by Midland, ensure the radio and
its antenna are at least 1 inch (2.5cm) from your body when
transmitting.


Produkt Specifikationer

Mærke: Midland
Kategori: Walkie-talkies
Model: LXT500VP3

Har du brug for hjælp?

Hvis du har brug for hjælp til Midland LXT500VP3 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Walkie-talkies Midland Manualer

Midland

Midland ALAN 37 Manual

31 August 2024
Midland

Midland G14 Manual

24 August 2024
Midland

Midland BT Ski Manual

20 August 2024
Midland

Midland G8E-BT Manual

19 August 2024
Midland

Midland BTEva Manual

15 August 2024
Midland

Midland G11V Manual

14 August 2024
Midland

Midland XT60 Manual

7 August 2024
Midland

Midland BT2 Manual

3 August 2024

Walkie-talkies Manualer

Nyeste Walkie-talkies Manualer

Audioline

Audioline PMR 46 Manual

13 Oktober 2024
Denver

Denver WTA-448 Manual

4 Oktober 2024
GoGen

GoGen BOB VYSILACKY Manual

30 September 2024
Cobra

Cobra MicroTalk CXT545 Manual

27 September 2024
Motorola

Motorola Mag One BPR40 Manual

24 September 2024
DeTeWe

DeTeWe Outdoor 8500 Manual

20 September 2024
Alecto

Alecto FR-58 Manual

17 September 2024
Alecto

Alecto FR175BW Manual

13 September 2024