Sun Joe 24V-WB1000 Manual


Læs nedenfor 📖 manual på dansk for Sun Joe 24V-WB1000 (68 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 30 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/68
Original instructions.
© 2022 Snow Joe, LLC. All rights reserved. SAVE THESE INSTRUCTIONS
1
A Division of Snow Joe, LLC Model 24V-WB1000 Form No. SJ-24V-WB1000-880E-M
R
OPERATOR’S MANUAL
24V MAX* CORDLESS
WHEELBARROW
LED HEADLIGHTS | FORWARD + REVERSE
ADJUSTABLE SPEEDS
EN
*Initial no-load voltage, when fully charged, peaks at 24 volts;
nominal voltage under typical load is 21.6 volts.
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Always follow these safety guidelines. Failure to follow all
instructions listed below may result in electric shock, re and/
or serious injury.
General Safety
Notice the personal safety alert symbol used in this manual m
to draw your attention to a WARNING given along with the
particular operating instruction. This means that the operation
requires special ATTENTION CAUTION AWARENESS, , and .
mWARNING! When using this wheelbarrow, basic safety
precautions, including the following, should always be followed
to reduce the risk of re, electric shock, personal injury and
material damage.
Work Area Safety
1. Keep work area clean and well-lit. Cluttered, dark areas
invite accidents.
2. Do not operate power tools in explosive atmospheres,
such as in the presence of ammable liquids, gases or
dust. Power tools create sparks which may ignite the dust
or fumes.
3. Know your product – Know how to start and stop the
machine. Be thoroughly familiar with the controls.
4. Keep children, bystanders, and pets away –
Distractions can cause you to lose control.
Electric Safety
1. Power tool plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
earthed (grounded) power tools. Unmodied plugs and
matching outlets will reduce risk of electric shock.
2. Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric shock
if your body is earthed or grounded.
3. Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
4. Do not abuse the cord. Never use the cord for carrying,
pulling or unplugging the power tool. Keep cord away
from heat, oil, sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric shock.
5. When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
6. If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
Personal Safety
1.
Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use a power
tool while you are tired or under the inuence of drugs,
alcohol or medication. A moment of inattention while
operating power tools may result in serious personal injury.
2. Use personal protective equipment. Always wear eye
protection. Protective equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing protection used for
appropriate conditions will reduce personal injuries.
3. Prevent unintentional starting. Ensure the switch is in
the o-position before connecting to power source and/or
BATTERY pack, picking up or carrying the tool. Carrying
power tools with your nger on the switch or energising
power tools that have the switch on invites accidents.
4. Remove any adjusting key or wrench before turning
the power tool on. A wrench or a key left attached to
a rotating part of the power tool may result in personal
injury.
5. Do not overreach. Keep proper footing and balance at
all times. This enables better control of the power tool in
unexpected situations.
6. Dress properly. Do not wear loose clothing or jewelry.
Keep your hair, clothing and gloves away from moving
parts. Loose clothes, jewelry or long hair can be caught in
moving parts.
7. If devices are provided for the connection of dust
extraction and collection facilities, ensure these are
connected and properly used. Use of dust collection can
reduce dust-related hazards.
8. Do not let familiarity gained from frequent use of tools
allow you to become complacent and ignore tool safety
principles. A careless action can cause severe injury within a
fraction of a second.


Produkt Specifikationer

Mærke: Sun Joe
Kategori: Ikke kategoriseret
Model: 24V-WB1000

Har du brug for hjælp?

Hvis du har brug for hjælp til Sun Joe 24V-WB1000 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Sun Joe Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

MSW

MSW -RF15S Manual

25 December 2024
MSW

MSW -HFCV-A7 Manual

25 December 2024
MSW

MSW -HFCV-A5 Manual

25 December 2024
MSW

MSW -LRL2T-1 Manual

25 December 2024
MSW

MSW -HFCV-A6 Manual

25 December 2024
Philips

Philips SWF2620 Manual

25 December 2024
Philips

Philips 13BDL4150IW Manual

25 December 2024
Vivax

Vivax TS-950B Vintage Manual

24 December 2024