Standard Horizon BU-1 Bluetooth Adapter Unit Manual

Standard Horizon Marine BU-1 Bluetooth Adapter Unit

Læs nedenfor 📖 manual på dansk for Standard Horizon BU-1 Bluetooth Adapter Unit (2 sider) i kategorien Marine. Denne guide var nyttig for 4 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Installation
1. Remove the six screws and the washer se-
curing the Front Panel and then carefully
separate the Front Panel from the Rear case.
Connector
BU-1 Bluetooth® Adapter Unit
Please be sure to follow these safety precautions.
Turn the transceiver power off, and disconnect all cables from the transceiver.
Touch a metal place to discharge any static electricity from your body.
Double-side tape
If you use the GX5500S, disconnect the
wire from the Printed Circuit Board in the
Front Panel.
2. Locate the connector for the BU-1.
Peel the covering of the double-side tape on
the Printed Circuit Board.
3. Carefully align the connector on the BU-1
with the connector on the Printed Circuit
Board, and gently press the BU-1 into place.
4. Replace the Rear Case, using the screws and
washer removed in the first step.
Note: If you used the GX5500S, Attach the
Wire to the connector on the Printed
Circuit Board in the Front Panel.
Be certain the Rubber packing on the Rear
case is correctly installed, and the rear
case adheres and seals properly.
5. Installation is now complete.
BU-1
Wire


Produkt Specifikationer

Mærke: Standard Horizon
Kategori: Marine
Model: BU-1 Bluetooth Adapter Unit

Har du brug for hjælp?

Hvis du har brug for hjælp til Standard Horizon BU-1 Bluetooth Adapter Unit stil et spørgsmål nedenfor, og andre brugere vil svare dig




Marine Standard Horizon Manualer

Marine Manualer

Nyeste Marine Manualer