Silva Cross Trail 3X Manual

Silva lampe Cross Trail 3X

Læs nedenfor 📖 manual på dansk for Silva Cross Trail 3X (1 sider) i kategorien lampe. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Visit: www.silva.se
for more information about the
Waste Electrical and Electronic
Equipment (WEEE) Directive.
Thank you for choosing Silva Cross Trail 3X headlamp. This headlamp can, thanks to the
modular design, also be used on a helmet or on a bike handle bar.
Cross Trail 3 and 3X are our first lamps featuring Flow light
® - a technology that lets you
control the light beam by tilting the lamp vertically and varies the light pattern infinitely
depending on where you aim the light. Thus the lamp is adaptable for slow or fast activities.
PRODUCT OVERVIEW
The Cross Trail 3X headlamp packaging consists of the following parts:
Headlamp body
Headband
Helmet bracket with adhesive strip
Bike bracket
Extension cable with helmet strap
Cable holder
USB charge cable
Li-Po battery in rubber skin
Battery case with attachment strap
Quick guide
BEFORE USE
BATTERY CHARGING
The battery needs to be charged before first use.
1. Disconnect headlamp from Battery
2. Open the rubber lid on the battery pack side and insert the micro USB connector on charge
cable.
3. Insert the USB connector in a USB-port
4. On the battery there is an LED showing the battery status during charging:
- Red light = battery is charging
- Green light = battery is fully charged
Battery charging time is approximately 4 hours.
Note! When the battery is fully charged the battery automatically switches off charging. How-
ever, never leave the battery connected to a USB-port unattended for longer periods.
ADJUST THE HEADBAND
The elastic headband is designed to give a comfortable fit at speed during activities such as run-
ning, XC skiing etc. Adjust the headband by moving the sliding buckle to fit it onto your head.
FLEXIBLE BATTERY CARRYING
The battery pack can be carried in multiple ways; for example on the head band, in a pocket,
backpack, on the waist or mounted on the bike frame by using the soft case with the integrated
strap.
MODULAR SYSTEM
In order to move the headlamp body from the headband to either the helmet bracket or the bike
bracket, gently push the lamp upward relative the head plate with head band. Insert the head-
lamp body in the new bracket and gently press it down until you hear a click sound.
MOUNTING THE HELMET BRACKET
The helmet bracket comes with pre mounted adhesive on the back for easy mounting on any
helmet. The adhesive is a polyethylene foam tape developed to not damage or cause any type of
weakness to the plastic in your helmet.
Before mounting the helmet bracket on a helmet, make sure the surface is dry and clean. Remove
the protective paper from the adhesive tape on the helmet bracket. Gently press the helmet
bracket to the helmet.
Depending on helmet type, it might be preferable to use the 4th light mode (Helmet mode – Flow
light deactivated), when the Cross Trail 3X is used on a helmet.
With Flow light deactivated you can tilt the lamp in a preferable position without affecting the light
beam.
MOUNTING THE BIKE BRACKET
The bike handlebar bracket is developed for use on bike handlebars with a dimension between
25 and 32 mm.
DURING USE
FLOW LIGHT®
The Cross Trail 3X headlamp is equipped with Flow Light
® which is a light distribution technolo-
gy that combines a wide angle flood light with a long reach spot light. If you aim the light beam of
the Cross trail 3X close to your feet by rotating the lamp body downward, the light beam will be
a wide flood light adapted for slower activities. If you aim the light higher up, further away, the
light beam will gradually transform into a long distance spot beam, perfect for higher speed.
This unique feature gives the user peripheral or long distance vision depending on the activity or
speed. For a runner, cross country skier, mountain biker or night orienteer this translates into
less head movement, increased control, better balance and more speed.
SWITCH ON YOUR HEADLAMP
On the side of the headlamp body there is a push button which controls all light modes.
Each press on the button gives you the following light:
1. Turns the headlamp ON with all LEDs in maximum power
2. Med mode
3. Min mode
4. Max mode with Flow light deactivated (helmet mode)
5. Blink
6. Starts over from 1 – Max mode
To turn OFF the headlamp; press and hold the button for 2 seconds.
TEMP CONTROL
The headlamp temperature will increase during use. The headlamp temperature is mainly
depending on light mode, ambient temperature and the airflow (speed). The Cross Trail 3X
headlamp is equipped with a temperature control function which prevents the headlamp body
from overheating by reducing the power to the LEDs. This means that the lower the ambient
temperature, the stronger the light output.
Note: Always make sure that the batteries are disconnected when the headlamp is stored in a
closed compartment such as a bag, pocket or similar.
BATTERY INDICATION
When the headlamp is turned off a small LED is turned on inside the front of the headlamp to
indicate the status of the batteries. The battery status indication LED will be on for 5 seconds
after power off.
Green light – Battery in good condition (more than ~70% remaining)
Red – Battery in poor condition (less than ~30% remaining)
LOW BATTERY WARNING
During operation of the headlamp there will be a low battery warning when 25-30% of the bat-
tery energy remains. This is done by flashing both LEDs for 1 second and repeated again after
5 seconds.
AFTER USE
MAINTENANCE
To make sure you get maximum performance from your Cross Trail 3X headlamp, clean it
regularly with a damp cloth.
Headset cleaning – wash in washing machine at 40 ºC.
ABOUT LI-ION (LI-PO) BATTERIES
The battery should be stored in a dry environment within the temperature range of -20 ºC -
+35 °C.
If you would like to store your battery for a longer period (more than 30 days) the battery
should 50%charged.
Li-ion batteries have a discharge rate of approx. 20% over a 30 day period.
Do not expose the battery for extreme temperatures which may cause fire or explosion.
Do not disassemble or mistreat the battery, risk for chemical burn.
Keep away from children.
Do not submerge the batteries in water.
Do not short circuit the contacts.
Replace only with Silva battery.
Note! Always make sure to disconnect the battery when the headlamp is not used.
TECHNICAL SPECIFICATIONS
Weight: headlamp (excluding battery): 70g
Weight: battery 75g
Battery type: Li-ion 7.4V 900mAh
Light distance (Max/Med/Min): 120m/70m/50m
Lumen (Max, Med, Min): 400, 200, 100 Lumen
Burn time: (Max/Med/Min): 2h/4h/6h
Water resistance: IPX6
Material head lamp body: PC/ABS and Aluminium
Operative temperature range: -10º - +55 ºC
Storage temperature range: -20 - +35 ºC
Art No: 37537
PROTECT THE ENVIRONMENT.
Headlamp and batteries should be recycled and must not be thrown in the regular trash. Dispose
these items in accordance with applicable local regulations.
WARRANTY
Silva warrants that, for a period of two (2) years, your Silva Product will be substantially free of
defects in materials and workmanship under normal use. Silva’s liability under this warranty is
limited to repairing or replacing the product. This limited warranty extends only to the original
purchaser.
If the Product proves defective during the Warranty Period please contact the original place
of purchase. Make sure to have your proof of purchase on hand when returning the product.
Returns cannot be processed without the original proof of purchase. This warranty does not
apply if the Product has been altered, not been installed, operated, repaired, or maintained in
accordance with instructions supplied by Silva, or has been subjected to abnormal physical or
electrical stress, misuse, negligence or accident. Neither does the warranty cover normal wear
and tear. Silva is not responsible for any consequences, direct or indirect, or damage resultant
from use of this product. In no event will Silva’s liability exceed the amount paid by you for the
product. Some jurisdictions do not allow the exclusion or limitation of incidental or consequen-
tial damages, so the above limitation or exclusion may not apply to you. This Warranty is valid
and may be processed only in the country of purchase.
For more information please visit www.silva.se
FULL VERSION MANUAL
CROSS TRAIL 3X Art. No 37537


Produkt Specifikationer

Mærke: Silva
Kategori: lampe
Model: Cross Trail 3X

Har du brug for hjælp?

Hvis du har brug for hjælp til Silva Cross Trail 3X stil et spørgsmål nedenfor, og andre brugere vil svare dig




lampe Silva Manualer

lampe Manualer

Nyeste lampe Manualer

Eurolite

Eurolite LED TMH-S200 Manual

16 December 2024
Ledlenser

Ledlenser H5 Core Manual

16 December 2024
Ledlenser

Ledlenser NEO-4 Manual

16 December 2024
Ledlenser

Ledlenser SEO 3 Manual

16 December 2024
Ledlenser

Ledlenser H4R Manual

16 December 2024
Ledlenser

Ledlenser H7R Core Manual

16 December 2024
Ledlenser

Ledlenser H7R Work Manual

16 December 2024
Ledlenser

Ledlenser MH5 Manual

16 December 2024