Miele WDB030 Eco Manual

Miele Vaskemaskine WDB030 Eco

Læs nedenfor 📖 manual på dansk for Miele WDB030 Eco (4 sider) i kategorien Vaskemaskine. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/4

WDB 030 en - AU, NZ M.-Nr. 10 832 550/00

Before the first use Operating the washing machine

OPERATING THE WASHING MACHINE

Washing

WASHING

Changing the programme sequence

CHANGING THE PROGRAMME SEQUENCE

Programme chart

1 2

ɉBefore using the machine for the first

time, ensure that it is correctly installed

and connected. Please read the separate

operating instructions supplied with the

appliance.

For safety reasons, spinning is not possible

until the machine has been prepared for use

for the first time. To activate the spinning

function, you must run a wash programme

without laundry and without detergent.

Using detergent could result in an exces-

sive build-up of foam.

This also activates the ball valve. The ball

valve prevents detergent escaping from the

suds container into the sump during a wash

programme, thus making maximum use of

the detergent.

Running the first programme

ĺTurn on the tap.

ĺTurn the programme selector to .Cottons

The washing machine is now switched on

and in the control panel, the temperature

60°C lights up.

ĺTouch the sensor.Start/Stop

The programme will start and the symbol 

lights up in the control panel.

After the end of the programme

The symbol lights up in the control panel; 

 : appears in the time display and the

drum occasionally rotates.

ĺTouch the sensor.Start/Stop

The door will be unlocked.

ĺReach under the door grip and pull the

door open.

ĺWhen the programme has ended, turn

the programme selector to .

Note: For safety reasons close the door.

Washing environmentally and economically

–To make the most out of your machine,

load the maximum dry load for the pro-

gramme you are using.

–When smaller amounts of laundry are

washed, the automatic load recognition

system will reduce the amount of water

and energy used.

–Use the programme for Express 20

small, lightly soiled loads.

–Modern detergents enable washing at

reduced temperatures (e.g. 20°C). Use

appropriate temperature settings for

saving energy.

–Reduce the amount of detergent with

smaller loads (approx. ⅓ less than the

amount recommended can be used

when washing a half load).

–Selecting the highest possible spin

speed for the wash programme will

save energy when drying in a tumble

dryer afterwards.

1. Preparing the laundry

ĺEmpty all pockets.

ɉForeign objects (e.g. nails,

coins, paper clips, etc.) can

cause damage to garments and

components in the machine.

ĺSort the laundry by colour and by care label. Most gar-

ments have a textile care label in the collar or side seam.

ĺPre-treat stains and badly soiled areas (see the booklet

"Miele's guide to laundry care").

2. Loading the washing machine

Opening the door

ĺReach under the door grip and

pull the door open.

ĺUnfold the laundry and load

loosely in the drum.

Closing the door

ĺMake sure that no items are

caught between the door and

the seal.

ĺShut the door with a gentle

swing.

1 Detergent dispenser drawer

2 Control panel

3 Access to drain filter, drain pump

and emergency release

4 Door

3. Selecting a programme

The washing machine is switched on by turning the pro-

gramme selector to a wash programme.

Programme selection

ĺTurn the programme selector

to the required programme.

The likely wash time is shown in the time display and the

pre-set temperature and spin speed light up in the con-

trol panel.

Selecting a temperature/spin speed

The wash programme's pre-set temperature and spin

speed light up brightly. The choice of temperatures and

spin speeds selectable for the wash programme light up

dimly.

ĺTouch the sensor for the tem-

perature you want. It then

lights up brightly.

ĺTouch the sensor for the spin

speed you want. It then lights

up brightly.

Selecting Extra options

The selection of Extras available for the wash programme

lights up dimly.

ĺTouch the sensor for the Extra

you want. It then lights up

brightly.

Useful tip: You can select multiple Extras for a wash

programme.

4. Adding detergent

There are several options for adding deter-

gent.

Detergent dispenser drawer

ĺPull out the

detergent drawer

and add

detergent to the

compartments.

Detergent for the pre-wash

Detergent for the main wash,

including Soak if selected

 /  Fabric softener, liquid starch or

capsules

CapDosing

Three different types of capsules are avail-

able:

Fabric care (e.g. fabric conditioner)

Additives (e.g. detergent enhancers)

Detergent

See "Detergent" in the operating instruc-

tions for more information.

5. Starting the programme

ĺTouch the flashing sensor.Start/Stop

The door will lock (the symbol will appear 

in the control panel) and the programme will

start.

6. At the end of the programme

The time display shows : . The sym-  

bol will remain lit up in the control panel.

The door is locked in the anti-crease phase.

ĺTouch the sensor.Start/Stop

ĺThe door unlocks and the symbol in 

the control panel goes out.

ĺPull open the door.

ĺRemove the laundry.

ɉCheck that all items have been

removed from the drum.

ĺCheck the folds

in the door seal

for any small

articles, e.g.

buttons, which

might be lodged

there.

ĺTurn the programme selector to the 

position. This switches the washing

machine off.

ĺIf applicable, remove the used capsule

from the detergent dispenser drawer.

ĺClose the door. Otherwise there is a dan-

ger of objects being placed inadvertently

in the drum. If these remain unnoticed

and were washed in the next load, they

could damage the laundry. An open door

is also a danger to pets and children.

Programme

Load

(inkg) Temperature Items Extras

Cottons 7.0 60°C⁄40°C Normally soiled cotton garments , , , 

Cottons 7.0 Cold to 90°C Cottons, linens or cotton mix fabrics, e.g. table linen, towelling,

underwear, T-shirts etc.

, , , 

Minimum iron 3.5 Cold to 60°C Synthetic, mixed fibre and easy care cotton , , , 

Delicates 2.0 Cold to 40°C Delicate garments made from synthetic fibre, mixed fibre, rayon

and viscose

, , , 

Woollens 2.0 Cold to 40°C Machine-washable or hand-washable wool or wool blend fabric

Shirts Cold to 60°C Shirts and blouses made of cotton and mixed fibre , , , 

Express 20 3.5 Cold to 40°C Cotton garments that have hardly been worn or are only very

lightly soiled.



Dark garments/

Denim

3.0 Cold to 60°C Black and dark garments made from cotton, mixed fibres and

denim

, , , 

Outerwear 2.5 Cold to 40°C Performance outerwear (e.g. jackets and trousers) made from

membrane fabric such as Gore-Tex®, SYMPATEX®, WIND-

STOPPER® etc.

, , , 

Proofing 2.5 40°C Treating microfibre fabric, skiwear and table linen made from

mainly synthetic fibres.

Drain/Spin 7.0 Drain only: Select for the spin speed.

Separate rinse/

Starch

7.0 For rinsing hand-washed items

Starching table cloths, serviettes and workwear



   = Short; = Water plus; = Pre-wash; = Soak

1 Control panel

2 Sensor controls - temperature

for selecting the temperature

3 Sensor controls - spin speed

for selecting the spin speed

4 Sensor controls - Extras

various options can be added to the

wash programmes

5 Indicator lights 

 = Fault with the water inlet or

drainage

 = Excess detergent was used

 = Hygiene information

 = Flashing: Laundry can be added

Lit up constantly: Door of the

washing machine is locked

6 CapDosing sensors

 = Fabric care (e.g. fabric conditioner)

 = Additives (e.g. detergent

enhancers)

 = Detergent (for the main wash only)

7 Time display

After the programme has started, the

programme duration will appear in the

display in hours and minutes.

8 Sensor controls   

for the Delay start function

9 Start/Stop sensor

Touching the Start/Stop sensor starts the

selected programme or cancels a pro-

gramme that has already been started.

The sensor flashes slowly as soon as it is

possible for a programme to be started

and then lights up constantly after the

programme has started.

10 Optical interface

for service technicians

11 Programme selector

for selecting programmes and for switch-

ing off. The washing machine is switched

on by selecting a programme, and

switched off by turning the programme

selector to the position.

Changing a programme

After the successful start of a programme

it is no longer possible to select a different

programme.

If you would like to change the programme

or add/remove laundry, you have to cancel

the programme.

Cancelling a programme

You can cancel a programme at any time

after it has started.

ĺTouch the sensor.Start/Stop

The water is pumped away and the time

display changes to : . As soon as the   

symbol in the control panel goes out, the

programme has been cancelled and the

door can be opened.

Selecting a different programme after

cancelling the programme

ĺOpen the door.

ĺClose the door.

ĺCheck that there is still detergent in the

dispenser drawer. Add more detergent if

necessary.

ĺTurn the programme selector to the pro-

gramme you want and start it by touching

the sensor.Start/Stop

Removing laundry after cancelling the

programme

If you want to remove the laundry when it is

dripping wet:

ĺOpen the door.

ĺRemove the laundry.

If you want to remove the laundry

after it has been spun (damp):

ĺOpen the door.

ĺClose the door.

ĺTurn the programme selector to Drain/

Spin.

Useful tip: Select an appropriate spin

speed.

ĺTouch the sensor.Start/Stop

The laundry is spun and can be removed

damp after spinning.

Interrupting a programme

ĺTurn the programme selector to the 

position.

The washing machine switches off.

ĺTo continue: Turn the programme selector

to the position of the wash programme

that was started.

Useful tip: If appears in the time dis-

play, the programme selector is in the incor-

rect position.

Adding or removing laundry

You can add or remove laundry at the start

of a wash programme as long as the 

symbol is flashing in the control panel.

ĺBriefly touch the Start/Stop sensor.

The programme will stop and the door will

unlock.

ĺPull open the door.

ĺAdd or remove items.

ĺClose the door.

ĺTouch the Start/Stop sensor.

The wash programme will continue.

Produkt Specifikationer

Mærke:	Miele
Kategori:	Vaskemaskine
Model:	WDB030 Eco

Har du brug for hjælp?

Hvis du har brug for hjælp til Miele WDB030 Eco stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Vaskemaskine Miele Manualer

Miele WED 325 WCS PWash Manual

19 Oktober 2024

Miele Top Electronic W720 Manual

1 Oktober 2024

Miele WS 5141 Manual

30 September 2024

Miele W 151 F Manual

27 September 2024

Miele W 3825 WPS Manual

12 September 2024

Miele G 7114 SC AutoDos Manual

9 September 2024

Miele WDB030 Eco Manual

9 September 2024

Miele W 852 Manual

7 September 2024

Miele W 5846 Manual

6 September 2024

Miele W 254 Manual

3 September 2024

Vaskemaskine Manualer

Nyeste Vaskemaskine Manualer

Nabo WM 1600 Manual

21 November 2024

Otsein LB LTO129A Manual

20 November 2024

SanGiorgio ST6512EL Manual

20 November 2024

SanGiorgio FS614D9 Manual

20 November 2024

SanGiorgio PROGETTO F4 Manual

20 November 2024

SanGiorgio SG710 Manual

20 November 2024

SanGiorgio F814DIBC Manual

20 November 2024

SanGiorgio F812D Manual

20 November 2024

SanGiorgio S5510C Manual

20 November 2024

SanGiorgio F812L Manual

20 November 2024