Palmer AoC Box XLRm Manual

Palmer Ikke kategoriseret AoC Box XLRm

Læs nedenfor 📖 manual på dansk for Palmer AoC Box XLRm (6 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/6
Palmer® is a registered brand of the Adam Hall Group
Adam Hall GmbH | Adam-Hall-Str. 1 | 61267 Neu-Anspach | Germany
Adam Hall Ltd. | The Seedbed Bus. Centre | SS3 9QY Essex | UK
info@adamhall.com | .comadamhall
Designed and engineered in Germany, assembled in P.R.C.
PAOCBXLRM
AUDIO OVER CAT BOX FROM ETHERCON TO 4 × XLR MALE
INTRODUCTION
This Palmer AoC product was developed to transmit audio signals reliably
over long distances without loss or hum via Cat cable. Up to four bal-
anced analogue channels or up to eight channels in digital AES3 format
can be transmitted. The compact and modular design is suitable for a
wide range of applications in the studio, on stage and in permanent instal-
lations. This product is suitable for use with phantom power. Preferably use
balanced cables for analogue signal transmission, as these are significant-
ly less susceptible to interference than unbalanced cables. Digital signal
transmission in AES3 format requires balanced cabling.
CONNECTIONS
Plug a shielded Cat cable (Cat5e or better) with etherCON plugs (or com-
patible) into the etherCON INPUT socket and connect the other end of the
cable to another Palmer AoC Box (e.g. PAOCBXLRF), a Palmer AoC Loom
or another suitable Palmer device with AoC interface (or other devices
with AES72 type 5E pin assignment). The second etherCON socket THRU is
intended for forwarding the signals.
LIFT / GND: Switch for disconnecting the ground connection of AoC INPUT
and AoC THRU (switch position LIFT = ground disconnected). The ability
to prevent a humming loop using the ground lift switch depends on the
grounding of the connected devices. It is therefore possible that either
switch position effectively reduces or eliminates humming.
Connect the male XLR sockets 1 to 4 to the balanced inputs of an active
speaker, amplifier, mixer, audio interface, etc. or to the AES3 inputs of a
digital audio device. Different devices can be used at the same time.
Item No.: PAOCBXLRM
General
Product type: Adapters
Type: Audio over Cat adapter
No. of channels: 4
Total inputs: 4
Input type: Balanced
Input connection: RJ45
Total outputs: 4
Output type: Balanced
Output connection: XLR male
Number of link outputs: 4 (via RJ45 THRU)
Ground/lift switch: yes (for RJ45 THRU)
Housing material: Aluminium and steel
Dimensions (W×D×H): 128 × 140 × 50 mm
Weight: 0.6 kg
Ambient temperature: - 20...70° C
Humidity: <80 % (non-condensing)
Audio
Max. Input level: +32 dBu (< 1% THD, 1 kHz)
Frequency response: 0 Hz DC – 20 kHz
THD+N: < 0.0005 % (1 kHz, +4 dBu, unity, unweighted)
RJ45 pin assignment (AES72 type 5E, symmetrically wired, straight = +)
Pin 1 Ch 3 -
Pin 2 Ch 3 +
Pin 3 Ch 4 -
Pin 4 Ch 1 +
Pin 5 Ch 1 -
Pin 6 Ch 4 +
Pin 7 Ch 2 -
Pin 8 Ch 2 +
SPECIFICATIONS
INTENDED USE
This product is a device for event technology, as well as studio, TV and broadcast!
This product has been developed for professional use in the field of event technology,
studio, TV and broadcast. It is not suitable for household use!
Furthermore, this product is only intended for qualified users with specialist knowledge of
event technology, as well as studio, TV and broadcast!
Use of the product outside the specified technical data and operating conditions is
considered improper use!
Liability for damage and third-party damage to persons and property due to inappropriate
use is excluded!
The product is not suitable for:
- Persons (including children) with limited physical, sensory or mental abilities or lack of
experience and knowledge.
- Children (children must be instructed not to play with the product).
SAFETY INSTRUCTIONS
1. Please read this manual carefully.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Use the device in the prescribed manner only.
5. Do not open the device and do not perform any modifications.
CHOKING HAZARD! KEEP OUT OF THE REACH OF CHILDREN! THE PRODUCT CONTAINS
SMALL PARTS THAT CAN BE SWALLOWED AS WELL AS PACKAGING MATERIAL THAT CAN BE
SWALLOWED! PLASTIC BAGS MUST BE KEPT OUT OF THE REACH OF CHILDREN!
MANUFACTURER’S WARRANTY & LIMITATION OF LIABILITY
Our current warranty conditions and limitation of liability can be found at:
www.adamhall.com/media/shop/downloads/documents/manufacturersdeclarations.pdf
If service is required, please contact Adam Hall GmbH, Daimlerstraße 9, 61267 Neu
Anspach / E-mail Info@adamhall.com / +49 (0)6081 / 9419-0
CORRECT DISPOSAL OF THIS PRODUCT
(Valid in the European Union and other European countries which mandate waste
separation) This symbol on the product or associated documents indicates that to
prevent environmental damage and personal injury through uncontrolled waste
disposal, the product must not be disposed of with normal household waste at the
end of its service life. Please dispose of this product separately from other waste and
recycle it to promote sustainable commercial activity. As a private customer, you can
obtain information on environmentally-friendly disposal options from the vendor of the
product or the appropriate regional authorities. As a commercial user, please contact
your supplier and check for any contractually agreed conditions on disposing of the
equipment. This product must not be disposed of with other commercial waste.
PLEASE NOTE:
The shielding of the breakout cable is connected to the shielding of the Cat cable
via the Cat plug and Cat socket.
CE CONFORMITY
Adam Hall GmbH hereby confirms that this product meets the following
guidelines (where applicable):
Low-Voltage Directive (2014/35/EU)
EMC Directive (2014/30/EU)
RoHS (2011/65/EU)
RED (2014/53/EU)
For use in dry indoor areas.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation
UKCA- Conformity
Hereby, Adam Hall Ltd. declares that this product meets the following
guidelines (where applicable) Electrical Equipment (Safety) Regulations
2016 Electromagnetic Compatibility Regulations 2016 (SI 2016/1091).
The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulation 2012 (SI 2012/3032) Radio Equipment Regulations 201 7(SI 2016/2015)
Adam Hall Ltd. | The Seedbed Bus. Centre | SS3 9QY Essex | UK
UKCA- Declaration of Conformity
Products that are subject to Electrical Equipment(Safety)Regulation 2016, EMC
Regulation 2016 or RoHS Regulation can be requested at info@adamhall.com.
Products that are subject to the Radio Equipments Regulations 2017 (SI2017/1206) can
be downloaded from www.adamhall.com/compliance/
SUBJECT TO MISPRINTS AND ERRORS, AS WELL AS TECHNICAL OR OTHER
MODIFICATIONS!


Produkt Specifikationer

Mærke: Palmer
Kategori: Ikke kategoriseret
Model: AoC Box XLRm

Har du brug for hjælp?

Hvis du har brug for hjælp til Palmer AoC Box XLRm stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Palmer Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Samsung

Samsung RCD-S70 Manual

17 September 2024
Taco Tuesday

Taco Tuesday TTTB1RD Manual

17 September 2024
Zephyr

Zephyr MWD3001AS Manual

16 September 2024
Nabo

Nabo DAB Easy Manual

16 September 2024
Roku

Roku Streaming Stick Manual

16 September 2024
GPO

GPO Vinyl Record Case Manual

16 September 2024