Ruckus Wireless ZoneFlex R310 Manual


Læs nedenfor 📖 manual på dansk for Ruckus Wireless ZoneFlex R310 (4 sider) i kategorien Adgangspunkt. Denne guide var nyttig for 16 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
Copyright © 2015 Ruckus Wireless, Inc. Page 1 of 4
Published 24 July 2015, Part Number 800-70972-001 Rev A
ZoneFlex R310 Access Point
Quick Setup Guide
This Quick Setup Guide provides step-by-step instructions on how to set up
your Ruckus Wireless ZoneFlex R310 access point. After completing the
steps in this guide, you will be able to place the access point at your site
and provide network access to wireless clients. The rest of this document
refers to the ZoneFlex R310 access point as an AP.
BEFORE YOU BEGIN
Before deploying your Ruckus Wireless device, please check the Ruckus
Wireless Web site for the latest software and release documentation.
Release Notes and User Documents are available at
http://support.ruckuswireless.com/documents
Software Upgrades are available at
http://support.ruckuswireless.com/software
Open Source information is available at
http://support.ruckuswireless.com/open_source
T HIS GUIDE IN O LTHER ANGUAGES
请从以下网站获得该指南的简体中文版
https://support.ruckuswireless.com
Vous trouverez la version française de ce guide à l'adresse suivante
https://support.ruckuswireless.com
日本語版 https://support.ruckuswireless.com
で ご
이 가이드의 한국어 버전은 웹 사이트
(https://support.ruckuswireless.com
) 에서 확인하시기 바랍니
Veja a versão em português (Brasil) deste guia em
https://support.ruckuswireless.com
Puede ver la versión en español (América Latina) de esta guía en
https://support.ruckuswireless.com
Figure 1. ZoneFlex R310 AP
PACKAGE CONTENTS
One ZoneFlex R310 access point
Two mounting screws and plastic wall anchors
One T8 5mm M2.5 Torx locking security screw
One unit removal pin
Regulatory flyer
Product warranty statement
Declaration of conformity, if required
Ruckus Wireless AP Getting Started Guide
This Quick Setup Guide
C ONFIGURING THE AP
Step 1: Collecting the AP MAC Address
Step 2: Collecting Setup Requirements, Hardware, and Tools
Step 3: Connecting Your Computer to the AP
Step 4: Preparing Your Computer for AP Setup
Step 5: Logging Into the AP Web Interface
Step 6: Customizing the Wireless Settings
Step 7: Placing the AP at the Site
Step 8: Verifying the Installation
Step 1: Collecting the AP MAC Address
Write down the MAC address (12 alphanumeric digits) from the
outside of the AP.
Step 2: Collecting Setup Requirements, Hardware,
and Tools
A computer with Ethernet adapter running Windows 7 or equivalent,
with Firefox or equivalent web browser.
One Cat 5e (or better) Ethernet cable.
T8 Torx screwdriver.
An AC-to-12VDC power adapter (sold separately)
--OR--
an 802.3af-compliant Power over Ethernet (PoE) switch or PoE
injector.
Step 3: Connecting Your Computer to the AP
AAfter removing the AP from its package, place it next to your
computer.
BUsing an Ethernet cable, connect your computer’s network port to the
POE IN port on the AP.
CConnect the AC power adapter (sold separately) to the 12VDC AP
port, and plug the AC power adapter into a convenient and protected
AC power source.
Alternatively, connect the POE IN port to a PoE injector or PoE switch
for both power and network connectivity.
Figure 2. AP rear panel
DAfter bootup, verify that the PWR LED on the AP is a steady green.
Step 4: Preparing Your Computer for AP Setup
AOn your Windows 7 computer, configure your network adapter from
the Local Area Connection settings as follows:
Start > Control Panel > Network and Sharing
Center > Change Adapter Settings
Note:
The minimum software revision for the AP is base image 100.x or
later, SmartZone 3.2 or later, or ZoneFlex 10.0 or later.
The rest of this document collectively refers to the SCG SZ, vSZ, ZD,
and other controllers as Ruckus Wireless controllers.
Important!
If the AP is to be managed by a Ruckus Wireless controller, then
follow the controller user documents to connect the AP to your local
network and configure it for initial operation. In that case, you may not
need to complete the following steps.
Note:
The following procedures assume that Windows 7 is the operating
system. Procedures for other operating systems are similar.


Produkt Specifikationer

Mærke: Ruckus Wireless
Kategori: Adgangspunkt
Model: ZoneFlex R310

Har du brug for hjælp?

Hvis du har brug for hjælp til Ruckus Wireless ZoneFlex R310 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Adgangspunkt Ruckus Wireless Manualer

Adgangspunkt Manualer

Nyeste Adgangspunkt Manualer

EQ-3

EQ-3 HMIP-HAP Manual

16 December 2024
Vimar

Vimar 20195.N Manual

15 December 2024
Vimar

Vimar 19195.M Manual

15 December 2024
Vimar

Vimar 20195 Manual

15 December 2024
Vimar

Vimar 19195 Manual

15 December 2024
Vimar

Vimar 14195 Manual

15 December 2024
Vimar

Vimar 14195.SL Manual

15 December 2024
Vimar

Vimar 20195.B Manual

15 December 2024
Vimar

Vimar 19195.B Manual

15 December 2024