Panasonic NI-313 Manual

Panasonic Jern NI-313

Læs nedenfor 📖 manual på dansk for Panasonic NI-313 (1 sider) i kategorien Jern. Denne guide var nyttig for 3 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Operating Instructions
ELECTRIC IRON
SPECIFICATIONS
Rated Input
Rated Voltage
Country of Origin
1,000W
220V ~
Malaysia
Before operating this iron, please read these instructions completely.
NI-313E/313EW/313EWT
Printed in Malaysia H0708N1
i8200G-oN02B
Approximately
Approximately
Approximately
Approximately
Approximately
Approximately
Selector Level Setting Soleplate Temperature ºC
1
2
3
4
5
6
85
112
140
165
185
200
Panasonic Corporation
Website: http://panasonic.co.jp/appliance/global/products
IMPORTANT SAFETY PRECAUTIONS
1. When leaving the room even for a short time, disconnect the power plug.
Keep children away.
2. Do not leave the iron unattended while it is connected to the mains.
3. Don't use the iron with the cord in tangled condition. The supply cord might be
damaged soon.
4. If the supply cord is damaged, it must be replaced by our service agent or a
similarly qualified person in order to avoid hazards.
5. The iron must be used and rested on a stable surface.
6. When placing the iron on its stand, ensure that the surface on which the stand is
placed is stable.
7. The iron is not to be used if it has been dropped, if there are visible signs of damage
or if it is leaking.
8. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
9. Children should be supervised to ensure that they do not play with the appliance.
HOW TO USE
1. Set fabric dial at the desired fabric marking.
2. Make sure the voltage indicated on the iron meets your local voltage.
Allow the iron to heat up for 2 minutes on heel rest before ironing.
3. The pilot lamp glows when the iron is switched on, and goes off when the iron
is heated up to the temperature selected by the fabric dial. The pilot lamp will
remain off as long as the iron keeps to the selected temperature and when
the temperature decreases, the thermostat will start working, and the lamp will
glow again. The thermostat makes the pilot lamp adjust automatically to the
varying temperature as being selected by the fabric guide.
4. First, iron chemical synthetic fabric at low temperature, and then as the
temperature rises, iron wool, cotton and linen accordingly. The iron heat up more
quickly than it cools.
5. Allow time for the iron to heat up when changing from low temperature to high.
Conversely, wait awhile when changing to a cooler setting.
PARTS IDENTIFICATION
1
2
3
4
5
6
Fabric dial
Handle
Soleplate
Cover shell
Pilot lamp
Cord


Produkt Specifikationer

Mærke: Panasonic
Kategori: Jern
Model: NI-313

Har du brug for hjælp?

Hvis du har brug for hjælp til Panasonic NI-313 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Jern Panasonic Manualer

Jern Manualer

Nyeste Jern Manualer